Scribd
Upload
89 views2 pages

Tric

This document provides guidance for conducting a toolbox talk and risk identification for a job. It instructs to 1) plan the job by breaking it into tasks, identifying hazards and controls, and assigning responsibilities; 2) conduct dynamic risk reviews as the job progresses; and 3) hold a toolbox talk covering the identified risks and controls using a TRIC discussion. It emphasizes verifying that controls are in place and pausing work if any safety checks fail.

Uploaded by

HSSE AL THAIL GROUP
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
89 views2 pages

Tric

This document provides guidance for conducting a toolbox talk and risk identification for a job. It instructs to 1) plan the job by breaking it into tasks, identifying hazards and controls, and assigning responsibilities; 2) conduct dynamic risk reviews as the job progresses; and 3) hold a toolbox talk covering the identified risks and controls using a TRIC discussion. It emphasizes verifying that controls are in place and pausing work if any safety checks fail.

Uploaded by

HSSE AL THAIL GROUP
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

TOOLBOX TALK RISK IDENTIFICATION CARD

PLANNING THE JOB DYNAMIC RISK REVIEW TOOLBOX TALK RISK IDENTIFICATION CARD
1. Check the requirements and timings
2. Check if PTW is required As the work progresses, condition change and hazards, risks Location :____________________________________
and controls must be reassessed. It is planned, at least to re-
3. Breakdown job into tasks overleaf
assess them at the following stages: TBT Leader :____________________________________
4. Ensure people required for the job are competent
and involved in the hazard identification process Date& Time :___________________________________
5. Identify and list all hazards for each task 1. __________________________________________
6. Identify and list all controls for each task Job: : _________________________________________
7. Assign a responsible person to check and ensure 2. __________________________________________
controls are in place ATTENDES
3. __________________________________________
8. Verify that controls are active and sufficient for the
1. 11.__________________
job 4. __________________________________________
9. Hold the toolbox talk using TRIC 2. 12.__________________
10. Carry out work and perform Dynamic Risk Review 5. __________________________________________
as scheduled 3. 13.__________________
*Use hazard warning sing below as reminders
CHECK POINTS 4. 14.__________________
 Does everyone have correct PPE
5. 15.__________________
 Do you all have correct tools and they are in good
condition
6. 16.__________________
 Is everyone aware of the other activities happening
 Have you discussed the Life Saving Rules 7. 17.__________________
 Have you agreed how to communicate to each
other 8. 18.__________________
 Does everyone know that if there is a shift change
or new people joining, then another TBT is 9. 19.__________________
required
10. 20.__________________
IF THE ANSWER TO ANY OF THE QUESTION IS NO,
YOUR SAFETY AND THE SAFETY OF YOUR TEAM IS AT
RISK PAUSE AND CHECK AGAIN….!
TBT LEADER: ___________________ ___________
TOOLBOX TALK RISK IDENTIFICATION CARD
JOB STEPS RISK WITH TASK CONTROL MEASURES

You might also like