The document provides load calculations and design specifications for a sag rod. It calculates dead loads, live loads, and wind loads on a roof. It then determines the induced force and reaction on the sag rod based on 2.5% of the purlin load. The required sag rod area is 0.88789 sq mm and a 12 mm diameter rod is provided with an area of 113.04 sq mm. Bolt design calculations show the 12 mm bolt meets the design tension capacity of 24.7 kilonewtons.
The document provides load calculations and design specifications for a sag rod. It calculates dead loads, live loads, and wind loads on a roof. It then determines the induced force and reaction on the sag rod based on 2.5% of the purlin load. The required sag rod area is 0.88789 sq mm and a 12 mm diameter rod is provided with an area of 113.04 sq mm. Bolt design calculations show the 12 mm bolt meets the design tension capacity of 24.7 kilonewtons.
The document provides load calculations and design specifications for a sag rod. It calculates dead loads, live loads, and wind loads on a roof. It then determines the induced force and reaction on the sag rod based on 2.5% of the purlin load. The required sag rod area is 0.88789 sq mm and a 12 mm diameter rod is provided with an area of 113.04 sq mm. Bolt design calculations show the 12 mm bolt meets the design tension capacity of 24.7 kilonewtons.
The document provides load calculations and design specifications for a sag rod. It calculates dead loads, live loads, and wind loads on a roof. It then determines the induced force and reaction on the sag rod based on 2.5% of the purlin load. The required sag rod area is 0.88789 sq mm and a 12 mm diameter rod is provided with an area of 113.04 sq mm. Bolt design calculations show the 12 mm bolt meets the design tension capacity of 24.7 kilonewtons.
Load Calculations Dead Load due to Sheet 0.063 Kn/sq m Additional Dead Load 0.060 Kn/sq m
Dead load due to purlin weight,
10% of purlin weigh extra for cleat 0.045 Kn/sq m Total dead load 0.168 Kn/sq m Live Load 0.547 Kn/sq m Wind load -1.07 Kn/sq m The dead load component normal to roof 0.236 Kn/m The live load component normal to roof 0.77028 Kn/m The total load normal to roof 2.487 Kn/m
Sag rod will be designed as
2.5% load of axial capacity of purlin or bending compressive stress of purlin Induced force in sag rod 0.12503 Kn Induced reaction in sag rod 0.13318 Kn (consider 250 Mpa yield Area Reuired for sag rod 0.88789 sq mm Stress) Area Provided 113.04 sq mm
Provide 12 mm dia sag rod.
Bolt Design (Considering 4.6 grade of Ultimate Capacity of Bolt 400 N/ sqmm Bolt) Yield Capacity of Bolt 240 N/ sqmm Diameter of Bolt 12 mm gross area of Bolt 113.04 Sq mm Shank area of Bolt 88.736 Sq mm Tension capacity of bolt, Tnb 31945.1 N Or 30829.1 N Tension capacity of bolt, Tnb 30829.1 N (Min of Both) Design Tension Capacity of Bolt 24.7 Kn OK
