Scribd
Upload
61 views2 pages

Cs It 304 Electronics Devices and Circuits Jun 2020

This document contains an 8 question practice exam for the course CS/IT-304 (Grading System). The exam covers topics in electronics devices and circuits, including oscillators, voltage regulators, clippers, multivibrators, transistor biasing, converters, amplifiers, and power supplies. Students are instructed to attempt any 5 of the 8 questions, which vary in length from short definitions to longer circuit explanations and derivations. The exam is meant to test students' understanding of fundamental electronic components and circuits.

Uploaded by

Atharva Atre
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
61 views2 pages

Cs It 304 Electronics Devices and Circuits Jun 2020

This document contains an 8 question practice exam for the course CS/IT-304 (Grading System). The exam covers topics in electronics devices and circuits, including oscillators, voltage regulators, clippers, multivibrators, transistor biasing, converters, amplifiers, and power supplies. Students are instructed to attempt any 5 of the 8 questions, which vary in length from short definitions to longer circuit explanations and derivations. The exam is meant to test students' understanding of fundamental electronic components and circuits.

Uploaded by

Atharva Atre
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

https://www.rgpvonline.

com

Total No. of Questions : 8] [1] [Total No. of Printed Pages : 2

Roll No ..................................
CS/IT-304 (GS)
B.E. III Semester Examination, June 2020
Grading System (GS)
Electronics Devices and Circuits
Time : Three Hours
Maximum Marks : 70
Note: i) Attempt any five questions.
ii) All questions carry equal marks.

1. Draw the circuit diagram and explain the principle of operation of the following oscillators
i) RC phase shift oscillator
ii) LC oscillator

2. a) Explain how a Zener diode can be used as a voltage regulator.


b) Write a short note on UPS.

3. Explain the operation of positive clipper with suitable waveforms.

4. a) Explain the working of Monostable multivibrators.


b) What do you understand by SMPS?

5. Determine the DC bias voltage VCE and IC for the voltage divider configuration of fig.

22V

39kΩ 10kΩ
Vo
Vi → β=140

3.9kΩ 1.5kΩ

6. Draw and explain voltage to current and current to voltage convertor.


OR
Describe Schmitt trigger.

CS/IT-304 (GS) PTO

https://www.rgpvonline.com
https://www.rgpvonline.com

[2]

7. Draw and explain circuit of a transformer coupled single stage transistor power amplifier and
explain the need for impedance matching.
OR
“A depletion mode MOSFET can also be operated in enhancement mode but an enhancement mode
MOSFET cannot be operated in depletion mode.” Justify

8. Answer any four of the following.


a) Write a note on Zener Diode.
b) What are the feedback techniques applied in a feedback amplifier? Explain.
c) Write a note on clamper.
d) Differentiate between an integrator and differentiator.
e) Explain in brief the working of a series regulated power supply.
f) What is meant by Minimum Load Resistance of a power supply.

******

CS/IT-304 (GS) PTO

https://www.rgpvonline.com

You might also like