0% found this document useful (0 votes)
4K views2 pages

DC - Blue - PLUS Programming

This document provides instructions for programming a remote control into the receiver of a DC BLUE PLUS garage door opener. The steps are: 1) Press and hold the button on the remote to be programmed 2) Short the middle programming pin to either the BT pin for open/close operation or LT pin for courtesy light operation 3) Remove the short once confirmation beeps are heard from the onboard buzzer 4) Release the remote button. The receiver LED will light to indicate if programming was successful or if memory is full.

Uploaded by

G
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
4K views2 pages

DC - Blue - PLUS Programming

This document provides instructions for programming a remote control into the receiver of a DC BLUE PLUS garage door opener. The steps are: 1) Press and hold the button on the remote to be programmed 2) Short the middle programming pin to either the BT pin for open/close operation or LT pin for courtesy light operation 3) Remove the short once confirmation beeps are heard from the onboard buzzer 4) Release the remote button. The receiver LED will light to indicate if programming was successful or if memory is full.

Uploaded by

G
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

How to program a remote into your:

DC BLUE PLUS

RX LED

RX programming pins

ET BLUE Compatible with both the ET BLU MIX


ET Blue and ET BLU MIX ranges of remotes

(NB. The ET BLU MIX remote button must be set to the


old ET Blue code for use on this motor)

Learning a remote transmitter button in the receiver for open/close operation: -


(25 user memory)
Action Pictorial confirmation Response

Press and hold the required remote


RX LED flickers lightly.
transmitter button

On board buzzer beeps


confirmation.
Short circuit the middle RX
1 Beep = First transmitter learnt.
programming pin to the BT pin.
2 Beeps = Successful there is still
memory available.
10 Beeps = memory full.

Remove the short circuit once the


RX LED remains lit in standby.
buzzer beeps confirmation.

Release remote transmitter button


How to program a remote into your:
DC BLUE PLUS

Learning a remote transmitter button in the receiver for courtesy light operation: -
(6 user memory)
Action Pictorial confirmation Response

Press and hold the required remote


RX LED flickers lightly.
transmitter button

On board buzzer beeps


confirmation.
Short circuit the middle RX
1 Beep = First transmitter learnt.
programming pin to the LT pin.
2 Beeps = Successful there is still
memory available.
10 Beeps = memory full.

Remove the short circuit once the


RX LED remains lit in standby.
buzzer beeps confirmation.

Release remote transmitter button

You might also like