Chemical Name : Acrylic Ester Copolymer Emulsion Cas Reg. No. : Not applicable (mixture) Main Ingredients : Water : 54-56 % Polymeric type : Polyacrylic Free Monomer : 0,3% maximum Others : -- Manufacturer : PT. JUSTUS SAKTI RAYA Head Office : Wisma Justus Jl. Danau Sunter Utara No. 27-28, Blok O3, Jakarta 14350 (Seberang Kantor PT. Toyota Astra Motor – Sunter) Phone : (021) 6515188; 65306066; 65304880 (hunting) Fax : (021) 65305066 Website : http://www.justus.co.id Email : general_jsr@justus.co.id Factory : Jl. Cakung Cilincing Raya Jakarta 14130 INDONESIA Phone : (021) 4401616;4400360
YUKASHU® IS A REGISTERED TRADEMARK
II.COMPOSITION/INFORMATION ON INGREDIENTS
Polymer and additives : 44-46 %
Water : 54-56 % (CAS No. 7732-18-5)
Important: While the descriptions, designs, data and information contained herein are presented in good faith and believed to be accurate, it is provided for your guidance only. Because many factors may affect processing or application/use, we recommend that you make tests to determine the suitability of a product for your particular purpose prior to use. No warranties of any kind, either expressed or implied, including warranties of merchantability or fitness for a particular purpose, are made regarding products described or designs, data or information set forth, or that the products, designs, data or information may be used without infringing the intellectual property rights of others. In no case shall the description, information, data or designs provided be considered a part of our terms and conditions of sales. Further, your expressly understand and agree that the descriptions, designs, data, and information furnished by PT Justus Sakti Raya hereunder are given free and PT Justus Sakti Raya assumes no obligation or liability for the description, designs, data and information given or results obtained, all such being given and accepted at your risk.
Page 1 of 6 PT JUSTUS SAKTI RAYA Chemicals Manufacturer
MATERIAL SAFETY DATA SHEET
III. HAZARD IDENTIFICATION
1. HEALTH HAZARD DATA.
Swallowing : No evidence of harmful effects from available information. Skin absorption : No evidence of harmful effects from available information. Inhalation : Trace component and residual monomer vapour may be irritating to the eyes, mucous membrane, respiratory tract, and may produce symptoms of headache, nausea in poorly ventilated areas. Skin contact : Prolonged contact may cause transient reddening of the skin. Eye contact : Direct contact may cause eye irritation. 2. EFFECTS OF REPEATED OVEREXPOSURE: No evidence of harmful effects from available information. 3. MEDICAL CONDITIONS AGGRAVATED BY OVEREXPOSURE. A knowledge of the available toxicology information and of the physical and chemical properties of the matter suggests that overexposure is unlikely to aggravate existing medical conditions. 4. OTHER EFFECTS OF OVEREXPOSURE. No evidence of harmful effects from available information.
IV.FIRST AID MEASURES.
Swallowing : No harmful effects expected.
Inhalation : No emergency are anticipated. Skin contact : Wash skin with soap and water until water is no longer claudy. If clothing is soaked, remove and wash before reuse. Eye contact : Immediately flush eyes with plenty of water. Get medical attention if irritaion persists. Note to physician : Toxicology studies have shown this or similar material to be of very low acute toxicity. There is no specific antidote. Treatment of overexposure should be directed at the control of symptoms and the clinical condition of the patient.
Important: While the descriptions, designs, data and information contained herein are presented in good faith and believed to be accurate, it is provided for your guidance only. Because many factors may affect processing or application/use, we recommend that you make tests to determine the suitability of a product for your particular purpose prior to use. No warranties of any kind, either expressed or implied, including warranties of merchantability or fitness for a particular purpose, are made regarding products described or designs, data or information set forth, or that the products, designs, data or information may be used without infringing the intellectual property rights of others. In no case shall the description, information, data or designs provided be considered a part of our terms and conditions of sales. Further, your expressly understand and agree that the descriptions, designs, data, and information furnished by PT Justus Sakti Raya hereunder are given free and PT Justus Sakti Raya assumes no obligation or liability for the description, designs, data and information given or results obtained, all such being given and accepted at your risk.
