EPON system 1. Overview HA7200 series ONU (Optical Network Unit) includes three types--HA7200HA7200G and HA7200D.

The main difference among them is the type of auto-adaptive Ethernet port: HA7200 has a 10/100Mbps oneHA7200G has a 10/100/1000M one and HA7200D has both. Each type has outside power supply and inside power supply, for the conveniences of users. Following is the instruction of using: part 2 for HA7200, part 3 for HA7200G and part 4 for HA7200D. Part 5 is the sketch map of the connection of EPON equipments. 2. HA7200 ONU 2.1 checklists Before you start installing the ONU, please verify the package if it contains the following: --HA7200 ONU --AC-DC power adapter (outside power) or AC/DC power line (inside power) --users manual Please notify your supplier immediately if any of the aforementioned items is missing or damaged. 2.2 Installing HA7200 ONU 2.2.1 Structure of front panel HA7200 (outside power)

Figure 2-1 front panel of HA7200 ONU (outside power)

HA7200 (inside power)

Figure2-2 front panel of HA7200 ONU (inside power) Introduction of the ports (outside power) NO A B C NAME 10/100Base-TX 1000Base-X RESET FUNCTION RJ45 interface, is a 10/100M auto-adaptive electrical interfaceconnected with twisted pair. SC type interfaceis a 1000M PON portconnected to ODN (optical division network) through single-mode fiber. RESET key-pressfor the system to restart

Introduction of the ports (inside power) NO A B C D E NAME 10/100Base-TX 1000Base-X RESET Power line port Mains switch FUNCTION RJ45 interfaceis a 10/100M auto-adaptive electrical interfaceconnected with twisted pair. SC type interfaceis a 1000M PON portconnected to ODN (optical division network) splitter through single-mode fiber RESET key-press, for the system to restart A port for AC220V power line to insert in Switch of power supply condition

HA7200 LED description: LED PWR LINK/ACT Color Green Green Function Lit, when power supply works Lit, TP (twisted pair) connection is good; Blink, TP data is transmitting; 100M LINK LLID Green Green Green Off, TP is disconnected. Lit, TX speed is 100M; Blink, 10/100Base-TX interface is not connected with 100M network Blinkno fiber connection; offfiber connection is good. BlinkONU is applying for register from OLT Litregister successfully Offfiber connection is abnormal 2.2.2 Back panel of HA7200 ONU HA7200 (outside power)

5VDC

Figure 2-3 HA7200 ONU back panel (outside power) Ainput power: outside power DC5V / 1A HA7200 (inside power)
48V 0V GND

DC-36V~-72V

Figure 2-4 HA7200 ONU back panelinside power Ainput power: inside power DC-48V Notice: For the ONU with inside power, we supply AC220V and DC-48V, you can choose from these two types. 2.3 Technical Specifications Operation Wavelength Max transmission distance MAC Table Buffer space Number of LLID MTBF Support EPON trait Function support 1310RX/1490TX 20 km 64 1.25MB 18 (for configure) 1 00,000 hours Support IEEE802.3ah Support Dynamic Bandwidth Allocation(DBA) Support ONU auto-searching and automatic allocation Support Protocols (real-time operation) Support IEEE 802.3IEEE802.3uIEEE802.3ab Support IEEE802.1q WLAN Network management Support IEEE802.1p QOS Cooperated with OLT, implement management configuration and software upgrade of ONU 2.4 Physical parameters
3

Parameter Power Module Power consumption Operating temperature Storage temperature Humidity Dimension

Specification DC5V (outside) or AC220V/DC-48V (inside) 3.5W -1055 -4070 590 non-condensing 26mm(H)*109mm(W)*152mm(D)/ (outside power) 38mm(H)*218mm(W)*176mm(D)/ (inside power)

2.5 Parameters of the optical power Bit rate 1250 Output and input PECL Overload(dBm) >= -3.0 Emitting 1310 wavelength(nm) Operating 0~+70 temperature NO. Sensitivity(<= -26dBm) S407080031 S407080012 3. HA7200G ONU 3.1 checklists PASS PASS

Operating voltage(V) Extinction ratio(dB) Spectral width Receiving wavelength(nm) Storage temperature Loss of signal (SD Assert:<= -26.5dBm (SD Deassert:>= -42.0dBm PASS/ PASS PASS/ PASS

+3.3 >=10 <3.0 1490 -40-+85 Output Power(dBm) 0.6 0.9

Before you start installing the ONU, please verify the package if it contains the following: --HA7200G ONU --AC-DC power adapter (outside power) or AC/DC power line (inside power) --users manual Please notify your supplier immediately if any of the aforementioned items is missing or damaged.

