0% found this document useful (0 votes)
68 views4 pages

DO880

abb

Uploaded by

sita
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
68 views4 pages

DO880

abb

Uploaded by

sita
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

DATA SHEET

DO880
System 800xA hardware selector

The DO880 is a 16 channel 24 V digital output module for single or


redundant application. The maximum continuous output current per
channel is 0.5 A. The outputs are current limited and protected
against over temperature. Each output channel consists of a current
limited and over temperature protected high side driver, EMC
protection components, inductive load suppression, output state
indication LED and an isolation barrier to the Modulebus.

Features and benefits


16 channels for 24 V d.c. current sourcing outputs in one isolated group
Redundant or single configuration
Loop monitoring, supervision of short and open load with configurable limits (see table Table 97).
Diagnostic of output switches without pulsing on outputs
Advanced on-board diagnostics
Output status indicators (activated/error)
Degraded mode for normally energized channels (supported from DO880 PR:G)
Current limitation at short circuit and over-temperature protection of switches
Fault tolerance of 1 (as defined in IEC 61508) for output drivers. For ND (Normally De-energized)
systems, outputs can still be controlled with error on output drivers
Certified for SIL3 according to IEC 61508
Certified for Category 4 according to EN 954-1.

DATA SHEET DO880 | 2019-07-25 | Copyright © 2019 ABB 1


General info
Type Digital Output
Signal specification 24 V d.c. (19.2 - 32 V d.c.), 0.5 A
Article number 3BSE028602R1
Number of channels 16
Signal type Current sourcing, current limiting
HART No
SOE No
Redundancy Yes
High integrity Yes
Intrinsic safety No
Mechanics S800

Detailed data
Isolation Groupwise isolated from ground
Current limiting Short circuit proof current limited output
Maximum field cable length 600 meters (656 yards)
Rated insulation voltage 50 V
Dielectric test voltage 500 V a.c.
Power dissipation 5.6 W (0,5 A x 16 channels)
Current consumption +5 V Modulebus 45 mA
Current consumption +24 V Modulebus Max. 50 mA
Current consumption +24 V external 10 mA

Diagnostics
Front LED’s F(ault), R(un), W(arning), Channel 1-16 Status/Error
Process power per channel

Supervision Loop supervision configurable for loop resistance from 50 Ω to 2 kΩ


dependent of configuration and mode of operation

Internal circuitry
Status indication of supervision Module Error, Module Warning, Internal channel error

Environment and certification


CE mark Yes
Electrical safety IEC 61131-2, UL 508
Hazardous Location C1 Div 2 cULus, C1 Zone 2 cULus, ATEX Zone 2
Marine certification ABS, BV, DNV-GL, LR, RS, CCS
Protection rating IP20 according to IEC 60529
Corrosive atmosphere ISA-S71.04 G3
Climatic operating conditions 0 to +55 °C (Storage -40 to +70 °C), RH=5 to 95 % no condensation, IEC/EN
61131-2
Pollution degree Degree 2, IEC 60664-1
Mechanical operating conditions IEC/EN 61131-2
EMC EN 61000-6-4 and EN 61000-6-2
Overvoltage categories IEC/EN 60664-1, EN 50178
Equipment class Class I according to IEC 61140; (earth protected)
Max ambient temperature 55 °C (131 °F), for vertical mounting in compact MTU 40 °C (104 °F)
RoHS compliance DIRECTIVE/2011/65/EN (EN 50581:2012)
WEEE compliance DIRECTIVE/2012/19/EU

Compability
Use with MTU TU810, TU812, TU814, TU830, TU833, TU842, TU843, TU852
Keying code FE

2 DATA SHEET DO880 | 2019-07-25 | Copyright © 2019 ABB


Dimensions
Width 45 mm (1.77”)
Depth 102 mm (4.01”), 111 mm (4.37”) including connector
Height 119 mm (4.7”)
Weight 0.20 kg (0.44 lbs.)


Related products

TU810V1 TU812V1

TU814V1 TU830V1

TU833 TU842

TU843 TU852

DATA SHEET DO880 | 2019-07-25 | Copyright © 2019 ABB 3


— —
www.abb.com/800xA 800xA is a registered or pending We reserve all rights to this
www.abb.com/controlsystems trademark of ABB. All rights to other document and the items and images
trademarks reside with their it contains. The reproduction,
respective owners. disclosure to third parties or the use
of the content of this document –
We reserve the right to make including parts thereof – are
technical changes to the products or prohibited without ABB’s prior
modify the contents of this written permission.
document without prior notice. With
regard to purchase orders, the Copyright© 2019 ABB All rights
agreed particulars shall prevail. ABB reserved
does not assume any responsibility
for any errors or incomplete
information in this document.

4 DATA SHEET | 2019-07-25 | Copyright © 2019 ABB

You might also like