Scribd
Upload
198 views4 pages

Session Plan

This session plan provides training over two learning outcomes for an intermediate turning workpiece unit. Learners will first set up workpieces, including work holding devices and centering tools, then perform turning operations over 40 hours through self-paced instruction, lectures, videos, and presentations. The second learning outcome involves performing lathe machine turning operations, covering speeds and feeds, machine accessories, procedures, safety practices, and metal properties over another 40 hours using similar instructional methods.

Uploaded by

John Buenaagua
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
198 views4 pages

Session Plan

This session plan provides training over two learning outcomes for an intermediate turning workpiece unit. Learners will first set up workpieces, including work holding devices and centering tools, then perform turning operations over 40 hours through self-paced instruction, lectures, videos, and presentations. The second learning outcome involves performing lathe machine turning operations, covering speeds and feeds, machine accessories, procedures, safety practices, and metal properties over another 40 hours using similar instructional methods.

Uploaded by

John Buenaagua
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

SESSION PLAN

SECTOR: METALS ENGINEERING

UNIT OF COMPETENCY: TURN WORKPIECE (INTERMEDIATE)

MODULE TITLE: TURNING WORKPIECE

INTRODUCTION: This module provides a solid foundation in turning workpiece operations and prepares learners for further skill development in the
field of machining and manufacturing.

LEARNING ACTIVITIES

LEARNING OUTCOMES:

LO 1. Set work piece

LO 2. Perform turning operations


LO 1. Introduction to Turn and Set the Workpiece

Learning Content Methods Presentation Practice Feedback Resources Time

 Work holding  Self-paced  Read information  Answer self-  Compare the CBLM 40hrs
devices instruction sheet 1.1-1 check 1.1-1 answer to the
 Lecture & Perform turning answer key
 centering tools and Discussion operations
devices.  Video
 Procedure in
presentation  View a video
setting up work
 PPT
presentation on
piece. Perform turning
operations
 safety practices
 View the PPT
for setting up
workpiece presentation

LO 2. Perform Lathe Machine Turning Operation

Learning Methods Presentation Practice Feedback Resources Time


Content

 Speeds and  Self-paced  Read information  Read the  Compare the CBLM 40hrs.
feeds instruction sheet 1.1-2 information sheet answer to the
calculations  Lecture &  View a video 1.1-2 answer key
Discussion
 Machine presentation  Self-paced
 Video
accessories and  View the PPT instruction
presentation
their uses. presentation  Lecture &
 PPT
Discussion
 Lathe operations  Video presentation
procedures  PPT

 Lathe safety
practices

 Properties of
metals

You might also like