Intra Projects Push_swap Edit 3/11/18, 7(03 PM

0
 search...   rnugroho

(https://profile.intra.42.fr)

SCALE FOR PROJECT PUSH_SWAP

(/PROJECTS/PUSH_SWAP)
You should correct 1 student in this team


Git repository

[email protected]:intra/2018/activities/push_swa


Introduction
Please respect the following rules:

- Remain polite, courteous, respectful and constructive

throughout the correction process. The well-being of the community
depends on it.

- Identify with the person (or the group) graded the eventual
dysfunctions of the work. Take the time to discuss
and debate the problems you have identified.

- You must consider that there might be some difference in how your
peers might have understood the project's instructions and the
scope of its functionalities. Always keep an open mind and grade
him/her as honestly as possible. The pedagogy is valid only and
only if peer-evaluation is conducted seriously.

Guidelines
- Only grade the work that is in the student or group's
GiT repository.

- Double-check that the GiT repository belongs to the student

or the group. Ensure that the work is for the relevant project
and also check that "git clone" is used in an empty folder.

- Check carefully that no malicious aliases was used to fool you

and make you evaluate something other than the content of the
official repository.

- To avoid any surprises, carefully check that both the correcting

and the corrected students have reviewed the possible scripts used
to facilitate the grading.

https://projects.intra.42.fr/scale_teams/1123754/edit Page 1 of 7
Intra Projects Push_swap Edit 3/11/18, 7(03 PM

- If the correcting student has not completed that particular

project yet, it is mandatory for this student to read the
entire subject prior to starting the defence.

- Use the flags available on this scale to signal an empty repository,

non-functioning program, a norm error, cheating etc. In these cases,
the grading is over and the final grade is 0 (or -42 in case of
cheating). However, with the exception of cheating, you are
encouraged to continue to discuss your work (even if you have not
finished it) in order to identify any issues that may have caused
this failure and avoid repeating the same mistake in the future.

Attachments
 Sujet
(https://cdn.intra.42.fr/pdf/pdf/650/push_swap.fr.pdf)

 Subiect
(https://cdn.intra.42.fr/pdf/pdf/651/push_swap.ro.pdf)

 Subject
(https://cdn.intra.42.fr/pdf/pdf/944/push_swap.en.pdf)

Mandatory part
Reminder : Remember that for the duration of the defence, no segfault, nor
other unexpected, premature, uncontrolled or unexpected termination of the
program, else the final grade is 0. Use the appropriate flag. This rule is
active thoughout the whole defence.

Author file
Check that the author file is at the root of the repository
and formatted as explained in the subject. If not defence is
finished and final grade is 0.

 Yes  No

Memory leaks
Throughout the defence, pay attention to the amount of memory
used by push_swap (using the command top for example) in order
to detect any anomalies and ensure that allocated memory is
properly freed. If there is one memory leak (or more), the final
grade is 0.

 Yes  No

https://projects.intra.42.fr/scale_teams/1123754/edit Page 2 of 7
Intra Projects Push_swap Edit 3/11/18, 7(03 PM

Checker program - Error management

In this section, we'll evaluate the checker's error management.
If at least one fails, no points will be awarded for this
section. Move to the next one.

- Run checker with non numeric parameters. The program

must display "Error".

- Run checker with a duplicate numeric parameter. The

program must display "Error".

- Run checker with only numeric parameters including one

greater than MAXINT. The program must display "Error".

- Run checker without any parameters. The program must

not display anything and give the prompt back.

- Run checker with valid parameters, and write an action that

doesn't exist during the instruction phase. The program must
display "Error".

- Run checker with valid parameters, and write an action with

one or several spaces before and/or after the action during
the instruction phase. The program must display "Error".

 Yes  No

Checker program - False tests

In this section, we'll evaluate the checker's ability to manage
a list of instructions that doesn't sort the list. Execute the
following 2 tests. If at least one fails, no points will be awarded
for this section. Move to the next one.

Don't forget to press CTRL+D to stop reading during the

intruction phase.

- Run checker with the following command "$>./checker 0 9 1 8 2

7 3 6 4 5" then write the following valid action list
"[sa, pb, rrr]". Checker should display "KO".

- Run checker with a valid list as parameter of your choice then

write a valid instruction list that doesn't order the integers.
Checker should display "KO". You'll have to specifically check
that the program wasn't developed to only answer correctly
on the test included in this scale. You should repeat this
test couple of times with several permutations before you
validate it.

https://projects.intra.42.fr/scale_teams/1123754/edit Page 3 of 7
Intra Projects Push_swap Edit 3/11/18, 7(03 PM

 Yes  No

Checker program - Right tests

In this section, we'll evaluate the checker's ability to manage
a liss of instructions that sort the list. Execute the
following 2 tests. If at least one fails, no points will
be awarded for this section. Move to the next one.

Don't forget to press CTRL+D to stop reading during the

instruction phase.

- Run checker with the following command "$>./checker 0 1 2"

then press CTRL+D without writing any instruction. The
program should display "OK".

- Run checker with the following command "$>./checker 0 9 1

8 2" then write the following valid action list
"[pb, ra, pb, ra, sa, ra, pa, pa]". The program should
display "OK".

- Run checker with a valid list as parameter of your choice then

write a valid instruction list that order the integers.
Checker must display "OK". You'll have to specifically check
that the program wasn't developed to only answer correctly
on the test included in this scale. You should repeat this
test couple of times with several permutations before you
validate it.

