204lab Assignment
204lab Assignment
Lab Assignment
Marks: 40
1. What are the general steps/points to check before starting an experiment? (2)
2. You have a NOR gate with you and you have to generate and output Q.R. Draw the circuit
diagram. (2)
3. You have a NAND gate with you and you have to generate and output Q.R. Draw the circuit
diagram. (2)
4. Draw the pin diagram of NOR gate and write the pin functions. (2)
6. Write the steps of making a NOT gate (basic gate) using a NAND gate as done in the lab
as an experiment. (2)
7. How did you confirm that the circuit you designed is showing the correct output? (1)
8. You have a box full of different logic gates. How would you recognize which one is the
one you are looking for? (1)
9. How would you connect the LED (positive side, negative side) in your circuit while you
are trying to generate an output from a logic gate? (1)
10. How will you connect the wire(s) for input(s) for 0, 1? (1)
11. Draw the pin diagram of NAND gate and write the pin functions. (2)
12. How did you verify De Morgan’s Theorems using logic gates as an experiment? Write the
steps. (3)
13. Draw the pin diagram of NOT gate and write the pin functions. (2)
15. What will the circuit diagram of 4-bit even parity generator look like? Draw the diagram.
(3)
16. What will the circuit diagram of 4-bit even parity checker look like? Draw the diagram.
(3)
17. Draw a NAND Latch Diagram. (1)
18. Is the following truth table for a NAND Latch correct? (1)
1
19. What are the gates needed for designing a full adder circuit? (1)
20. What is the voltage of the power supply were you recommended to use while doing the
experiments? (1)
21.
22.
23.
2
24.
25.
26.