Azeron Manual V2.0
Azeron Manual V2.0
Manual
MANUAL V2.0
TABLE OF CONTENTS
1. INTRODUCTION……………………………………………………………………….. 2
2. FEATURES / PACKAGE CONTENTS……………………………………………. 3
3. DEVICE LAYOUT………………………………………………………………………. 4
4. SETUP YOUR AZERON KEYPAD………………………………………………… 5
5. HOWTO UPDATE FIRMWARE MANUALLY………………………………… 6
6. HOW TO USE AZERON SOFTWARE………………………………………….. 8
7. TIPS AND TRICKS……………………………………………………………………..13
PACKAGE CONTENTS
By using the included Hex key, it is possible to adjust each key tower
position for your hand.
Step 1:
Connect keypad to USB slot (don’t connect to USB 3.0 if you don’t have
USB 3.0 drivers installed)
Step 2:
Open teensy.exe software
Step 3:
Press on first button to load hex file (for example, “Firmware.hex”)
Step 4:
Reset Azeron keypad by pressing pin in the hole shown in the picture
Step 6:
After that press button 3, to restart Teensy. Done!
OVERVIEW
There are 2 profile types available - hardware and software. Hardware profiles are saved on
the onboard memory (so you can use the keypad on other PC and it will work with the saved
settings). If you are using only hardware profiles, then Azeron software doesn’t need to run
while gaming, it is used just to setup buttons. If you are using software profile, then the
Azeron software needs to run while playing the game.
BUTTON SETUP
To setup buttons, click on the button you wish to setup, then choose between 3 modes:
keyboard, joystick or no action.
In joystick mode the keypad will act as a joystick button (it can be well used in games which
uses gaming controllers). Or it can be used together with JoyToKey software to get more
THUMBSTICK SETUP
Thumbstick has 2 modes – it acts as analog stick or as a keyboard buttons (D-Pad).
With angle setting it is possible to rotate the forward direction for thumbstick:
PROFILE SWITCH
To switch between profiles you need to press mode switch on the side of the keypad.
If you are running on Hardware profiles, the mode switch will switch between both
Hardware profiles which are on the onboard memory.