0% found this document useful (0 votes)
503 views10 pages

Networking Scenario Based Interview Questions - IP With Ease

This document discusses networking scenario based interview questions. It provides 5 example questions: 1. Which device will issue an ARP request in a newly powered up network diagram? 2. How many EIGRP neighborships will form between routers R1 and R2 that have primary and secondary IPs configured under the same AS? 3. Can PC1 ping PC2 if switch 1 has VLAN 10 as the native VLAN and switch 2 has VLAN 20 as the native VLAN? 4. Can a switch have more than one native VLAN configured over a trunk? 5. Will a diagram support HSRP/VRRP on two interfaces of a Cisco 1941 router?

Uploaded by

Cinema Hunger
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
503 views10 pages

Networking Scenario Based Interview Questions - IP With Ease

This document discusses networking scenario based interview questions. It provides 5 example questions: 1. Which device will issue an ARP request in a newly powered up network diagram? 2. How many EIGRP neighborships will form between routers R1 and R2 that have primary and secondary IPs configured under the same AS? 3. Can PC1 ping PC2 if switch 1 has VLAN 10 as the native VLAN and switch 2 has VLAN 20 as the native VLAN? 4. Can a switch have more than one native VLAN configured over a trunk? 5. Will a diagram support HSRP/VRRP on two interfaces of a Cisco 1941 router?

Uploaded by

Cinema Hunger
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 10

6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

HOME ABOUT US TERMS OF USE DISCLAIMER CONTACT US  LOGIN  CART   


Checkout : E-STORE for latest release "Palo Alto Firewall Interview Q&A " Dismiss

HOME BASICS WITH EASE DESIGN  CONFIGURE  TROUBLESHOOT  PRODUCT DATASHEETS 

FREE ZONE  E-STORE TRAINING 

NOW
5G TRENDING Default VPC vs Custom VPC in AWS
vs Fiber What is CDN – Content Delivery Network What is SDN

 Home BUZZ Networking Scenario Based Interview Questions


Search the site 

Networking Scenario Based Interview For Sponsored Posts and


Advertisements, kindly reach us at:
Questions [email protected]
Related:
Best IoT Software Jobs Hiring Near Me Top 20 In
Telephone Interview Tips Top Resume Formats Accelerat FIND US ON FACEBOOK
U SD

IPWITHEASE | April 28, 2019 | BUZZ, Discussion | No Comments


IN R
1. BEST IOT SOFTWARE a

2. TELEPHONE INTERVIEW TIPS a

3. JOBS HIRING NEAR ME a

4. TOP RESUME FORMATS a

5. TOP 20 INTERVIEW QUESTIONS a

CATEGORIES

Select Category

POPULAR RECENT

ANSWERS
HOW TO RESET
@https://ipwithease.com/shop/ THE CISCO
7821IP PHONE
1. In the below diagram, all the devices are recently powered up. Which TO THE FACTORY
device will issue ARP request? DEFAULT
November 10, 2016 

https://ipwithease.com/networking-scenario-based-interview-questions/ 1/10
6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

ENABLE /
DISABLE
INTERFACE IN
JUNIPER
March 23, 2017

DIFFERENCE
BETWEEN
UNDERLAY
NETWORK AND
OVERLAY NETWORK
August 1, 2017

2. In the given diagram, EIGRP neighborship is formed between R1 and R2


on Interface Gi0/0. Both the primary and secondary IPs are con gured COMPARISON OF
under EIGRP AS 1. How many Neighborship will be formed between R1 IGMPV1, IGMPV2
and R2? AND IGMPV3
October 13, 2016

ROUTE LEAKING
BETWEEN VRF
AND GLOBAL
ROUTING TABLE
April 5, 2014

3. In the given diagram, Switch 1 has Vlan 10 as native VLAN over trunk
while Switch 2 has VLAN 20 as native VLAN over trunk. Can PC1 ping PC2? NEXT »U SD

IN R

4. Can a Switch have more than one Native VLAN over Trunk?
5. Will the below diagram support HSRP/VRRP on interface Gi0/0 and Gi0/1
of Cisco 1941 Router?

TAGS

BGP Cisco Con guration

Cisco products Cloud

Comparison Con guration

DHCP EIGRP high availability

IP Packet IP Routing IPv6

IP Voice Juniper Con guration

Juniper Routing Juniper Security



LAN Technologies Layer 1

Load balancing
https://ipwithease.com/networking-scenario-based-interview-questions/ 2/10
6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

Monitoring and Management

MPLS multicast NAT

Network Design

Network device architecture

Network Services

New Technologies OSPF

Power protocol Proxy

questions Redundancy

Route Caching SDN Security

SNMP Storage Switching

Troubleshoot Security

Virtualization VOIP
6. Can 2 HSRP routers becomes Active/Active? VPN technologies

WAN Technologies Wireless

U SD

IN R

7. What is the use of LSA4? Can LSA 3 serve the work of LSA4 in any of
scenario?
8. In the given scenario, Loopback0 (2.2.2.2/32) is advertised into OSPF. SEARCH PRODUCTS
Next, OSPF is redistributed into BGP. Will R3 receive the route of
2.2.2.2/32? Search products… Search

PRODUCT CATEGORIES
Data Network (24)
Security (8)
Services (3)
Uncategorized (6)
Voice (1)
Wireless (2)

9. In which LSA will R1 share route of Loopbacks to R2 and how many LSAs
will be generated? Further, how many LSAs will R2 send to R3?

https://ipwithease.com/networking-scenario-based-interview-questions/ 3/10
6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

10. Can we con gure /32 IP on physical Interface of Router?


11. In the given below setup, will OSPF come up?

12. In the below given setup, will OSPF come up?

U SD

13. In the given setup, if PC2 is disconnected, what will happen to mac-
IN R
address table?

14. In the above question, what should be the value of default gateway on
the TCP/IP adapter settings of PCs for communication between them to
be successful?
15. A router has 3 interfaces – Gi0/0, Gi0/1 and Gi0/2. If the router receives
an Ethernet frame with destination mac-address FF-FF-FF-FF-FF-FF on
Gi0/0, Will the router forward the frame out from Gi0/1 and Gi0/2?
16. In the below diagram, R2 receives a packet from R1 destined to a network
behind R3. The TTL of received packet by R2 is 1. What will the Router do
with packet?

https://ipwithease.com/networking-scenario-based-interview-questions/ 4/10
6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

17. A merger has taken place between 2 Organizations with AS 1 and AS 2


respectively. A new Router R4 has been installed to connect both the
organization networks. After R4 forming neighborship all the 3 directly
connected neighbors, still the networks are unable to communicate. What
could be the probable cause?

The Interface details of R4 is given below –

U SD

IN R

18. In the HSRP Setup, R1 is the active HSRP Router and forwards the tra c
towards WAN1.The customer wants speci c destination tra c to take
WAN2 path and rest of default tra c to take path via WAN1 on same
HSRP Group. Would this be possible?

19. In the given setup, R1 is Active HSRP Router .Due to WAN link going down,
R2 takes on the role of active Router. Now, Layer 2 Switch has MAC table
information to forward the tra c towards R1 (Mac address of HSRP
master). Which mechanism tells SW1 to forward the HSRP tra c towards
R2 and not R1?

https://ipwithease.com/networking-scenario-based-interview-questions/ 5/10
6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

20. In the below given con guration, R10, R1, R2 and R3 are forming EIGRP
neighborship across AS1 and 2. But R10 I unable to any external network
like 192.168.23.0/24 and 3.3.3.0/24. What could be the probable cause?

U SD

21. In the below given OSPF setup (comprising of Area0, Area 1 and Area 2),
R1 is unable receives routes from Area 2. As an architect for this network, IN R

what are your recommendations on the design?

22. In the below scenario, CE1 is active HSRP GW for LAN while CE2 is
standby. Both the CEs are running static Default Route towards WAN
Links and monitoring their WAN Internet (Ethernet Links) status for HSRP
failover. However, one day cable between 1st link L2 SW and PE1 got
faulty which lead to downtime of 1 hour. Company management is very
critical on the downtime and wants the architect to resolve the issue. As a
network architect, what is your proposal on the case (considering provide
routers don’t support dynamic Routing)?

https://ipwithease.com/networking-scenario-based-interview-questions/ 6/10
6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

23. In the below given diagram, there is a requirement to have Active-Active


link for incoming tra c from WAN 1 and 2. To achieve this scenario, the
LAN has been divided into Network X and Y. How can this be achieved?

24. In the previous question, now we need to have Active-Active ow for


outgoing tra c towards WAN 1 and 2. How can this be achieved?
25. In the given diagram, 1.1.1.0/24 is not learnt by R3. What could be the U SD

probable cause?
IN R

26. In the below given diagram, the newly installed Access point is able to
reach the controller (through ping) but AP to WLC controller registration 
is not happening. What could be the key reasons for this issue?

https://ipwithease.com/networking-scenario-based-interview-questions/ 7/10
6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

27. In the below given setup, eBGP is running between R1, R2 and R3. For
some reason R3 is not learning Network X routes advertised by R1. What
could be the probable cause of this? How can this be resolved?

U SD

IN R

28. In OSPF, an area can scale upto how many maximum number of Routers?
29. As shown in the below given diagram, 3 Switch have been connected to
each other over Gigabit Ethernet links. Which Switch will become Root
Bridge and on what criteria?

https://ipwithease.com/networking-scenario-based-interview-questions/ 8/10
6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

30. In the below given scenario, which port on which switch will go into
blocking stage? Kindly elaborate the reason?

ANSWERS
@https://ipwithease.com/shop/
Please follow and like us:
Tweet Save
U SD
 Post Views: 530

IN R

Tags: questions

RELATED POSTS

BUZZ BUZZ BASICS WITH EASE

NFC TYPES OF ARP MPLS


TECHNOLOGY April 1, 2017 | CHEATSHEET
June 7, 2016 | IPWITHEASE | No August 23, 2017 |

IPWITHEASE | No Comments IPWITHEASE | No

https://ipwithease.com/networking-scenario-based-interview-questions/ 9/10
6/21/2019 Networking Scenario Based Interview Questions | IP With Ease

Comments Comments
MORE 

MORE  MORE 

ADD COMMENT

Comment Text*

Name*

Email*

Website U SD

IN R

POST COMMENT

Copyright © 2019 IP With Ease . Designed and Developed by WOW IT Solutions


HOME | ABOUT US | DISCLAIMER | TERMS OF USE | CONTACT US

Social Media Auto Publish Powered By : XYZScripts.com

https://ipwithease.com/networking-scenario-based-interview-questions/ 10/10

You might also like