Aw FP100
Aw FP100
Aw FP100
CHAPTER 1
GENERAL INFORMATION
1.1 INTRODUCTION
6
ASENWARE LTD.
Reset
Press RESET to eliminate all current alarms and reboot the system. The whole process takes 30-
60s.RESET clear all latched alarms and other events as well as turn off event LEDs. If alarms or
other off-normal events exist after reset, they will resound the system and relight the LEDs.
Evacuate
Press this key, holding it down for 2 seconds, to activate all silenceable fire output circuits.
By pressing this key, the panel sound will be silenced but LED will keep open.
Test
For Lamp Test, press this key to test the LED indicators on the left of the keypad, the panel circuit
LEDs.
7
ASENWARE LTD.
Fire Alarm Red Illuminates when at least one fire alarm event exists
System Fault Illuminates when any system is in fault or system is not working
Yellow
as expected
Supervisory Yellow Illuminates when at least one fire alarm event exists
Test Yellow Illuminate when the panel carries out Lamp test for all LEDs
AW FP 100 Series Fire Alarm Control Panel are composed of the following main parts
The main control part is responsible for processing and analyzing the data transmitted from other
parts, and activating other parts of the system based on the result of data analysis, for example,
sounding the buzzer of the panel when a fire is detected.
The display element provides main output interface for alarm signal, fault, supervisory and
interface for routine maintenance and query.
8
ASENWARE LTD.
From the display, it is very convenient for the programmer to input and register the devices.
The power supply is designed to supply power to all devices in the system. The system adopts
the special firefighting equipment powered with DC 24V output, which can provide alarm or
feedback signals, such as main power fault, battery fault, battery under-voltage and battery
charging, and have a good capacity for interference.
The loop card is used as the driver of detector/module bus, which may drive 250 intelligent
detectors or intelligent modules and can be equipped with bus type fire indicating panel.
The system can get access to various intelligent smoke, heat or combination detectors
produced by the manufacturer, and the main types include detectors, modules, horn strobes ,
manual call point and so on.
The system can be interconnected to Modules, Manual Call Point, Relays, Deluge vale
and Gas System. The system can get access to multiple intelligent modules e.g. Input module
AW-D110 , Control Module AW-D112 , Supervisory Module and Isolator Module AW-D111 and
D114 respectively. Moreover, it can also get access to intelligent sounder visual indicator AW-
D106, and intelligent manual call point AW-D105. Panel can be configured with Gas
Extinguishing system, deluge system or other water based system and supervisory of various
types of valves.
1.4.7 Printer
The system is equipped with a special mini-printer as standard, which can print alarm,
supervisory and fault messages for future reference.
9
ASENWARE LTD.
The control panel electronics are contained on one printed circuit board that incorporates with
loop cards and the central processing unit (CPU). The built-in power supply includes an integral
battery charger. A display unit is connected over the PCB.
10
ASENWARE LTD.
1.5.3 Terminals
Refer to product instructions for detailed technical parameters of the detector, module, sounder
visual indicator and so on
11