Quiz 2
Quiz 2
Quiz 2
SET A
SO1.1 Identify applicable methods, techniques, and fundamental principles of electricity and magnetism, waves, and light and optics to solve complex engineering problems. complex
engineering problems
2. An electric heater draws 10 A from a 120-V line. The resistance of the heater is:
(a) 1200 Ω (b) 120 Ω (c) 12 Ω (d) 1.2 Ω
3. The voltage drop across a 1.5-kW toaster that draws 12 A of current is:
(a) 18 kV (b) 125 V (c) 120 V (d) 10.42V
4. The maximum current that a 2W, 80 k Ω resistor can safely conduct is:
(a) 160 kA (b) 40 k V (c) 5 mA (d) 25 μA
SO1.3 Solve for the unknown variables or parameters in complex engineering problems based on the derived methods from the fundamental principles of electricity and magnetism, waves,
and light and optics.
Part II. Problem Solving (A). (5pts each) Show detailed solution to get a full mark
Refer to the given circuit as shown in the figure for problems (A1–A2):
Part III. Use the information in the figure below. Show your detailed solution to get a full mark
S.Y 2nd Sem 2022- QUIZ
05/12/2023
III(a) 10pts. Of what material is a wire made, if it is 5.0 m long with a diameter of 2.053 mm and has a resistance of 0.025 Ω at 0°C?
Formulate your answer by completing the table. (Use provided answer sheet)
III(b) 5pts. Determine the temperature of the field winding of a series motor if it is constructed from the material in III(a) when its resistance had
increased to 240 Ω after running for 2 hours. (Sketch/Illustrate before solving)
SETB
SO1.1 Identify applicable methods, techniques, and fundamental principles of electricity and magnetism, waves, and light and optics to solve complex engineering problems. complex
engineering problems
2. An electric heater draws 10 A from a 120-V line. The resistance of the heater is:
(a) 1200 Ω (b) 120 Ω (c) 12 Ω (d) 1.2 Ω
3. The voltage drop across a 1.5-kW toaster that draws 12 A of current is:
(a) 18 kV (b) 125 V (c) 120 V (d) 10.42V
4. The maximum current that a 2W, 80 k Ω resistor can safely conduct is:
(a) 160 kA (b) 40 k V (c) 5 mA (d) 25 μA
SO1.3 Solve for the unknown variables or parameters in complex engineering problems based on the derived methods from the fundamental principles of electricity and magnetism, waves,
and light and optics.
Part II. Problem Solving (A). (5pts each) Show detailed solution to get a full mark
Refer to the given circuit as shown in the figure for problems (A1–A2):
Part III. Use the information in the figure below. Show your detailed solution to get a full mark
III(a) 10pts Of what material is a wire made, if it is 5.0 m long with a diameter of 2.053 mm and has a resistance of 0.025 Ω at 0°C?
Formulate your answer by completing the table. (Use provided answer sheet)
III(b) 5pts Determine the temperature of the field winding of a series motor if it is constructed from the material in III(a) when its resistance had
increased to 240 Ω after running for 2 hours.
S.Y 2nd Sem 2022- QUIZ
05/12/2023
PART I
NAME:_______________________________ 1.
SECTION:____________________________ 2.
3. PART II
SET:_________________________________ 4. A1.
5. A2.
ANSWER SHEET/SOLUTION PAPER 6. A3
Summary: (Strictly no erasures) 7. A4.
8. A5.
9.
10.
SOLUTION PART II
S.Y 2nd Sem 2022- QUIZ
05/12/2023
NAME:
SOLUTION PART III