Iso 20652 2006
Iso 20652 2006
Iso 20652 2006
STANDARD 20652
First edition
2006-02-01
Reference number
ISO 20652:2006(E)
© ISO 2006
ISO 20652:2006(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2006
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail [email protected]
Web www.iso.org
Published in Switzerland
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 20652 was prepared by Technical Committee ISO/TC 20, Aircraft and space vehicles,
Subcommittee SC 13, Space data and information transfer systems.
iTeh STANDARD PREVIEW
ISO 20652 was prepared by the Consultative Committee for Space Data Systems (CCSDS)
(as CCSDS 651.0-B-1, May 2004) and was adopted (without modifications except those stated in Clause 2 of
(standards.iteh.ai)
this International Standard) by Technical Committee ISO/TC 20, Aircraft and space vehicles,
Subcommittee SC 13, Space data and information transfer systems.
ISO 20652:2006
https://standards.iteh.ai/catalog/standards/sist/d3377532-84d3-4e35-bc73-
25334730e725/iso-20652-2006
1 Scope
This International Standard identifies, defines and provides structure to the relationships and interactions
between an information producer and an archive. This International Standard defines the methodology for the
structure of actions that are required from the initial time of contact between the producer and the archive until
the objects of information are received and validated by the archive. These actions cover the first stage of the
ingest process as defined in the open archival information system (OAIS) reference model (see ISO 14721).
This International Standard describes parts of the functional entities administration (‘negotiate submission
agreement’) and ingest (‘receive submission’ and ‘quality assurance’).
The scope and field of application are furthermore detailed in subclauses 1.1 and 1.2 of the enclosed CCSDS
publication.
2 Requirements
iTeh STANDARD PREVIEW
(standards.iteh.ai)
Requirements are the technical recommendations made in the following publication (reproduced on the
following pages), which is adopted as an International Standard:
ISO 20652:2006
https://standards.iteh.ai/catalog/standards/sist/d3377532-84d3-4e35-bc73-
CCSDS 651.0-B-1, May 2004, Producer–archive interface — Methodology abstract standard.
25334730e725/iso-20652-2006
For the purposes of international standardization, the modifications outlined below shall apply to the specific
clauses and paragraphs of publication CCSDS 651.0-B-1.
Pages i to v
Page B-1
It has been agreed with the Consultative Committee for Space Data Systems that Subcommittee ISO/TC
20/SC 13 will be consulted in the event of any revision or amendment of publication CCSDS 651.0-B-1. To
this end, NASA will act as a liaison body between CCSDS and ISO.
Consultative
Committee for
Space Data Systems
RECOMMENDATION FOR SPACE
DATA SYSTEM STANDARDS
Producer-Archive Interface
Methodology
iTeh STANDARD PREVIEW
(standards.iteh.ai)
Abstract Standard
ISO 20652:2006
https://standards.iteh.ai/catalog/standards/sist/d3377532-84d3-4e35-bc73-
25334730e725/iso-20652-2006
CCSDS 651.0-B-1
BLUE BOOK
May 2004
AUTHORITY
This document has been approved for publication by the Management Council of the
Consultative Committee for Space Data Systems (CCSDS) and reflects the consensus of
technical panel experts from CCSDS Member Agencies. The procedure for review and
authorization of CCSDS Reports is detailed in the Procedures Manual for the Consultative
Committee for Space Data Systems.
STATEMENT OF INTENT
The Consultative Committee for Space Data Systems (CCSDS) is an organization officially
established by the management of member space Agencies. The Committee meets
periodically to address data systems problems that are common to all participants, and to
formulate sound technical solutions to these problems. Inasmuch as participation in the
CCSDS is completely voluntary, the results of Committee actions are termed
Recommendations and are not considered binding on any Agency.
This Recommendation is issued by, and represents the consensus of, the CCSDS Plenary
body. Agency endorsement of this Recommendation is entirely voluntary. Endorsement,
however, indicates the following understandings:
– Whenever an Agency establishes a CCSDS-related standard, this standard will be in
accord with the relevant Recommendation. Establishing such a standard does not
preclude other provisions which an Agency may develop.
