0% found this document useful (0 votes)
32 views1 page

سه

Uploaded by

rezakaihani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
0% found this document useful (0 votes)
32 views1 page

سه

Uploaded by

rezakaihani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 1
$:10Feot: potentiometer manually given voltage input +, Potentiometer manually given voltage input - Foot 11: Automatic Display Switch Input Foot 12:24, Foot 13: 24V GND 14.15 Foot: Empty calibration order, Empty calibration indication 16 foot: section selection 17-18 Foot: Full calibration order, Full calibration indication 20.21 Foot :4-20 mA Set level height signal 22.23 Foot :0-10 V Set level height signal Area 19. s: + 25 core standard double-row pins: 3.4,5 feet: Upper limit alarm :NO/ middle contact point / NC 7.8,9 feet: Lower limit alarm :NO/ middle contact point / NC 11.12,13 feet: MEU normal : NO/middle contact point /NC Area20. 220 V Power outlet Area 21, Instrument grounding or receiver); 1. Check MEU display information, data should be like follow: Ay The N value is big enough 8. VO value 4-8 Cy The V6 value is about v0.5-1 Note: Mean while, the sen: and radioactive source should be fixed tightly in the mold_and source contait should be_in_epen condition: Mould cooling water should be full of mould jacket, Not allow other metal stu inside of mould; 2. If the V6 value is not about 0.5-1 V and the N value is small, it is necessary to Sxecute the peak stabilization operation.:By Pressing "MOD" input "9999" and Press "1", the peak voltage can be adjusted automatically. (Prohibit in casting) ; 3. ifthe automatic V6 can not be adjusted, it i necessary to execute the manual peak stabilization operation,

You might also like