WinDelta32 Eng
WinDelta32 Eng
If an old version of WinDelta is already installed on your computer, carry out the following steps before
installing the new version:
• In the Options/Configuration menu, open the Serial Port page and note the COM port
displayed to the right of Default (e.g. COM1).
• If you want to keep the stored parameter sets, select the menu Parameters/LRV and export all
existing parameter sets (click Export => All parameter sets). Save the file (for example under
the name ParaLRV.prm) to the folder C:\Temp). Close the window.
• Open the menu Parameters/VF-LRV and export all existing parameter sets (click Export => All
parameter sets). Save the file (for example under the name ParaVF_LRV.prm) to the folder
C:\Temp).
• Exit and close all programmes. Refer to the Windows help for information about how to remove a
programme.
Installing the new version (the following steps may take a few minutes):
• If any further dialogs (see picture below) are displayed, click “YES” or “OK”
• Click the button Next (or Install or Finish) until the installation is terminated. A shortcut will
automatically be placed on the desktop.
• In order to determine the serial port used for data communication between the programme
WinDelta32 (PC) and the Delta Controller (control card), in the Menu Options / Configuration,
call up the Serial Port page, select the port you wrote down or a port from the list of available
ports and check the box Default in order to store the current settings.
• If you wish to reuse the parameter sets that you previously exported, select the menu
Parameters/LRV and import (click Import => All parameter sets) the stored file (e.g. the file
ParaLRV.prm from the folder C:\Temp). Click the button (Refresh
data) before closing the window.
• Select the menu Parameters/VF-LRV and import (click Import => All parameter sets) the
stored file (e.g. the file ParaVF_LRV.prm from the folder C:\Temp). Click the button
(Refresh data) before closing the window.
• Refer to the integrated on-line help (Menu Help/Contents and Index / Contents / WinDelta32 /
Settings) for further information about settings.
Connect DELCON to PC/Laptop