– Whenever an Agency establishes a CCSDS-related standard, the Agency will provide
other CCSDS member Agencies with the following information:
• The standard itself.
•
iTeh STANDARD PREVIEW
The anticipated date of initial operational capability.
•
(standards.iteh.ai)
The anticipated duration of operational service.
– Specific service arrangements are made ISO 20652:2006
via memoranda of agreement. Neither this
https://standards.iteh.ai/catalog/standards/sist/d3377532-84d3-4e35-bc73-
Recommendation nor any ensuing standard is a substitute for a memorandum of
25334730e725/iso-20652-2006
agreement.
No later than five years from its date of issuance, this Recommendation will be reviewed by
the CCSDS to determine whether it should: (1) remain in effect without change; (2) be
changed to reflect the impact of new technologies, new requirements, or new directions; or,
(3) be retired or canceled.
In those instances when a new version of a Recommendation is issued, existing
CCSDS-related Agency standards and implementations are not negated or deemed to
be non-CCSDS compatible. It is the responsibility of each Agency to determine
when such standards or implementations are to be modified. Each Agency is,
however, strongly encouraged to direct planning for its new standards and
implementations towards the later version of the Recommendation.
FOREWORD
The purpose of this Recommendation is to identify, define and provide structure to the
relationships and interactions between an information Producer and an Archive.
http://www.ccsds.org/
Questions relating to the contents or status of this report should be addressed to the CCSDS
Secretariat at the address on page i.
At time of publication, the active Member and Observer Agencies of the CCSDS were:
Member Agencies
DOCUMENT CONTROL
CONTENTS
Section
1 INTRODUCTION.......................................................................................................... 1-1
1.1 PURPOSE AND SCOPE........................................................................................ 1-1
1.2 APPLICABILITY................................................................................................... 1-1
1.3 RATIONALE.......................................................................................................... 1-2
1.4 CONFORMANCE.................................................................................................. 1-2
1.5 DOCUMENT STRUCTURE ................................................................................. 1-3
1.6 DEFINITIONS........................................................................................................ 1-4
1.7 APPLICABLE REFERENCES .............................................................................. 1-7
2 AN OVERVIEW OF THE PRODUCER-ARCHIVE INTERFACE
METHODOLOGY ........................................................................................................ 2-1
2.1 THOSE INVOLVED AND THEIR RELATIONSHIPS........................................ 2-1
2.2 THE PRODUCER-ARCHIVE PROJECT ............................................................. 2-3
2.3 THE PHASES......................................................................................................... 2-3
3 DETAILED DESCRIPTION OF PHASES................................................................. 3-1
3.1 PRELIMINARY PHASE ....................................................................................... 3-1
3.2 FORMAL DEFINITION PHASE ........................................................................ 3-17
3.3 TRANSFER PHASE ............................................................................................ 3-32
iTeh STANDARD PREVIEW
3.4 VALIDATION PHASE........................................................................................ 3-34
4 CREATING A PRODUCER-ARCHIVE INTERFACE METHODOLOGY
(standards.iteh.ai)
COMMUNITY STANDARD FROM THE PRODUCER-ARCHIVE INTERFACE
METHODOLOGY ABSTRACT STANDARD .......................................................... 4-1
ISO 20652:2006
4.1 PURPOSE............................................................................................................... 4-1
https://standards.iteh.ai/catalog/standards/sist/d3377532-84d3-4e35-bc73-
4.2 EXAMPLES OF CREATORS OF PRODUCER-ARCHIVE INTERFACE
25334730e725/iso-20652-2006
METHODOLOGY COMMUNITY STANDARDS .............................................. 4-1
4.3 PHASES FOR DEVELOPING A COMMUNITY PRODUCER-ARCHIVE
INTERFACE STANDARD.................................................................................... 4-2
4.4 BEST PRACTICES FOR CREATING A COMMUNITY STANDARD ............. 4-3
Figure
Table