Welding Project
Welding Project
Welding Project
KAMPALA (UGANDA)
DATE : 30 /03/2023
SIGNATURE:.............
DECLARATION
I HEREBY DECLARE THAT THE CONTENT IN THIS REPORT HAS BEEN
DONE TO THE BEST OF MY KNOWLEDGE AND HAS NOT BEEN
SUBMITTED TO ANY HIGHER INSTITUTION OF EDUCATION OF ANY
AWARD.
SIGNATURE: ……………………………………..
3/04/2023
DATE: …………………………………………………..
APPROVAL
SIGNATURE: ………………………………………………………….
DATE: ……………………………………………………………
DEDICATION
I hereby dedicate this report to Mr NYANZI MATIA who have really worked
hard to see that I study this mechanics course…
I finally dedicate this report to the almighty GOD who has been guiding me
from the day I first joined the spear motors training Institute up to date…
ACKNOWLEDGEMENT
This project was started and concluded under the supervision of all the
lecturers at spear motors training institute. I'm grateful for their time and
guidelines that saw this project to a successful end.
report…
ABSTRACT
During this welding project, i have been able to learn new ideas and
techniques i never knew before
CHAPTER 7 challenges
CHAPTER 1
TOOLS WE USED
Welding machine/transformer;
provided power for welding
Welding rods;
for joining material surfaces
Tape measure;
for measuring length of the materials
Scriber;
we used it for marking material surfaces
Chipping hammer;
we used it for chipping cool off flux
Square;
we used it to join material at an angle of 90
Welding glass;
we used it for the safety of our eyes
Flux;
a courting formed on top of a welded point
Wire brush;
we used this for cleaning welded joints
Spirit level;
we used this for finding the ground level of the workpiece
Vice;
we used a vice for holding the workpiece during cutting and filing
Pillar bench drilling machine;
We used it for making drillings on locks
Power hacksaw;
We used for cutting pieces of metal
Hand shearing machine;
We used it for cutting metal sheets
Safety boots;
Welding torch
Stainless steel metric ruler
CHAPTER 2
Materials we used
Angle line steel
12 piece 40cm each for partitioning the cubicle vertically
3 piece 200cm each partitioning the cubicles horizontally
CHAPTER
Welding techniques we used we used
Spot
Weave welding
Polarity,
Voltage,
weld groove,
travel speed,
electrode extension,
CHAPTER5
Tools
Spray gun
Thinner
We used this for dissolving the paint
air compressor
This provided compressed air we used to spray
CHAPTER6
Spraying procedures
CHAPTER 7