0% found this document useful (0 votes)
34 views

Tutorial Assembly Exploded View

This document provides instructions for creating an exploded view in OnShape. It outlines the following steps: 1. Create a new drawing from an assembly file and set the sheet size. 2. Demonstrate how to add an exploded view by selecting parts, moving them to defined distances or angles, and accepting their placements. 3. For the assembly, an exploded front view was created by selecting parts, renaming explode steps, dragging parts to distances, and accepting their placements until the assembly was fully exploded.

Uploaded by

Marwin Belmonte
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
34 views

Tutorial Assembly Exploded View

This document provides instructions for creating an exploded view in OnShape. It outlines the following steps: 1. Create a new drawing from an assembly file and set the sheet size. 2. Demonstrate how to add an exploded view by selecting parts, moving them to defined distances or angles, and accepting their placements. 3. For the assembly, an exploded front view was created by selecting parts, renaming explode steps, dragging parts to distances, and accepting their placements until the assembly was fully exploded.

Uploaded by

Marwin Belmonte
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

OnShape: Assembly Exploded View

By: Matthew Jourden


Brighton High School
Brighton, MI
1. Navigate to onshape.com > Open Assembly Tutorial > Select + sign in the bottom left corner > Select New Drawing >
Rename Cover Page > Sheet Size: ANSI_C_ INCH
Document Tabs should look as follows

2. Demo Exploded View: Note the following Steps i-v are demo. Actual Explode View is on Step 3
a. Navigate to OnShape Help Desk Assembly Creating Exploded Views (Hold CTRL (Control) Key + Left Click on Link
to open from pdf)
i. Select Assembly Tab > Select Explode Icon (Right Hand Side of the Screen)

BOM Chart Creation

Assembly Configuration

Explode View Icon

Add Exploded View


ii. Select Add Exploded View
iii. Demo Each Part will have its own Explode Step > Select Part to Move > Consider changing the name of
the Explode Step to the Part Name > Dragger will appear > Place cursor on the direction of movement or
enter a distance > Hold Left Mouse Button > Drag to desired Location > Green Check to Accept
Placement (Note: User can edit distance by double clicking on the Explode View Window on the Parts
Step)

Green Check to
Accept
Translation or
Rotational Option

Dragger: Place Cursor on


desired location > Hold
Left Mouse Button Down
> Drag to Desired Location

Dragged or User
Defined Distance:
User may type a
value here to a
specified distance
or angle

Consider Changing Explode Step


Name to the Part Name
iv. Demo Repeat Steps > Select Part > Rename > Drag or Set Distance > Green Check

Click Done When Done

Double Click on Part


to edit position

3. For this Assembly we will opt for a Front View Orthographic Assembly
a. Select Done next to Editing Explode 1 when complete
b. Explode View should look something like this (NOTE: I did not explode the Base pieces or Plug to keep the view
simple and to be able to see the parts)

Click Done When Done

I placed both Plugs in the Same


Explode Step so they would go the
same distance

You might also like