Scribd
Upload
112 views

Assignment 2 Solution

This document contains the solutions to 5 questions from Assignment 2 for ECE 250. It provides the figures and questions asked for each of the 5 circuit analysis problems. Node voltage analysis, mesh current analysis, source transformation, Thevenin's theorem, and Norton's theorem are used to solve for unknown voltages, currents, power, and equivalent circuits. The assignment was due to instructor Dr. Sana Shuja on June 15th, 2022.

Uploaded by

paisal ahmed
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
112 views

Assignment 2 Solution

This document contains the solutions to 5 questions from Assignment 2 for ECE 250. It provides the figures and questions asked for each of the 5 circuit analysis problems. Node voltage analysis, mesh current analysis, source transformation, Thevenin's theorem, and Norton's theorem are used to solve for unknown voltages, currents, power, and equivalent circuits. The assignment was due to instructor Dr. Sana Shuja on June 15th, 2022.

Uploaded by

paisal ahmed
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 7

Faculty of Engineering | Electrical and Computer Engineering

Engineering Office Wing Room 448 PO Box 1700 STN CSC Victoria BC V8W 2Y2 Canada
T 250-721-6036 | [email protected] |

ECE 250 – Assignment 2 Solution

Instructor Due Date


Dr. Sana Shuja Friday June 15th, 2022
E-mail: [email protected]

Question 1

Find Node Voltages v1, v2, v3 and v4 in Fig. 1. (10 points)

Figure 1
Solution
Question 2

Use Mesh Analysis to find the power supplied by the 2.2 V source
in the circuit of Fig. 2. Label the mesh as following: (10 points)
Top left i1
Top right i2
Bottom left i3
Bottom right i4
All currents are labeled clockwise.

Figure 2
Solution

Question 3

Calculate the current I through 2 Ohm resistor (with Vx voltage


across it) using source transformation and simplifying the circuit
(obtain one closed path) in the circuit of Fig. 3. (10 points)

Figure 3
Solution
Question 4
Find the value of RL such that maximum power is transferred to the
load in the circuit of Fig. 4, also draw the Thevenin Equivalent
circuit, and find the voltage across the load RL. (10 points)
Figure 4
Solution
Question 5

Find the Thevenin and Norton equivalent network to the left of


terminals a – b of the circuit shown in Fig. 5, use a 1 A test
source to find Thevenin equivalent resistance RTH. (10 points)

Figure 5
Solution

You might also like