Scribd
Upload
43 views3 pages

Flame Sensor2

- This module can detect flames or light sources between 760nm-1100nm wavelengths up to 100cm away. It has a 60 degree detection angle and is sensitive to flame spectra. - It has adjustable detection range and outputs both digital and analog signals. The digital output indicates detection while the analog output varies based on the strength of the detected flame or light. - It operates from 3.3-5V and has power/output indicators. An example Arduino code reads and prints the analog output value for monitoring.

Uploaded by

Shameer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
43 views3 pages

Flame Sensor2

- This module can detect flames or light sources between 760nm-1100nm wavelengths up to 100cm away. It has a 60 degree detection angle and is sensitive to flame spectra. - It has adjustable detection range and outputs both digital and analog signals. The digital output indicates detection while the analog output varies based on the strength of the detected flame or light. - It operates from 3.3-5V and has power/output indicators. An example Arduino code reads and prints the analog output value for monitoring.

Uploaded by

Shameer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

Flame Sensor Module

Introduction
This module is sensitive to the flame and radiation. It also can detect
ordinary light source in the range of of a wavelength 760nm-1100 nm.
The detection distance is up to 100 cm.
The Flame sensor can output digital or analog signal. It can be used as
a flame alarm or in fire fighting robots.

Future Electronics Egypt Ltd. (Arduino Egypt).


Description

• Detects a flame or a light source of a wavelength in the range


of 760nm-1100 nm
• Detection distance: 20cm (4.8V) ~ 100cm (1V)
• Detection angle about 60 degrees, it is sensitive to the flame spectrum.
• Comparator chip LM393 makes module readings stable.
• Adjustable detection range.
• Operating voltage 3.3V-5V
• Digital and Analog Output
"DO digital switch outputs (0 and 1)
"AO analog voltage output
• Power indicator and digital switch output indicator

Interface Description (4-wire)


1) VCC -- 3.3V-5V voltage
2) GND -- GND
3) DO -- board digital output interface (0 and 1)
4) AO -- board analog output interface

Future Electronics Egypt Ltd. (Arduino Egypt).


Arduino Example

Here is sample code and connection to Arduino board. The analog


output can be connected to any analog input pin on Arduino.

AnalogReadSerial
Reads an analog input on pin 0, prints the result to the serial monitor.
Attach the center pin of a potentiometer to pin A0, and the outside pins to
+5V and ground.

This example code is in the public domain.


*/

/ the setup routine runs once when you press reset:


void setup() {
/ initialize serial communication at 9600 bits per second:
Serial.begin(9600);
}

/ the loop routine runs over and over again forever:


void loop() {
/ read the input on analog pin 0:
int sensorValue = analogRead(A0);
/ print out the value you read:
Serial.println(sensorValue);
delay(1);// delay in between reads for stability
}

Future Electronics Egypt Ltd. (Arduino Egypt).

You might also like