Scribd
Upload
1K views1 page

Exercises Programming CNC Milling

The document provides instructions to create a CNC milling program using absolute programming (G90) to machine a profile starting from point P1 (X48, Y15) using an 8mm endmill to a depth of 10mm.

Uploaded by

marlina bie
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

Exercises Programming CNC Milling

The document provides instructions to create a CNC milling program using absolute programming (G90) to machine a profile starting from point P1 (X48, Y15) using an 8mm endmill to a depth of 10mm.

Uploaded by

marlina bie
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

EXERCISES PROGRAMMING CNC MILLING

1. Refer to the Figure 1 and given data below, create a program for CNC machining milling by
using absolute programming (G90). Machining process should be following the sequence from P1
(X48, Y15).
Given data:
i) Tool T1 (Endmill diameter 8mm)
ii) Machining depth for profile = 10mm

You might also like