PHK724 Idneng
PHK724 Idneng
PHK724 Idneng
Warning
H226 Flammable liquid and vapour.
H312 Harmful in contact with skin.
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H332 Harmful if inhaled.
H412 Harmful to aquatic life with long lasting effects.
[Prevention]:
P210 Keep away from heat / sparks / open flames / hot surfaces - No smoking.
P235 Keep cool.
P240 Ground / bond container and receiving equipment.
P241 Use explosion-proof electrical / ventilating / light / equipment.
P242 Use only non-sparking tools.
P243 Take precautionary measures against static discharge.
P260 Do not breathe mist / vapours / spray.
P261 Avoid breathing dust / fume / gas / mist / vapours / spray.
P262 Do not get in eyes, on skin, or on clothing.
P264 Wash thoroughly after handling.
P271 Use only outdoors or in a well-ventilated area.
P272 Contaminated work clothing should not be allowed out of the workplace.
P273 Avoid release to the environment.
P280 Wear protective gloves / eye protection / face protection.
[Response]:
P301+310 IF SWALLOWED: Immediately call a POISON CENTER or doctor / physician.
P302+352 IF ON SKIN: Wash with soap and water.
P303+361+353 IF ON SKIN (or hair): Remove / Take off immediately all contaminated clothing. Rinse skin
with water / shower.
P304+312 IF INHALED: Call a POISON CENTER or doctor / physician if you feel unwell.
P305+351+338 IF IN EYES: Rinse continuously with water for several minutes. Remove contact lenses if
present and easy to do - continue rinsing.
P321 Specific treatment (see information on this label).
P322 Specific measures (see information on this label).
P331 Do NOT induce vomiting.
P333+313 If skin irritation or a rash occurs: Get medical advice / attention.
P337 If eye irritation persists:
P304+340 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P362 Take off contaminated clothing and wash before reuse.
P363 Wash contaminated clothing before reuse.
P370+378 In case of fire: Use alcohol resistant foam, CO2, powder, water spray for extinction. Do not use
water jet.
[Storage]:
P403+233 Store in a well ventilated place. Keep container tightly closed.
[Disposal]:
P501 Dispose of contents / container in accordance with local / national regulations.
2.3. Other hazards
This product contains no PBT/vPvB chemicals.
3. Composition/information on ingredients
*The full texts of the Hazard (H) phrases are shown in Section 16.
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence do not
require reporting in this section.
Skin Contact
Remove contaminated clothing. Wash skin thoroughly with soap and water or use a recognised skin
cleanser. Do NOT use solvents or thinners.
Eye Contact
Irrigate copiously with clean fresh water for at least 10 minutes, holding the eyelids apart and seek medical
attention.
Ingestion
If accidentally swallowed obtain immediate medical attention. Keep at rest. Do NOT induce vomiting.
4.2. Most important symptoms and effects, both acute and delayed
No data available
4.3. Indication of any immediate medical attention and special treatment needed and notes for
physician
No data available
5. Fire-fighting measures
Note; Fire will produce dense black smoke. Decomposition products may be hazardous to health. Avoid
exposure and use breathing apparatus as appropriate.
Cool closed containers exposed to fire by spraying them with water. Do not allow run off water and
contaminants from fire fighting to enter drains or water courses.
5.2. Special hazards arising from the substance or mixture
Fire will produce dense black smoke. Decomposition products may include the following materials: carbon
monoxide, carbon dioxide, smoke, oxides of nitrogen.
Avoid exposure and use breathing apparatus as appropriate.
5.3. Advice for fire-fighters
Cool closed containers exposed to fire by spraying them with water. Do not allow run off water and
contaminants from fire fighting to enter drains or water courses.
6. Accidental release measures
Contain and absorb spillage with non-combustible materials e.g. sand, earth, vermiculite. Place in closed
containers outside buildings and dispose of according to the Waste Regulations. (See section 13).
If drains, sewers, streams or lakes are contaminated, inform the local water company immediately. In the
case of contamination of rivers, streams or lakes the Environmental Protection Agency should also be
informed.
In Storage
Handle containers carefully to prevent damage and spillage.
Naked flames and smoking should not be permitted in storage areas. It is recommended that fork lift trucks
and electrical equipment are protected to the appropriate standard.
This coating contains solvents. Solvent vapours are heavier than air and may spread along floors. Vapours
may form explosive mixtures with air. Areas of storage, preparation and application should be ventilated to
prevent the creation of flammable or explosive concentrations of vapour in air and avoid vapour
concentrations higher than the occupational exposure limits.
Smoking, eating and drinking should be prohibited in all preparation and application areas.
Never use pressure to empty a container; containers are not pressure vessels.