 Yes  No

Push_swap - Identity test

In this section, we'll evaluate push_swap's behavior when
given a list, which has already been sorted. Execute the
following 3 tests. If at least one fails, no points will be
awarded for this section. Move to the next one.

- Run the following command "$>./push_swap 42". The program

should display nothing (0 instruction).

- Run the following command "$>./push_swap 0 1 2 3". The

program should display nothing (0 instruction).

- Run the following command "$>./push_swap 0 1 2 3 4 5 6

7 8 9". The program should display nothing (0 instruction).

 Yes  No

https://projects.intra.42.fr/scale_teams/1123754/edit Page 4 of 7
 Intra Projects Push_swap Edit 3/11/18, 7(03 PM

Push_swap - Simple version

If the following test fails, no points will be awarded
for this section. Move to the next one.

- Run "$>ARG="2 1 0"; ./push_swap $ARG | ./checker $ARG".

Check that the checker program displays "OK" and that
the size of the list of instructions from push_swap is
2 OR 3. Otherwise the test fails.

 Yes  No

Another simple version

Execute the following 2 tests. If at least one fails,
no points will be awarded for this section. Move to
the next one.

- Run "$>ARG="1 5 2 4 3"; ./push_swap $ARG | ./checker

$ARG". Check that the checker program displays "OK"
and that the size of the list of instructions from
push_swap isn't more than 12. Kudos if the size of
the list of instructions is 8.

- Run "$>ARG="<5 random values>"; ./push_swap $ARG |

 Menu ./checker $ARG" and replace the placeholder by 5 random
valid values. Check that the checker program displays
//profile.intra.42.fr)
 My projects (/) "OK" and that the size of the list of instructions
from push_swap isn't more than 12. Otherwise this test
  All projects (/projects/graph)
fails. You'll have to specifically check that the program
//projects.intra.42.fr)
 List projects (/projects/list) wasn't developed to only answer correctly on the test
included in this scale. You should repeat this test
  Available Cursus couple of times with several permutations before you
(/cursus_subscriptions) validate it.
/elearning.intra.42.fr)
Your projects
 Yes  No

 Push_swap
://forum.intra.42.fr)
(/projects/push_swap) Push_swap - Middle version
  Savoir Relier (/projects/savoir- If the following test fails, no points will be awarded
for this section. Move to the next one.
/companies.intra.42.fr)
relier)

- Run "$>ARG="<100 random values>"; ./push_swap $ARG |

 ./checker $ARG" and replace the placeholder by 100 random
s://meta.intra.42.fr) valid values. Check that the checker program displays
"OK" and then give a grade based on the size of the list
 of instructions:
- Less than 700: 5
s://shop.intra.42.fr) - Less than 900: 4
- Less than 1100: 3

https://projects.intra.42.fr/scale_teams/1123754/edit Page 5 of 7
Intra Projects Push_swap Edit 3/11/18, 7(03 PM

- Less than 1300: 2

- Less than 1500: 1

You'll have to specifically check that

the program wasn't developed to only answer correctly
on the test included in this scale. You should repeat
this test couple of times with several permutations
before you validate it.

Rate it from 0 (failed) through 5 (excellent)

Push_swap - Advanced version

If the following test fails, no points will be awarded
for this section. Move to the next one.

- Run "$>ARG="<500 random values>"; ./push_swap $ARG |

./checker $ARG" and replace the placeholder by 500
random valid values (One is not called John/Jane Script
for nothing) Check that the checker program displays "OK"
and then give a grade based on the size of the list
of instructions:
- Less than 5500: 5
- Less than 7000: 4
- Less than 8500: 3
- Less than 10000: 2
- Less than 11500: 1

Otherwise this test fails.

You'll have to specifically check that the program
wasn't developed to only answer correctly on the
test included in this scale. You should repeat this
test couple of times with several permutations
before you validate it.

Rate it from 0 (failed) through 5 (excellent)

Bonus
Reminder : Remember that for the duration of the defence, no segfault, nor
other unexpected, premature, uncontrolled or unexpected termination of the
program, else the final grade is 0. Use the appropriate flag. This rule is
active throughout the whole defence. We will look at your bonuses if and
only if your mandatory part is EXCELLENT. This means that you must

https://projects.intra.42.fr/scale_teams/1123754/edit Page 6 of 7
Intra Projects Push_swap Edit 3/11/18, 7(03 PM

complete the mandatory part, beginning to end, and your error

management needs to be flawless, even in cases of twisted or bad usage. So
if the mandatory part didn't score all the point during this defence bonuses
will be totally IGNORED.

Some bonuses
To deserve being considered as such, a bonus must be:
- Useful (you will judge for yourself), no need to exaggerate.
- Well done
- Operational, it cannot generate any errors.

ex: -v to display the stacks during processing, -c to display

with colours, etc...

Rate it from 0 (failed) through 5 (excellent)

Ratings
Don’t forget to check the flag corresponding to the defense

 Ok  Outstanding project

 Empty work  Incomplete work  No author file

W Invalid compilation  Norme  Cheat

d Crash  Leaks

Conclusion
Leave a comment on this evaluation

Finish evaluation

https://projects.intra.42.fr/scale_teams/1123754/edit Page 7 of 7