PU Paper Manufacturing Science KME-403 - New
PU Paper Manufacturing Science KME-403 - New
PU Paper Manufacturing Science KME-403 - New
1. Attempt all parts. All parts carry equal marks. Write answer of each part in short. (20 Marks)
a. Define casting.
b. How does hot working differ from cold working?
c. What do you mean by abrasive jet machining?
d. Define upsetting and V bending?
e. What are the functions of cutting fluids?
f. Define continuous, discontinuous, and built-up chips.
g. What do you mean by forming.
h. Define punching and blanking with the help of a diagram.
i. Why is vacuum created in a electron gun?
j. What do you mean by plasma?
SECTION-B
2. Attempt any three parts from this question. All parts carry equal marks. (30 Marks)
a. With the help of a neat diagram, explain the design of a gating system by elaborating the function of each and
every part.
b. With the help of a neat diagram, explain TIG welding. Also state the differences between TIG and MIG
welding .
c. Explain powder metallurgy by elaborating the various steps involved . State its advantages, limitations, and
applications.
d. Discuss the analysis of wire drawing. Derive an expression for maximum reduction in drawing.
e. With the help of a neat diagram, explain the working of Plasma Arc Machining while elaborating the working
of each and every part . State its advantages, limitations and applications .
SECTION-C
Note: Attempt all questions from this section. All questions carry equal marks.
3. Attempt any one part of the following: (10 Marks)
(a) Explain the process of metal removal in Electrode Discharge machining and derive the volumetric material
removal rate in EDM.
(b) Explain the process of electron beam machining using a neat diagram. State its advantages, disadvantages,
and applications.
(a) Explain:
(a) With the help of a suitable diagram, explain grinding process. Also explain the meaning of grade, structure,
grit, bond, cylindrical grinding, surface grinding, centerless grinding and internal grinding
(b) Explain the three different types of grinding wheel wear. What can be done to prevent them? Differentiate
between dressing and truing.
(a) In an orthogonal cutting, the following data has been observed: rake angle = 15°, chip thickness ratio = 0.39,
uncut chip thickness t=0.6 mm , width of cut b = 3.3 mm , yield shear stress of material in shear = 280
N/mm2 , average coefficient of friction on the tool face = 0.7 . calculate the normal and tangential
components of forces on the tool face .
(a) What do you mean by deep drawing? Explain the various deep drawing operations in detail. Enlist the
various defects in deep drawing operations.
(b) With the help of suitable diagram, explain hot chamber die casting. How is it different from cold
chamber die casting.
KME-403/MS/AITM (719)