Scribd
Upload
39 views2 pages

WPS New 1

This document is a pre-qualified welding procedure specification from Jalmood National for welding using the shielded metal arc welding (SMAW) process. It specifies the materials, welding consumables, welding positions, and parameters to be used for structural welds on projects for CCED. The base metal is S 275 JR steel up to 24mm thick. Welding will be performed manually with E6010 electrodes from Orange in the 2G uphill position.

Uploaded by

Erica Sanders
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
39 views2 pages

WPS New 1

This document is a pre-qualified welding procedure specification from Jalmood National for welding using the shielded metal arc welding (SMAW) process. It specifies the materials, welding consumables, welding positions, and parameters to be used for structural welds on projects for CCED. The base metal is S 275 JR steel up to 24mm thick. Welding will be performed manually with E6010 electrodes from Orange in the 2G uphill position.

Uploaded by

Erica Sanders
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

JALMOOD NATIONAL

P.O. BOX: 1120, P.C: 133, AL KHUWAIR, SULTANATE OF OMAN

PRE-QUALIFIED WELDING PROCEDURE SPECIFICATION


(AWS D1.1/D1.1M)

CLIENT CCED CONTRACT NO. PA-000719 Page 1 of 2

CONTRACTOR Jalmood National CONTRACT TITLE Provision of Civil and Earthworks Construction Services

PQWP NO. JN-PQWP-01 PROJECT LOCATION Block 3 & 4. OMAN (CCED)

REV. NO. 1

DATE 06.11.2023

PQR NO. -

REV. NO. -

DATE -

TEST CODE AWS D1.1

SPECIFICATION N/A

PROCESS SMAW

TYPE Manual

MDMT 5o C

SERVICE Sour and Non Sour

Material Specification & Grade Base Metal Heat Treatment Condition Qualified Position

S 275 JR N/A 2G Uphill

Max. Carbon Equivalent Qualified Thickness Range Group No.

0.35 (Max) 3mm - 24mm N/A

CONSUMABLE DETAILS TRAVEL


CURRENT & AMPS RANGE VOLTS HEAT INPUT
PASS NO. PROCESS SPEED
POLARITY (A) RANGE (V) (KJ/MM)
MANUFACTURER AWS CLASS DIA (MM) SFA GROUP NO. (MM/MIN)

ROOT PASS SMAW ORANGE E6010 3.2

HOT PASS SMAW ORANGE E6010 3.2

FILL PASS SMAW ORANGE E6010 3.2

CAPPING SMAW ORANGE E6010 3.2

Notes: QUALIFIED WELD DEPOSIT THICKNESS


Welding is only performed when weather and Protection provide
PROCESS
satisfactory weld
This PQWP is applicable for all structural welds SMAW
Stray arc shall be avoided. Arc strikes, if any, shall be ground smooth and the
grounded area shall be MP tested.
GAS
Temperature indicating crayons shall be free from lead and sulphur (less
PURPOSE GAS % COMP FLOW RATE (LPM) % OXYGEN
than 1ppm) or any other low melting point constituent
The nos. of passes are shown as per PQR. SHIELDING

TRAILING

BACKING
25

You might also like