Scribd
Upload
666 views1 page

User Manual USR TCP232 410S Quick Start Guide 10

The document provides instructions for configuring a USR-TCP232-410s RS-232/485 serial to Ethernet converter, including: 1. Connecting the converter to an Ethernet router or PC using an Ethernet cable and connecting serial devices via an RS-232 or RS-485 cable 2. Assigning the computer a static IP address in the 192.168.0.2-192.168.0.254 range to communicate with the converter, which has a default IP of 192.168.0.7 3. Downloading and installing Virtual COM software to use the converter as a virtual COM port

Uploaded by

dnc_rock
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
666 views1 page

User Manual USR TCP232 410S Quick Start Guide 10

The document provides instructions for configuring a USR-TCP232-410s RS-232/485 serial to Ethernet converter, including: 1. Connecting the converter to an Ethernet router or PC using an Ethernet cable and connecting serial devices via an RS-232 or RS-485 cable 2. Assigning the computer a static IP address in the 192.168.0.2-192.168.0.254 range to communicate with the converter, which has a default IP of 192.168.0.7 3. Downloading and installing Virtual COM software to use the converter as a virtual COM port

Uploaded by

dnc_rock
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

2.Serial Port 4.

Configure USR-TCP232-410s
RS-232 DB9 Male Port ■ Assign a static IP address to your computer in the
RS-485 Terminal header 192.168.0.2 to 192.168.0.254 range. Mask 255.255.255.0.
Quick Start Guide This is necessary to ensure that your computer can
communicate with your USR-TCP232-410s
RS232/485 Serial To Ethernet Converter
MODEL USR-TCP232-410s ■ The default IP address of 410s is 192.168.0.7
Open your web browser and enter this IP to connect
to USR-TCP232-410s for configure.

Default Parameters
User Name admin
Password admin
IP address 192.168.0.7

Mask 255.255.255.0
Gateway 192.168.0.1
Work Mode TCP Server

1. Hardware Installation Local Port


23 (RS232)
26 (RS485)
 Use a standard Ethernet cable to connect the USR- Baud Rate 115200

TCp232-410s to an Ethernet router or connect it Parity bit/Data bit/Stop bit None/8/1


directly to a PC.
RS-232/485 can connect with a PC or other serial port
3. Software Installation
device by serial cables  Download Setup/Test program from website
http://www.usriot.com/usr-tcp232-m4e45-setup-v2-3-0-78/
https://www.pusr.com/products/modbus-serial-to-ethernet-
converters-usr-tcp232-410s.html
 Install Virtual COM software- VCOM Website: http://www.usriot.com
http://www.usriot.com/p/rs232rs485rs422-serial-ethernet-
Email:[email protected]
converter/

Note: Be sure you have administrative rights and disable


any firewalls/anti-virus software when install software.

You might also like