3.2 Installing HA7200G ONU 3.2.1 Structure of front panel HA7200G (outside power)

Figure 3-1 front panel of HA7200G ONUoutside power HA7200G (inside power)

Figure 3-2 front panel of HA7200G ONUinside power Introduction of the ports (outside power) NO A B C NAME 10/100/1000Base-T 1000Base-X RESET FUNCTION RJ45 interface, is a 10/100/1000M auto-adaptive electrical interfaceconnected with twisted pair. SC type interface, is a 1000M PON port, connected to ODN (optical division network) splitter through single-mode fiber. RESET key-press, for the system to restart

Introduction of the ports (inside power) NO A B C D E NAME 10/100/1000Base-T 1000Base-X RESET Power line port Mains switch FUNCTION RJ45 interface, is a 10/100/1000M auto-adaptive electrical interface, connected with twisted pair. SC type port, a 1000M PON port, connected to ODN (optic division network) through single-mode fiber. RESET key-press, a press for the system to restart A port for AC220V power line to insert in Switch of power supply condition

HA7200G LED description LED PWR 100 COLOR green green FUNCTION Lit, power supply worksoff, power supply doesnt work Lit, TP speed is 100Mbps Off, 10/100/1000Base-TX interface is not connected with 100M ACT 1000 green green network Blink, TP data is transmitting Off, no TP data is transmitting Lit, TP speed is 1000Mbps Off, 10/100/100Base-TX interface is not connected with 1000M LINK LLID green green network Blink, no fiber connection; off, fiber connection is good BlinkONU is applying for register from OLT Litregister successfully
5

Offfiber connection is abnormal 3.2.2 Structure of back panel of HA7200G ONU It is the same of HA7200. Refer to figure 2-3 and 2-4. 3.3 Technical Specifications Operation Wavelength Max transmission distance MAC Table Buffer space Number of LLID MTBF Support EPON traits Function support 1310RX/1490TX 20 km 64 1.25MB 18 (for configure) 1 100,000 hours Support IEEE802.3ah Support Dynamic Bandwidth Allocation(DBA) Support ONU auto-searching and automatic allocation Support Protocols (real-time operation) Support IEEE 802.3IEEE802.3uIEEE802.3ab Support IEEE802.1q WLAN Network management Support IEEE802.1p QOS Cooperated with centre OLT, implement management configuration and software upgrade of ONU 3.4 Physical parameters Parameter Power Module Power consumption operating temperature Storage temperature Humidity Dimension Specification DC5V (outside) or AC220V/DC-48V (inside) 3.5W -1055 -4070 590 non-condensing 26mm(H)*109mm(W)*152mm(D)/(outside power) 38mm(H)*218mm(W)*176mm(D)/(inside power) 3.4 Parameters of the optical power Bit rate 1250 Output and input PECL Overload(dBm) >= -3.0 Emitting 1310 wavelength(nm) Operating 0~+70 temperature NO. Sensitivity(<= -26dBm) S407080031 S407080012 PASS PASS

Operating voltage(V) Extinction ratio(dB) Spectral width Receiving wavelength(nm) Storage temperature Loss of signal (SD Assert:<= -26.5dBm (SD Deassert:>= -42.0dBm PASS/ PASS PASS/ PASS

+3.3 >=10 <3.0 1490 -40-+85 Output Power(dBm) 0.6 0.9

4. HA7200D ONU 4.1 checklists

Before you start installing the ONU, please verify the package if it contains the following: --HA7200D ONU --AC-DC power adapter (outside power) or AC/DC power line (inside power) --users manual Please notify your supplier immediately if any of the aforementioned items is missing or damaged. 4.2 Installing HA7200D ONU 4.2.1 Structure of front panel HA7200D (outside power)

