0% found this document useful (0 votes)
45 views1 page

FEE 512 Exercise 1

This document provides instructions for an exercise to draw a ladder logic diagram controlling lamps using ON-delay timers. The diagram should turn on Lamp 1 after 2 seconds, Lamp 2 after 4 seconds, Lamp 3 after 6 seconds, and Lamp 4 after 8 seconds after a start button is pressed. All lamps should then turn off after 10 seconds. The ladder logic diagram is to be created using open source PLC software and submitted by email by the deadline.

Uploaded by

BILLY
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
45 views1 page

FEE 512 Exercise 1

This document provides instructions for an exercise to draw a ladder logic diagram controlling lamps using ON-delay timers. The diagram should turn on Lamp 1 after 2 seconds, Lamp 2 after 4 seconds, Lamp 3 after 6 seconds, and Lamp 4 after 8 seconds after a start button is pressed. All lamps should then turn off after 10 seconds. The ladder logic diagram is to be created using open source PLC software and submitted by email by the deadline.

Uploaded by

BILLY
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

FEE 512: INDUSTRIAL AUTOMATION

Exercise 1:
Draw a ladder logic diagram to control the lamp output as per the given logic. Make use of
ON-Delay timers for this problem.

 Start the system using the start push button.


 Timer T1 receives an impulse from system memory to give output (lamp L1) after 2
seconds.
 Similarly, L2 turns ON after 4 seconds after receiving an impulse.
 Similarly, L3 turns ON after 6 seconds after receiving an impulse.
 Similarly, L4 turns ON after 8 seconds after receiving an impulse.
 In the end, all lamps turn off after 10 seconds after receiving an impulse.

Use any open source PLC software of your choice for the ladder diagram.
Submission Deadline: Friday 24th March 4pm
Submission Email: [email protected]

You might also like