Pre-Test Exam

Mock Written Exam
Trainor: Nelson B. Galang

Qualification: HEO Wheel Loader NCII
1. In checking the engine lubricating oil using dipstick, the 2. The first characteristic of a backhoe loAder operator must
operator MUST observe the have is
A. Presence of oil inside the engine for safe starting A. skill

B. Brand and color B.knowledge
C. Condition and viscosity C.attitude
D. Level, color and condition of oil D.none
3. When loading the bucket , the front frame SHOULD always 4. Which one is not a part of PPE for Wheel loader operator
Be aligned with the rear frame to avoid damage to
A. bucket A. gloves
B. boom C. Safety shoes
D. Center pin B. Safety hat
E. cylinder C. Reflectorize vest
5. Before operating near a cliff, the operator MUST test the 6. Which heavy equipment doesn’t have a tire
flooring by?
A. running the backhoe loader through it A. Wheel loader

B. Pushing some load down the cliff B. Road Roller
C. Going down from the machine and inspecting condition of C. hydraulic excavator
the soil
D. Pouring water in it E. backhoe loader
7. Which one is a MUST for the operator before raising the 8. What does PSI means
stabilizer when operating on a slope position
A. Lower the implement A. Pile per square inch

B. Install the swing lock pin B. Pinch per square index
C. Engage the parking brake C. Pinch per square idle
D. Make a signal D.none of the above
9. When applying multiple loading using four wheel loaders,10.
theWhere are we going to pump air in air filter when cleaning
operator with the least skill SHOULD be placed at the
A. 4th A. outside
B. 2nd C. inside
D. 3rd B. side by side
E. never C. just replace it
11. The maximum distance that a Wheel Loader can move the 12. Which instrument is needed to fillup grease lube point
load efficiently is
A. 2000 meters A.fittings

B. 1000 B.finger
C. 150 C.tubegreaser
D. 50 D.grease gun
13. The engine is idled for 5 minutes after starting to 14. Which one needs to come do first
A. Filter oil impurifies A. Heat up the engine in heater mode

B. Increase the viscosity of the lubricating oil B.walk around check
C. Make the passed by valve of the filter operates C.test the boom arm and bucket is moving
D. Allow oil to attain correct operating temperature D.check your surroundings
15. In checking belt tension, the usual belt sag is 16. Which one does not belong to the group
A. 5mm A. starting
B. 10mm B. Charging
C. 7mm C.lighting
D. 6mm D.swinging
17. When loading earth materials to the dumptruck, the
Maximum swing angle allowed for efficient operation is
18. What does this mean

A.30 degrees A.boom up
B.60 degrees B.swing left
C.90 degrees C.arm out
D. 120 degrees D.bucket out
19. For Philippine condition, the preferred oil viscosity for
engine lubrication is

A. SAE 10 A.boom up
B.SAE20 B.swing left
C.SAE40 C.arm out
D.SAE90 D.bucket out
21. The maximum angle of a wheel loader during v
shaped loading of material is
22What does this mean.

A.40 degrees A.boom up
B.45 degrees B.swing left
C.50 degrees C.arm out
D.60 degrees D.bucket out
23. What is the equivalent of 12 feet in inches

A. 144 A.boom up
B. 168 B.swing left
C. 24 C.arm out
D.10 D.bucket out
25. Filling up the tank after a day’s work is DONE primarily to

A.prevent accumulation of dirt A. Move forward
B.always have a reserve fuel B.distance left to back
C.prepare the equipment for next day’s work C. Slow down
D.lessen the airspace to prevent condensation D.stop
27. The volume of the box if the given is:
Length:9
Width:8
Height: 8
A.578 A. Move forward
B.576 B.distance left to back
C.577 C. Slow down
D.575 D.stop
29. What is the result of unusual tire wear

A. Too many stopping A. Back up
B.over speeding of unit B.distance left to back
C.over inflation/under inflation C. Slow down
D.overloading of equipment D.stop
31. When climbing the unit how many contact we are doing
A. 4 A. Back up
B. 2 B.distance left to back
C. 3 C. Slow down
D. 5 D.stop
33. What FIRST step is required in replacing fuel filter 34. The most probable cause of hard starting engine is
A. Make sure the tank is full A.under filled radiator

B. Clean the immediate area around the filter B.defective alternator
C.make sure the engine is not running C.low lube oil
D.Loosen the fasteners D.none of the above
35. If 4.4 lbs is equal to 2 kg. How many lbs are there in 20? 36. The quotient of 72 when divided by 9 is equal to
A.20 A.6
B.44 B.7
C.24 C.3
D.62 D.8
37. Adding 1.29391+1.90+1.342102+1.4523+10.6 is equal to 38. Which of the following components circulates engine oil
A.16.598412 A.fuel pump

B.16.588312 B.transmission pump
C.16.576312 C.hydraulic pump
D.16.539132 D.lubricating pump
39. Two basic requirements to make an engine run are 40. power Is transmitted from engine to transmission by the
A.oil and water A.none of the below

B.fuel and oil B.torqueachiever
C.fuel and air C.clutches
D.electricity and air D.hydrostatic drive

Pre-Test Exam

Uploaded by

Copyright:

Available Formats

Pre-Test Exam

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Pre-Test Exam

Uploaded by

Copyright:

Available Formats

Mock Written Exam

Trainor: Nelson B. Galang

A. Presence of oil inside the engine for safe starting A. skill

A. running the backhoe loader through it A. Wheel loader

A. Lower the implement A. Pile per square inch

A. 2000 meters A.fittings

A. Filter oil impurifies A. Heat up the engine in heater mode

18. What does this mean

20. What does this mean

22What does this mean.

24. What does this mean

26. What does this mean

30. What does this mean

32. What does this mean

A. Make sure the tank is full A.under filled radiator

A.16.598412 A.fuel pump

A.oil and water A.none of the below

You might also like