Page 2 of 6 PT JUSTUS SAKTI RAYA Chemicals Manufacturer
MATERIAL SAFETY DATA SHEET
V. FIRE-FIGHTING MEASURES.
Extinguishing media : This product is non-flamable aqueous emulsion. After water evaporates, the remaining material will burn. Use alcohol-type or all-purpose type foams applied by manufacture ‘s recommended techniques for large fires. Use carbon dioxide or dry chemical media for small fires.
Extinguishing media to be avoided : None
Special fire fighting procedures : None.
Special protective equipment for firefighters : Use self-contained breathing apparatus when fighting fires in enclosed areas.
Unusual fire and explosion hazards :Product will not burn may spatter if temperature exceeds boiling point of water. Dry solids car burn giving off oxides of carbon.
VI. ACCIDENTAL RELEASE MEASURES
Steps to be taken if material is released or spilled :
Restrict the area to only those personnel needed. Major spills should be collected for disposal. Minor spills may be flushed to sewer if permitted by national, state and local regulations.
VII. HANDLING AND STORAGE.
1. HANDLING :
General handling precautions : Avoid breathing vapours in top of shipping container.
Use with adequate ventilation. Avoid contact with skin and clothing. Wash thoroughly after handling.
Ventilation : General (mechanical) room ventilation is expected to be
satisfactory. Use local exhaust if needed to control mest and vapour.
Other precautions : None known.
2. STORAGE : Keep container closed when not is use.
Important: While the descriptions, designs, data and information contained herein are presented in good faith and believed to be accurate, it is provided for your guidance only. Because many factors may affect processing or application/use, we recommend that you make tests to determine the suitability of a product for your particular purpose prior to use. No warranties of any kind, either expressed or implied, including warranties of merchantability or fitness for a particular purpose, are made regarding products described or designs, data or information set forth, or that the products, designs, data or information may be used without infringing the intellectual property rights of others. In no case shall the description, information, data or designs provided be considered a part of our terms and conditions of sales. Further, your expressly understand and agree that the descriptions, designs, data, and information furnished by PT Justus Sakti Raya hereunder are given free and PT Justus Sakti Raya assumes no obligation or liability for the description, designs, data and information given or results obtained, all such being given and accepted at your risk.
Page 3 of 6 PT JUSTUS SAKTI RAYA Chemicals Manufacturer
MATERIAL SAFETY DATA SHEET
VIII. EXPOSURE CONTROL/PERSONAL PROTECTION.
Exposure limits : Non value assigned for this product.
Personal protection : Respiratory protection : None should required. If necessary , use OSHA/NIOSH approved respirators in poor ventilated areas. Hand protection : Use gloves impervious to water and soap. Eye protection : Safety glasses. Other protective equipment : Eye bath and safety shower.
IX. PHYSICAL AND CHEMICAL PROPERTIES:
Physical state : Fluid.
Color : White Odour : Mild Molecular weight : Mixture. Boiling point : 100oC Freezing point : 0oC Melting point : Not applicable. Flash point : Not applicable Flammability limits : Upper and lower : Not applicable (aqueous system). in air (% by volume) Specific gravity (H2O=1) : 1.06 Vapour pressure : Same as water. Vapour density (air = 1) : <1 Evaporation rate : Is lower than Butyl Acetate (Butyl Acetate = 1) Solubility in water : Dilutable Percent volatiles : 54-56 wt % (water)
X. STABILITY AND REACTIVITY
Stability : Stable. Condition to avoid : None. Incompatible materials : None Hazardous combustion products : Carbon monoxide and/or carbon dioxide. Polymerization : Will not occur. Condition to avoid : None
Important: While the descriptions, designs, data and information contained herein are presented in good faith and believed to be accurate, it is provided for your guidance only. Because many factors may affect processing or application/use, we recommend that you make tests to determine the suitability of a product for your particular purpose prior to use. No warranties of any kind, either expressed or implied, including warranties of merchantability or fitness for a particular purpose, are made regarding products described or designs, data or information set forth, or that the products, designs, data or information may be used without infringing the intellectual property rights of others. In no case shall the description, information, data or designs provided be considered a part of our terms and conditions of sales. Further, your expressly understand and agree that the descriptions, designs, data, and information furnished by PT Justus Sakti Raya hereunder are given free and PT Justus Sakti Raya assumes no obligation or liability for the description, designs, data and information given or results obtained, all such being given and accepted at your risk.
