Scribd Logo
Upload

Welcome to Scribd!

  • 13 views

    Service Letter 1122

    Uploaded by

    Biblioteca Brasil Aviation

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Service Letter 1122

    Uploaded by

    Biblioteca Brasil Aviation
    13 views5 pages

    Original Title

    SERVICE_LETTER_1122

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    13 views5 pages

    Service Letter 1122

    Uploaded by

    Biblioteca Brasil Aviation

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 5

    ® SERVICE NO.

    1122

    Piper Aircraft, Inc.


    2926 Piper Drive
    LETTER
    Vero Beach, Florida, U.S.A. 32960

    Date: May 20, 2010 (S)

    SUBJECT: G1000 SPLIT COMMUNICATIONS ENABLE

    MODELS AFFECTED: SERIAL NUMBERS AFFECTED:


    PA-46R-350T Matrix 4692134 through 4692147
    PA-46-350P Mirage 4636460; 4636463 through 4636469

    COMPLIANCE TIME: At owner/operator’s discretion.

    APPROVAL: The technical content of this Service Letter has been shown to comply with the
    applicable Federal Aviation Regulations and is FAA approved.

    PURPOSE: This Service Letter provides instructions to enable the split communications
    feature of the Garmin G1000 system, which will allow the pilot and co-pilot to
    transmit/receive on Comms 1 and 2 simultaneously.

    INSTRUCTIONS:
    1. Apply power to aircraft and all avionics.
    2. Pull MFD and both PFD circuit breakers.
    3. While holding the far right softkey on the MFD, restore power to the MFD.
    4. When the words “INITIALIZING SYSTEM” appear in the upper left corner of the MFD, release the softkey.
    5. While holding the far right softkey on the PFD 2, restore power to the PFD 2.
    6. When the words “INITIALIZING SYSTEM” appear in the upper left corner of the PFD 2, release the softkey.
    7. While holding the far right softkey on the PFD 1, restore power to the PFD 1.

    (OVER)
    ATA: 2300
    SERVICE LETTER NO. 1122  PAGE 2 of 5

    8. When the words “INITIALIZING SYSTEM” appear in the upper left corner of the PFD 1, release the softkey.
    9. The SYSTEM STATUS page should appear as shown below:

    10. By rotating the large FMS knob, go to the GMA Configuration page in the GMA group as shown below:
    SERVICE LETTER NO. 1122 PAGE 3 of 5

    11. Press the softkey located under OPTIONS on the PFD, see below for GMA CONFIGURATION:

    12. Activate cursor by pressing the FMS knob.


    13. By rotating the large FMS knob, scroll down to “DISABLE SPLIT COM”. Press ENT key to configure GMA as
    shown below:
    SERVICE LETTER NO. 1122 PAGE 4 of 5

    14. Press ENT to accept configuration.

    15. The final configuration is shown below:


    SERVICE LETTER NO. 1122 PAGE 5 of 5

    MATERIAL REQUIRED: N/A

    AVAILABILITY OF PARTS: N/A

    EFFECTIVITY DATE: This Service Letter is effective as of release date.

    SUMMARY: N/A

    NOTE: Please notify the factory of any address/ownership corrections. Changes should include aircraft
    model, serial number, current owner’s name and address.

    Corrections and/or changes should be directed to:

    PIPER AIRCRAFT, INC.


    Attn: Customer Service
    2926 Piper Drive
    Vero Beach, FL 32960

    You might also like