There are no exposure scenarios, see details in section 1.
Store on concrete or other impervious floor, preferably with bunding to contain any spillage. Do not stack
more than 3 pallets high.
Keep container tightly closed. Containers which are opened must be carefully resealed and kept upright to
prevent leakage. Keep in the original container or one of the same material.
The product may charge electrostatically. Always use earthing leads when pouring solvents and
transferring product. Operators should wear clothing which does not generate static (at least 60% natural
fibre) and antistatic footwear; floors should be of conducting type.
DNEL/PNEC values
No Data Available
Eye Protection
Wear safety eyewear, e.g. safety spectacles, goggles or visors to protect against the splash of liquids.
Eyewear should comply with an approved standard.
Wear a full face shield if mixing or pouring operations pose a risk of splashes.
Skin Protection
Gloves of an appropriate material should be worn during mixing and application.
Other
Overalls which cover the body, arms and legs should be worn. Skin should not be exposed. Barrier creams
may help to protect areas which are difficult to cover such as the face and neck. They should however not
be applied once exposure has occurred. Petroleum jelly based types such as Vaseline should not be used.
All parts of the body should be washed after contact.
Respiratory Protection
When concentrations exceed the exposure limits shown above, workers must wear appropriate approved
respirators. Provision of other controls such as exhaust ventilation should be considered if practical.
Thermal hazards
No Data Available
10.1. Reactivity
No data available
10.2. Chemical stability
Stable under recommended storage and handling conditions (see section 7). When exposed to high
temperatures may produce hazardous decomposition products such as carbon monoxide, carbon dioxide,
oxides of nitrogen and smoke.
Keep away from oxidising agents, strongly alkaline and strongly acid materials in order to avoid possible
exothermic reactions.
10.3. Possibility of hazardous reactions
May react exothermically with: oxidising agents, strong alkalis, strong acids.
10.4. Conditions to avoid
Stable under recommended storage and handling conditions (see section 7).
10.5. Incompatible materials
Keep away from the following materials: oxidising agents, strong alkalis, strong acids.
10.6. Hazardous decomposition products
Fire will produce dense black smoke. Decomposition products may include the following materials: carbon
monoxide, carbon dioxide, smoke, oxides of nitrogen.
Avoid exposure and use breathing apparatus as appropriate.
Acute toxicity
Exposure to solvent vapour concentrations from the component solvents in excess of the stated
occupational exposure limits may result in adverse health effects such as mucous membrane and
respiratory system irritation and adverse effects on the kidneys, liver and central nervous system.
Symptoms include headache, nausea, dizziness, fatigue, muscular weakness, drowsiness and in extreme
cases, loss of consciousness.
Repeated or prolonged contact with the preparation may cause removal of natural fat from the skin
resulting in dryness, irritation and possible non-allergic contact dermatitis. Solvents may also be absorbed
through the skin. Splashes of liquid in the eyes may cause irritation and soreness with possible reversible
damage.
The preparation has been assessed using the Acute Toxicity Data listed below, and classified for
toxicological hazards accordingly. See section 2 for details.
Inhalation Inhalation
Oral LD50, Skin LD50,
Ingredient Vapour LD50, Dust/Mist LD50,
mg/kg mg/kg
mg/L/4hr mg/L/4hr
1-Methoxy-2-propylacetate - (108-
65-6) 8,532.00, Rat 5,000.00, Rabbit Not Available Not Available
Xylene - (1330-20-7)
4,299.00, Rat 1,548.00, Rabbit Not Available 20.00, Rat
12.1. Toxicity
The preparation has been assessed according to the GHS criteria and is classified as dangerous for the
environment, using the toxicity data listed below.
There are no data available on the product itself.
Aquatic Ecotoxicity
Xylene - (1330-20-7)
Not Available Not Available Not Available
1-Methoxy-2-propylacetate - (108-
65-6) 100.00, Salmo 500.00, Daphnia Not Available
gairdneri magna
Using information provided in this data sheet advice should be obtained from the local Waste Regulation
Authority as to whether special waste regulations apply.
14. Transport information
Ems F-E,S-E
This product and all its components complies with the chemical and transport regulations from the country
listed in section 1.3.
Other regulatory information specific to the hazardous chemical(s):
None noted.
It is always the responsibility of the user to take all necessary steps to meet the demands of applicable
legislation.
This SDS is valid for 5 years from the revised date on page 1.
The revision date is in American format (e.g. MM/DD/YY).
End of document
All information concerning this product and/or suggestions for handling and use contained herein are
offered in good faith and are believed to be reliable. Akzo Nobel however makes no warranty as to
the accuracy of and/or sufficiency of such information.