Scribd
Upload
21 views

Dernier Code

This document describes code for reading RFID cards using an MFRC522 module connected to an Arduino. The code initializes an LCD display and the MFRC522 module, then continuously scans for cards and displays the card UID on the LCD and serial monitor.

Uploaded by

Thierno Hady Diallo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
21 views

Dernier Code

This document describes code for reading RFID cards using an MFRC522 module connected to an Arduino. The code initializes an LCD display and the MFRC522 module, then continuously scans for cards and displays the card UID on the LCD and serial monitor.

Uploaded by

Thierno Hady Diallo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

#include <LiquidCrystal_I2C.

h>
#include <SPI.h>
#include <MFRC522.h>

#define RST_PIN 9
#define SS_PIN 10
byte readCard[4];
byte a = 0;

LiquidCrystal_I2C lcd(0x27, 16, 2);


MFRC522 mfrc522(SS_PIN, RST_PIN);

void setup() {
Serial.begin(9600);
lcd.init();
lcd.backlight();
while (!Serial);
SPI.begin();
mfrc522.PCD_Init();
delay(4);
mfrc522.PCD_DumpVersionToSerial();
lcd.setCursor(2, 0);
lcd.print("Put your card");
}

void loop() {
if ( ! mfrc522.PICC_IsNewCardPresent()) {
return 0;
}
if ( ! mfrc522.PICC_ReadCardSerial()) {
return 0;
}

lcd.clear();
lcd.setCursor(0, 0);
lcd.print("Scanned UID");
a = 0;
Serial.println(F("Scanned PICC's UID:"));
for ( uint8_t i = 0; i < 4; i++) { //
readCard[i] = mfrc522.uid.uidByte[i];
Serial.print(readCard[i], HEX);
Serial.print(" ");
lcd.setCursor(a, 1);
lcd.print(readCard[i], HEX);
lcd.print(" ");
delay(500);
a += 3;
}
Serial.println("");
mfrc522.PICC_HaltA();
return 1;

You might also like