OX03C10 2.

5MP product brief

Image Sensor for Automotive Viewing Cameras with

lead free
140 dB HDR and Top LED Flicker Mitigation Performance
available in
a lead-free
OmniVision’s OX03C10 is a 2.5 Megapixel (MP), ASIL-C image flexibility and faster camera-view switching for drivers.
package sensor. It provides automotive viewing applications with the Additionally, it has the lowest power consumption of any LFM
combination of a large 3.0 micron pixel size, a high dynamic range image sensor with 2.5MP resolution, along with the industry’s
(HDR) of 140 dB and the best LED flicker mitigation (LFM) smallest package size, enabling the placement of cameras that
performance for minimized motion artifacts. Additionally, the continuously run at 60 fps in even the tightest spaces for
integration of OmniVision’s industry-leading HALE (HDR and stringent styling requirements.
LFM engine) combination algorithm uniquely provides top HDR
and LFM performance simultaneously. These industry-leading The sensor uses OmniVision’s Deep Well™, dual conversion gain
features enable the best image quality for automotive viewing (DCG) technology to provide significantly lower motion artifacts.
applications, including rearview cameras (RVC), surround view Additionally, split-pixel LFM technology with four captures
systems (SVS), camera monitoring systems (CMS) and e-mirrors. provides the best performance over the entire automotive
temperature range.
Built on OmniVision’s PureCel®Plus stacked die technology, this
sensor enables pixel performance advantages over non-stacked The OX03C10 features 4-lane MIPI CSI-2 and 12-bit DVP
technology. 3D stacking boosts pixel and dark current interfaces and is available in both a-CSP™ and a-BGA™ packages.
performance, resulting in a 20% improvement in the
signal-to-noise ratio over the prior generation of its 2.5MP Find out more at www.ovt.com.
viewing sensors.

The OX03C10 is also the first viewing image sensor with HDR
and LFM that can deliver 1920 x 1280p resolution at the highest
rate of 60 frames per second (fps), enabling greater design
Applications OX03C10
¬ Automotive
- Surround View System - Autonomous Driving
- Rear View Camera - E-Mirror

Ordering Information
Product Features ¬ OX03C10-B83Y-001A-Z
(color, lead-free) 83-pin a-BGA™ packed in tray without protective film

¬ support for image size: ¬ image signal processor functions:

1920 x 1280 and any cropped size - lens shading correction
- defective pixel cancellation
¬ PureCel®Plus-S technology - HDR combination

¬ HDR readout modes, with up to 4x

- automatic black level correction
- PWL compression, etc.
Technical Specifications
captures and on-chip combination:
- on-chip line buffers ¬ safety features for supporting ¬ active array size: 1920 x 1280 ¬ output interfaces:
(alignment with staggered readout) ASIL C applications up to 4-lane MIPI CSI-2, 12-bit DVP
- DCG (LPD) + SPD + staggered (VS) ¬ maximum image transfer rate:
- DCG (LPD) + staggered (VS) ¬ parallel 12-bit DVP output - 1280p: 60 fps ¬ lens size: 1/2.6"
- LFM support (SPD)
- PWL mapping from 24-bit ¬ external frame synchronization ¬ power supply: ¬ lens chief ray angle: 20°
to 20, 16, 14, and 12-bit capability - analog: 2.9V
- digital: 1.1V ¬ output formats: uncompressed 24-bit,
¬ motion free HDR (3 capture), ¬ embedded temperature sensor - I/O pads: 1.8V/3.3V 20/16/14/12-bit (PWL) combined
4 capture HDR optimized to HDR (4 captures)
minimize motion artifacts ¬ embedded supply voltage monitor ¬ power requirements:
- active: streaming @ 1280p60: ¬ pixel size: 3 µm x 3 µm
¬ SCCB for register programming ¬ one-time programmable (OTP) memory 390 mW (HDR4 combined 24b),
streaming @ 1280p30: 290 mW ¬ image area: 5814 µm x 3894 µm
¬ high speed serial data transfer (HDR4 combined 24b)
with MIPI CSI-2
¬ temperature range:
- operating: -40°C to +105°C sensor
ambient temperature and -40°C to
+125°C junction temperature

Functional Block Diagram

OX03C10
image sensor core image signal output
processing interface
temperature
row select

sensor
image
array temperature
sensor HDR combine,
WB gain, DVP
column BLC, pre-CCM (SPD),
FIFO
PWL

MIPI

ADCs DigGain LENC (SPD),

DPC (OTP+Dyn), MIPI
window
analog gain
control

timing generator and voltage SCCB

PLL1 PLL2 OTP
system control logic monitor interface
2.9V
1.8V/3.3V
1.1V
XVCLK

FSIN

RESETB

TM

GPIO[3:0]

VSYNC

ERRB

VM_ERRB

SID
SCL
SDA

OmniVision reserves the right to make changes to their products or to discontinue any product or
4275 Burton Drive Tel: + 1 408 567 3000 service without further notice. OmniVision, the OmniVision logo, and PureCel are registered
Santa Clara, CA 95054 Fax: + 1 408 567 3001 trademarks of OmniVision Technologies, Inc. Deep Well, a-CSP, and a-BGA are trademarks of
OmniVision Technologies, Inc. All other trademarks used herein are the property of their
USA www.ovt.com respective owners.

Version 1.2, May 2021