Page 4 of 6 PT JUSTUS SAKTI RAYA Chemicals Manufacturer
MATERIAL SAFETY DATA SHEET
XI. TOXICOLOGICAL INFORMATION.
1. Acute toxicological information :
Information on analogous product shows minimal toxicity concerns.
2. Other toxicological information:
Information on analogous product shows minimal toxicity concerns.
XII ECOLOGICAL INFORMATION.
Persistence and degradability : Polymer is not biodegradable.
Environmental risks : Not toxic to fish or plants.
Others information : Does not inhibit bacteria in waste treatment facilities.
XIII. DISPOSAL CONSIDERATIONS.
Waste disposal method(s) :
Recycle or incinerate or absorb water and bury in a suitable landfill where permitted under appropriate national and local regulations.
XIV. TRANSPORT INFORMATION
TRANSPORT CLASSIFICATION :
ADR/RID……….. : This product is not submitted to the ADR regulations.
IMDG …………. : This product is not submitted to the imo regulations. MARPOL ……… : ANNEX II …. : Not evaluated at this moment. ANNEX III…. : Not classified. ICAO ………...... : This product is not submitted to the ICAO regulations.
Important: While the descriptions, designs, data and information contained herein are presented in good faith and believed to be accurate, it is provided for your guidance only. Because many factors may affect processing or application/use, we recommend that you make tests to determine the suitability of a product for your particular purpose prior to use. No warranties of any kind, either expressed or implied, including warranties of merchantability or fitness for a particular purpose, are made regarding products described or designs, data or information set forth, or that the products, designs, data or information may be used without infringing the intellectual property rights of others. In no case shall the description, information, data or designs provided be considered a part of our terms and conditions of sales. Further, your expressly understand and agree that the descriptions, designs, data, and information furnished by PT Justus Sakti Raya hereunder are given free and PT Justus Sakti Raya assumes no obligation or liability for the description, designs, data and information given or results obtained, all such being given and accepted at your risk.
Page 5 of 6 PT JUSTUS SAKTI RAYA Chemicals Manufacturer
MATERIAL SAFETY DATA SHEET
XV. REGULATION INFORMATION.
EU CLASSIFICATION
Danger symbol(s) :- EC reference number : - Note(s) : - Risk phrases :- Safety phrases :- Label test : For industrial use only. Contains :-
REGULATORY DATA : All other national and local regulations, if applicable to the use, transport or disposal of this product, should be observed.
CHEMICAL INVENTORY INFORMATION :
EINECS : The component monomers of this polymer are listed on the EINECS inventory. TSCA : This product is on or exempt from the TSCA inventory. MITI : This product is on the MITI inventory. AICS : This product is on the AICS inventory. DSL : This product is on the DSL inventory. NEPA : This product is on the China inventory.
XVI. OTHERS INFORMATION
Recommended uses and restrictions :
Please consult the relevant product and/or application information for this product.
Important: While the descriptions, designs, data and information contained herein are presented in good faith and believed to be accurate, it is provided for your guidance only. Because many factors may affect processing or application/use, we recommend that you make tests to determine the suitability of a product for your particular purpose prior to use. No warranties of any kind, either expressed or implied, including warranties of merchantability or fitness for a particular purpose, are made regarding products described or designs, data or information set forth, or that the products, designs, data or information may be used without infringing the intellectual property rights of others. In no case shall the description, information, data or designs provided be considered a part of our terms and conditions of sales. Further, your expressly understand and agree that the descriptions, designs, data, and information furnished by PT Justus Sakti Raya hereunder are given free and PT Justus Sakti Raya assumes no obligation or liability for the description, designs, data and information given or results obtained, all such being given and accepted at your risk.
