Scribd
Upload
30 views1 page

WP 32

The document provides instructions for activating and shutting down functions of an inverter as well as modifying parameter settings. It describes several parameters including buzzer alarm, power saving mode, backlight, overload auto restart, over temperature auto restart, and beeps while primary source interrupt.

Uploaded by

tonielhage
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
30 views1 page

WP 32

The document provides instructions for activating and shutting down functions of an inverter as well as modifying parameter settings. It describes several parameters including buzzer alarm, power saving mode, backlight, overload auto restart, over temperature auto restart, and beeps while primary source interrupt.

Uploaded by

tonielhage
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Diagram 4-12

NOTE: This screen may be different for different model of inverter.

Step 1 Activate/Shut down functions by clicking “Enable” or “Disable” button. Some


parameters are allowed to change the numbers by clicking up-down arrows or
modify the numbers directly in the number column.

Step 2 Click “Apply” button to save the settings. Each function setting is saved by
clicking each “Apply” button.

z Buzzer alarm: If disabled, buzzer won’t be on when alarm/fault occurred. Vice


versa.

z Power saving mode: If disabled, output will be on continuously when device is


operated in battery mode. If enabled, inverter output will be on or off depending on
connected loads detected or not. If the load is not detected, the output of inverter
will be off until load reaches a certain level. Check product manual for more details.

z Backlight: If disabled, LCD backlight will be off when panel button is not operated
for 1 minute. Vice versa.

z Overload auto restart: If disabled, the unit won’t be restarted after overload occurs.
Vice versa.

z Over temperature auto restart: If disabled, the unit won't be restarted after
over-temperature fault is solved. Vice versa.

z Beeps while primary source interrupt: If enabled, buzzer will alarm when primary

 

You might also like