RRV42VV-6533D-R10

20-port sector/multibeam antenna 4x 694–960 MHz , 8x 1695-2690

MHz 65° HPBW and 8x 1710–2690 MHz 2x 2-Beam 33°HPBW, 10x
RET. Band cascaded SRET

General Specifications
Antenna Type Multibeam

Band Multiband

Color Light Gray (RAL 7035)

Grounding Type RF connector inner conductor and body grounded to reflector and mounting
bracket

Performance Note Outdoor usage    |   Wind loading figures are validated by wind tunnel
measurements described in EN1991-1-4 standard

RF Connector Interface 4.3-10 Female

RF Connector Location Bottom

RF Connector Quantity, high band 16

RF Connector Quantity, low band 4

RF Connector Quantity, total 20

Remote Electrical Tilt (RET) Information

RET Hardware CommRET v2

RET Interface 8-pin DIN Female    |   8-pin DIN Male

RET Interface, quantity 2 female    |   2 male

Input Voltage 10–30 Vdc

Internal RET High band (8)    |   Low band (2)

Power Consumption, active state, maximum 8W

Power Consumption, idle state, maximum 1W

Protocol 3GPP/AISG 2.0 (Single RET)

Dimensions
Width 498 mm   |   19.606 in

Depth 197 mm   |   7.756 in

Length 2688 mm   |   105.827 in

58.6 kg   |   129.191 lb Page 1 of 4

©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: May 25, 2023
RRV42VV-6533D-R10
Net Weight, antenna only 58.6 kg   |   129.191 lb

Array Layout

Port Configuration

Electrical Specifications
Impedance 50 ohm

Operating Frequency Band 1695 – 2690 MHz    |   1710 – 2690 MHz    |   694 – 960 MHz

±45° Page 2 of 4

©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: May 25, 2023
RRV42VV-6533D-R10
Polarization ±45°

Total Input Power, maximum 1,300 W @ 50 °C

Electrical Specifications
Frequency Band, MHz 694–790 790–890 880–960 1695–19201920–21802300–26901710–19201920–21802300–2690
Gain, dBi 15.6 15.9 15.9 15.7 16.9 17.7 17.5 19 19.4
Beam Centers, Horizontal, ±27 ±27 ±27
degrees
Beamwidth, Horizontal, 71 65 63 76 67 59 37 34 28
degrees
Beamwidth, Vertical, 9.3 8.3 7.6 7.1 6.4 5.4 7.2 6.5 5.5
degrees
Beam Tilt, degrees 2–12 2–12 2–12 2–12 2–12 2–12 2–12 2–12 2–12
USLS (First Lobe), dB 17 17 16 16 16 19 16 18 20
Front-to-Back Ratio at 180°, 30 28 30 32 30 33 39 38 35
dB
Isolation, Cross 25 25 25 25 25 25 25 25 25
Polarization, dB
Isolation, Inter-band, dB 25 25 25 25 25 25 25 25 25
Isolation, Beam to Beam, dB 17 17 17
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0

PIM, 3rd Order, 2 x 20 W, -150 -150 -150 -150 -150 -150 -150 -150 -150
dBc
Input Power per Port at 50° 250 250 250 200 200 150 200 200 150
C, maximum, watts

Electrical Specifications, BASTA

Frequency Band, MHz 694–790 790–890 880–960 1695–19201920–21802300–26901710–19201920–21802300–2690
Gain by all Beam Tilts, 15.1 15.6 15.7 15.2 16.3 17.3 17 18.4 18.8
average, dBi
Gain by all Beam Tilts ±0.6 ±0.4 ±0.4 ±0.8 ±0.7 ±0.4 ±1.1 ±0.9 ±1
Tolerance, dB
Beamwidth, Horizontal ±7.9 ±9.2 ±5.4 ±6.7 ±7 ±4.5 ±3.4 ±2.3 ±3.6
Tolerance, degrees
Beamwidth, Vertical ±0.5 ±0.5 ±0.3 ±0.5 ±0.4 ±0.4 ±0.5 ±0.4 ±0.5
Tolerance, degrees
USLS, beampeak to 20° 17 16 15 14 16 14 15 15 13
above beampeak, dB
Front-to-Back Total Power 22 22 23 23 23 25 31 31 28

Page 3 of 4

©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: May 25, 2023
RRV42VV-6533D-R10
at 180° ± 30°, dB
CPR at Boresight, dB 23 22 18 19 22 23 16 20 20
CPR at Sector, dB 12 9 13 8 6 8
CPR at 10 dB Horizontal 6 11 12
Beamwidth, dB

Mechanical Specifications
Wind Loading @ Velocity, frontal 944.0 N @ 150 km/h (212.2 lbf @ 150 km/h)

Wind Loading @ Velocity, lateral 292.0 N @ 150 km/h (65.6 lbf @ 150 km/h)

Wind Loading @ Velocity, maximum 1,130.0 N @ 150 km/h (254.0 lbf @ 150 km/h)

Wind Loading @ Velocity, rear 650.0 N @ 150 km/h (146.1 lbf @ 150 km/h)

Wind Speed, maximum 241 km/h   |   149.75 mph

Packaging and Weights

Width, packed 565 mm   |   22.244 in

Depth, packed 309 mm   |   12.165 in

Length, packed 2935 mm   |   115.551 in

Weight, gross 80.4 kg   |   177.251 lb

Regulatory Compliance/Certifications
Agency Classification
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system

Included Products
BSAMNT-4 – Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members.
Kit contains one scissor top bracket set and one bottom bracket set.
BSAMNT-M4 – Middle Downtilt Mounting Kit for Long Antennas for 2.4 - 4.5 in (60 - 115 mm) OD round
members. Kit contains one scissor bracket set.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

Page 4 of 4

©2023 CommScope, Inc. All rights reserved. CommScope and the CommScope logo are registered trademarks of CommScope and/or its
affiliates in the U.S. and other countries. For additional trademark information see https://www.commscope.com/trademarks. All product names,
trademarks and registered trademarks are property of their respective owners. Revised: May 25, 2023