Scribd
Upload
25 views

Project LCD Arduino Uno R3 in Tinkercad

This document provides instructions for connecting an LCD display to an Arduino Uno R3 board using a breadboard. It lists the components needed, describes connecting the LCD data lines and control pins to specific Arduino pins via a breadboard, and mentions adding code to display on the LCD.

Uploaded by

Rafly Ahmad
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
25 views

Project LCD Arduino Uno R3 in Tinkercad

This document provides instructions for connecting an LCD display to an Arduino Uno R3 board using a breadboard. It lists the components needed, describes connecting the LCD data lines and control pins to specific Arduino pins via a breadboard, and mentions adding code to display on the LCD.

Uploaded by

Rafly Ahmad
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Project LCD Arduino Uno R3 in Tinkercad

a. Komponen yang digunakan : Arduino Uno R3, Breadboard, LCD

b. Tambahkan juga Resistor dan setting

c. Klik untuk Pemilihan warna kabel

d. Sambungkan kabel dan tambahkan Potentiometer


- Breadboard (+) ke Breadboard (+) warna kabel merah
- Breadboard (-) ke Breadboard (-) warna kabel hitam
- LED Catodhe (lcd) ke Breadboard (-) warna kabel hitam
- LED Anode (lcd) ke Breadboard (h) warna kabel coklat
- DB7 (lcd) ke Breadboard (f) warna kabel ungu dan Breadboard (g) ke Arduino pin 2
- DB6 (lcd) ke Breadboard (f) warna kabel biru dan Breadboard (g) ke Arduino pin 3
- DB5 (lcd) ke Breadboard (f) warna kabel biru muda dan Breadboard (g) ke Arduino pin 4
- DB4 (lcd) ke Breadboard (f) warna kabel hijau ke Arduino pin 5
- LCD enable ke Breadboard (f) warna kabel kuning dan Breadboard (j) ke Arduino pin 11
- LCD read/write ke Breadboard (-) warna kabel hitam
- LCD register ke Breadboard (f) warna kabel orange dan Breadboard (j) ke Arduino pin 12
- LCD contras ke Breadboard (b) potentiometer (tengah) warna kabel ungu
- LCD power ke Breadboard (+) warna kabel merah
- LCD ground ke Breadboard (-) potentiometer sisi kanan
- Breadboard (+) ke Breadboard (a) warna kabel merah
- Breadboard (+) ke Arduino 5v warna kabel merah
- Breadboard (-) ke Arduino gnd warna kabel hitam
e. Ganti code

f. Hasilnya

You might also like