Det Norske Veritas Atex en Us 4189176

DET NORSKE VERITAS
ACKNOWLEDGEMENT OF RECEIPT - EC
ACKNOWLEDGEMENT NO. 81458-2010-CE-USA-DNV Rev. 3
This Acknowledgement consists of 2 pages
This is to confirm that the Technical File for the following product(s):
Actuators
with type designation(s)
See page 2
Manufactured by
Morin Actuator
Pelham, Alabama 35124
USA
has been received and stored according to
the conformity assessment procedure described in Article 8.1.(b).(ii), of Council Directive

94/9/EC (ATEX) of 23 March 1994, category 2 non-electrical equipment.
Further details are given overleaf.
Place and date This Acknowledgement is valid until

Høvik, 2014-06-13 2024-07-01
for DET NORSKE VERITAS AS
PROD 021
Ståle Sandstad
Certification Manager
Notice: The acknowledgement is subject to terms and conditions overleaf. Any significant changes in design or construction may render this acknowledgement invalid.
The digitally signed and electronically distributed document is the original and valid acknowledgement. Ref.: www.dnv.com/digitalsignatures
If any person suffers loss or damage which is proved to have been caused by any negligent act or omission of Det Norske Veritas, then Det Norske Veritas shall pay compensation to such person for his proved direct loss or damage.
However, the compensation shall not exceed an amount equal to ten times the fee charged for the service in question, provided that the maximum compensation shall never exceed USD 300.000. In this provision “Det Norske Veritas” shall
mean the Foundation Det Norske Veritas as well as all its subsidiaries, directors, officers, employees, agents and any other acting on behalf of Det Norske Veritas.
Det Norske Veritas AS Veritasveien 1, , 1322 Høvik, Norway, +4767579900, +4767579911
Page 1 of 2
Ack. No.: 81458-2010-CE-USA-DNV Rev. 3
Project No.: PRJC-243238-2010-PRC-USA
Jurisdiction
DNV is appointed by the Directorate for Civil Protection and Emergency Planning as Notified
Body (No. 0575) under the terms of the Norwegian regulation “Forskrift om utstyr og
sikkerhetssystem til bruk i eksplosjonsfarlig område”, dated 1996-12-09 and Article 9 of
Council Directive 94/9/EC (ATEX), as amended.
Acknowledgement history
Revision Description DNV Project Issue Date
Original Acknowledgement PRJC-04117-2007-PRC-NOR 2007-05-04
1 Renewal PRJC-243238-2010-PRC-USA 2010-07-23
2 Add Hydraulic HP and SHP Actuators PRJC-243238-2010-PRC-USA 2013-07-10
3 Added A series Actuators PRJC-243238-2010-PRC-USA 2014-06-13
Product description: The following types are covered by the Acknowledgement:

Product Description Type Designations Category Product Group Product Sub Group
Actuator Model A 2 Ex equipment Non-electrical
Actuator Model B 2 Ex equipment Non-electrical
Actuator Model C 2 Ex equipment Non-electrical
Actuator Model S 2 Ex equipment Non-electrical
Hydraulic Actuator Model HP 2 Ex equipment Non-electrical
Hydraulic Actuator Model SHP 2 Ex equipment Non-electrical
Technical documentation: The following documentation has been received and stored:
Document No Document Name Rev. Date
00-2968 Actuator models A, B, C, S, HP & SHP 2 2014-05-01
Terms and conditions

The product liability rests with the manufacturer, his representative or, in the absence of a
representative, the importer, in accordance with the General Product Safety Directive
2001/95/EC
The following conditions may render this acknowledgement invalid:
• Changes in the design or construction of the product.
• Changes or amendments to the referenced directive(s).
• Changes or amendments in the standards which form the basis for documenting
compliance with the essential requirements of the directive(s).
Conformity declaration and marking of product

In order to fully meet with the requirements of the Directive and legally affix the CE mark, the
manufacturer must take all measures necessary to ensure that the manufactured product
comply with the technical documentation and with the requirements of the Directive and
finally draw up an EC declaration of conformity.
END OF ACKNOWLEDGEMENT
Det Norske Veritas AS Veritasveien 1, , 1322 Høvik, Norway, +4767579900, +4767579911
Page 2 of 2

Det Norske Veritas Atex en Us 4189176

Uploaded by

Copyright:

Available Formats

Det Norske Veritas Atex en Us 4189176

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Det Norske Veritas Atex en Us 4189176

Uploaded by

Copyright:

Available Formats

DET NORSKE VERITAS

This Acknowledgement consists of 2 pages

the conformity assessment procedure described in Article 8.1.(b).(ii), of Council Directive

Further details are given overleaf.

Place and date This Acknowledgement is valid until

Det Norske Veritas AS Veritasveien 1, , 1322 Høvik, Norway, +4767579900, +4767579911

Product description: The following types are covered by the Acknowledgement:

Terms and conditions

Conformity declaration and marking of product

Det Norske Veritas AS Veritasveien 1, , 1322 Høvik, Norway, +4767579900, +4767579911

You might also like