Scribd
Upload
39 views

Assignment 06 Multiview Orthographic Projection

The document provides instructions for sketching objects using different projection methods and matching surface letters and numbers between pictorial and multiview drawings. Students are asked to sketch orthographic views of specific objects showing problems per sheet of paper.

Uploaded by

Umer Majeed
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
39 views

Assignment 06 Multiview Orthographic Projection

The document provides instructions for sketching objects using different projection methods and matching surface letters and numbers between pictorial and multiview drawings. Students are asked to sketch orthographic views of specific objects showing problems per sheet of paper.

Uploaded by

Umer Majeed
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 5

Roll # and Name:

CLO 3 Assignment No 06
1. Sketch the objects shown using isometric, oblique, and one- or two-point perspective.

2. Draw the necessary orthographic views.

Safety Key (inches)


Parallel block (Metric)

Angle stop (inches)


3. In the table, match the given surface letter from the pictorial drawing with the corresponding surface
number from the multiview drawing for each view.
4. Multiview Sketching Problems. Sketch necessary orthographic views on graph paper or plain paper,
showing either one or two problems per sheet. These exercises are designed to fit on 8.5” × 11” size A
or metric A4 paper. The units shown may be either .500” and .250” or 10 mm and 5 mm. All holes are
through holes.

You might also like