Figure 4-1 front panel of HA7200D ONUoutside power

HA7200D (inside power)

Figure 4-2 front panel of HA7200D ONUinside power Introduction of the ports (outside power) NO A B C NAME 10/100/1000Base-T 10/100Base-TX 1000Base-X FUNCTION RJ45 interfaceis a 10/100/1000M auto-adaptive electrical interfaceconnected with twisted pair. RJ45 interface, is a 10/100M auto-adaptive electrical interface SC type interfaceis a 1000M PON portconnected to

ODN (optical division network) splitter through single-mode D RESET fiber. RESET key-pressfor the system to restart

Introduction of the ports (outside power) NO A B C D E F NAME 10/100/1000Base-T 10/100Base-TX 1000Base-X RESET Power line port Mains switch FUNCTION RJ45 interfaceis a 10/100/1000M auto-adaptive electrical interfaceconnected with twisted pair. RJ45 interface,10/100M auto-adaptive electrical interface SC type interface, a 1000M PON port, connected to ODN (optical division network) splitter through single-mode fiber. RESET key-pressa press for the system to restart A port for AC220V power line to insert in Switch of power supply condition

HA7200D LED description LED PWR 100 COLOR green green FUNCTION Lit, power supply worksoff, power supply doesnt work Lit, TP speed is 100Mbps Off, 10/100/1000Base-TX interface is disconnected with 100M ACT 1000 green green network Blink, TP data is transmitting Off, no TP data is transmitting Lit, TP speed is 1000Mbps Off, 10/100/100Base-TX interface is disconnected with 1000M LINK/ACT green network Lit, TP connection of 10/100Base-TX interface is good Blink, TP data of 10/100Base-TX interface is transmitting10/100BaseTX 100M LINK LLID green green green Off, no TP connection Link, TP speed is 100Mbps Off, 10/100Base-TX interface is disconnected with 100M network Blink, no fiber connection; off, fiber connection is good BlinkONU is applying for register from OLT Litregister successfully Offfiber connection is abnormal 4.2.2 Structure of back panel of the HA7200D ONU It is the same with HA7200. Refer to figure 2-3 and 2-4. 4.3 Technical Specifications Operation Wavelength Max transmission distance MAC Table Buffer space Function support 1310RX/1490TX 20 km 64 1.25MB
8

Number of LLID MTBF Support EPON traits

18 (for configure) 1 100,000 hours Support IEEE802.3ah Support Dynamic Bandwidth Allocation(DBA) Support ONU auto-searching and automatic allocation (real-time operation) Support IEEE 802.3IEEE802.3uIEEE802.3ab Support IEEE802.1q WLAN Support IEEE802.1p QOS Cooperated with centre OLT, implement management configuration and software upgrade of ONU

Support Protocols

Network management

4.4 Physical parameters Parameter Power Module Power consumption operating temperature Storage temperature Humidity Dimension Specification DC5V (outside) or AC220V/DC-48V (inside) 3.5W -1055 -4070 590 non-condensing 26mm(H)*109mm(W)*152mm(D)/height*width*depth (outside power) 38mm(H)*218mm(W)*176mm(D)/height*width*depth (inside power)

4.5 Parameters of the optical power Bit rate 1250 Output and input PECL Overload(dBm) >= -3.0 Emitting 1310 wavelength(nm) Operating 0~+70 temperature NO. Sensitivity(<= -26dBm) S407080031 S407080012 PASS PASS

Operating voltage(V) Extinction ratio(dB) Spectral width Receiving wavelength(nm) Storage temperature Loss of signal (SD Assert:<= -26.5dBm (SD Deassert:>= -42.0dBm PASS/ PASS PASS/ PASS

+3.3 >=10 <3.0 1490 -40-+85 Output Power(dBm) 0.6 0.9

5. Sketch map of the connection of EPON equipments Figure 5-1 is a reference picture of the connection of EPON equipments.

HA7100 OLT is an access device with rack structure, supporting maximum 8 PON systems. HA7200HA7200G and HA7200D (optional) can be connected with HA7100 OLT through ODN (built-up with all passive optical devices, such as splitters and fibers) to form a EPON system. (More details about the installing can consult with our technicians)

Figure 5-1 reference picture

10