Scribd
Upload
55 views1 page

MRL Iii FS 635

This document provides specifications for a red diode laser operating at 635nm. The laser operates continuously in the CW mode, has an output power between 600-800mW, and a beam quality factor of less than 20. It has a small compact design, long expected lifetime of 10,000 hours, and 1-year warranty. The laser is suitable for applications such as measurement, spectroscopy, and laser lighting displays.

Uploaded by

Robert Kleven
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
55 views1 page

MRL Iii FS 635

This document provides specifications for a red diode laser operating at 635nm. The laser operates continuously in the CW mode, has an output power between 600-800mW, and a beam quality factor of less than 20. It has a small compact design, long expected lifetime of 10,000 hours, and 1-year warranty. The laser is suitable for applications such as measurement, spectroscopy, and laser lighting displays.

Uploaded by

Robert Kleven
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

MRL-III-FS-635/600~800mW

SPECIFICATIONS
Wavelength (nm) 635±5
Output power (mW) >600, 610, 620, … , 800
RED DIODE LASER Transverse mode Near TE00
At 635nm Operating mode CW
Power stability (rms, over 4 hours) <1%, <3%, <5%
Warm-up time (minutes) <5
M2 factor <20
Beam divergence, full angle (mrad) <2.5
Diode red laser 635nm is made features Dimensions of beam at the aperture (mm) ~5×8
of ultra compact, long lifetime, low cost and Beam height from base plate (mm) 28. 5
easy operating, which is widely used in Polarization ratio >50:1
measurement, spectrum analysis, laser Pointing stability after warm-up (mrad) <0.05
lighting show, etc. Operating temperature (℃) 10~35
Power supply (90-264VAC or 5VDC) PSU-III-LED PSU-III-FDA PSU-III-OEM

Modulation option TTL/Analog 1Hz-5KHz, 1Hz-10KHz, 1Hz-30KHz, and TTL on/off

Expected lifetime (hours) 10000


Warranty 1 year
MRL-635 is a diode laser module, so the beam quality is not as good as the
Remarks
solid-state laser at 671nm. The beam spot is nearly square.

MxL-III-FS-635 PSU-III-LED PSU-III-FDA PSU-III-OEM

136(L)×73(W) ×50(H) mm3, 0.6kg 153 (L) ×155(W) ×92 (H) mm3, 1.5kg 133 (L) ×130(W) ×65 (H) mm3, 1.2kg 100 (L) ×62(W) ×56 (H) mm3, 0.2kg

Website: http://www.eforcelaser.com.au E-mail: [email protected] Fax: 03-83954370

You might also like