Eni Blasia
Eni Blasia
Eni Blasia
High-pressure gear oil based on mineral oil for oiltight mechanical industrial transmissions
and other high loaded lubricating points.
Agip BLASIA Unit 68 100 150 220 320 460 680 Test method
Kin. Viscosity at 40°C mm²/s 64 99 141 220 303 461 628 DIN 51 550
at 100°C mm²/s 8,4 11,1 14,1 18,9 23,4 30,5 37,1
Viscosity index 98 96 96 96 96 95 95 DIN ISO 2909
Density at 15°C kg/m³ 885 890 895 900 903 909 915 DIN 51 757
Flashpoint o. C. °C 225 228 238 240 240 245 250 DIN ISO 2592
Pour point °C -24 -24 -21 -18 -18 -15 -9 DIN ISO 3016
Designation CLP CLP CLP CLP CLP CLP CLP DIN 51 517 T.3
ISO-VG grades 68 100 150 220 320 460 680
Agip BLASIA - types are produced from a well-balanced combination of carefully selected
base oils and coordinated high-pressure additives with them with a wide sphere of action.
Sulphurous additives cause at relatively high gliding speeds as well as well as at intermittent
and oscillating loads a layer building stable lubrication film. Additives based on phosphor take
effect especially at high loaded slow running transmissions and contribute the formation of a
stable and seizing preventing lubrication film. The high base oil quality in connection with
oxidation inhibitors ensure a high thermal load capacity and long service times. They are
compatible with all common sealing materials and internal varnishes.
Applications:
Agip BLASIA - types are applicable as high-performance gear oils for the splash and circular
lubrication in all oiltight incased transmissions, especially with mechanically high loaded
lubricating points such as slow running and high loaded sliding and roller bearings, clutches,
spindles and transmissions with high surface pressures and numbers or revolution. Since these
oils do not content lead soaps they can also be used for the oil mist lubrication.
Agip BLASIA Unit 68 100 150 220 320 460 680 Test method
Neutralisation number (s) mgKOH/g 0,4 0,5 0,5 0,5 0,5 0,6 0,6 DIN 51 558 T.1
Ash (sulphate) weight % 0,04 DIN 51 575
Coke residue according to
weight % 0,1 0,1 0,3 0,4 0,5 0,7 1,5 DIN 51 551
Conradson
Corrosion effect on copper Corr.-grade 1 - 100 A 3 DIN 51 759
Corrosion protection DIN 51 355
Corr.-grade 0-A
properties against steel method A
Determination of
g/100 g < 0,03 DIN 51 592
undissolved materials
Demulsifying power 54°C min 15 10 --- --- --- --- ---
82°C min 15 15 15 15 --- DIN 51 599
Water content g/100g < 0,1 DIN ISO 3733
FZG-Test A/16,6/140
> 12 DIN 51 354 T.2
load stage
Spec. change of weight mg/KWh < 0,27
Timken test OK load lbs 60 60 60 65 60 65 65
Specifications: