Scribd
Upload
52 views

Assignment 4 Solution

This document is an assignment sheet from a professor for an Electrical and Computer Engineering course. It provides 5 questions for the assignment related to circuit analysis, along with the due date of July 30, 2022. The questions involve finding equivalent circuits, calculating complex power in circuits, and determining voltage magnitudes and phase angles given load conditions.

Uploaded by

paisal ahmed
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
52 views

Assignment 4 Solution

This document is an assignment sheet from a professor for an Electrical and Computer Engineering course. It provides 5 questions for the assignment related to circuit analysis, along with the due date of July 30, 2022. The questions involve finding equivalent circuits, calculating complex power in circuits, and determining voltage magnitudes and phase angles given load conditions.

Uploaded by

paisal ahmed
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

Faculty of Engineering | Electrical and Computer Engineering

Engineering Office Wing Room 448 PO Box 1700 STN CSC Victoria BC V8W 2Y2 Canada
T 250-721-6036 | [email protected] |

ECE 250 – Assignment 4

Instructor Due Date


Dr. Sana Shuja July 30, 2022
E-mail: [email protected]

Question 1

Find Norton equivalent circuit with respect to terminal a-b in


the circuit of Fig. 1, when Vs = 25∠0° V (10 points)

Figure 1
Solution
Question 2

Find Thevenin equivalent circuit with respect to terminal a-b in


the circuit of Fig. 2. (10 points)

Figure 2
Solution
Question 3

The load impedance in Fig. 3 absorbs 40 kW and 30 kVAR. The


sinusoidal voltage source develops 50 kW. Find the values of
capacitive line reactance that will satisfy these constraints.
(10 points)

Figure 3
Solution

Question 4

The three loads in the circuit in Fig. 4 are


S1 = 5 + j 2 k VA,
S2 = 3.75 + j 1.5 k VA,
S3 = 8 + j 0 k VA
a) Calculate the complex power associated with each voltage
source, Vg1 and Vg2. (5 points)
b) Verify that the total real and reactive power delivered by
the sources equals the total real and reactive power
absorbed by the network. (5 points)

Figure 4

Solution
Question 5
The three parallel loads in the circuit shown in Fig. 5 can be
described as follows: Load 1 is absorbing an average power of 24
kW and reactive power of 18 k VARS; Load 2 is absorbing an average
power of 48 kW and generating reactive power of 30 kVARS; Load 3
is a 60 Ω resistor in parallel with an inductor whose reactance
is 480 Ω. Find the rms magnitude and the phase angle of Vg if
Vo = 2400 ∠0° V (rms). (10 points)

Figure 5
Solution

You might also like