Scribd
Upload
3K views1 page

7AF ECU Pinout

This document provides a pinout diagram for the 7AF ECU (Engine Control Unit). It shows the pin assignments and wire colors for 3 connectors - connectors A, B, and C. The pinout identifies the function of each pin, such as sensors for manifold pressure, throttle position, air and coolant temperatures, oxygen sensors, fuel injectors, and other engine and emissions control components.

Uploaded by

Marrij Chowdhry
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
3K views1 page

7AF ECU Pinout

This document provides a pinout diagram for the 7AF ECU (Engine Control Unit). It shows the pin assignments and wire colors for 3 connectors - connectors A, B, and C. The pinout identifies the function of each pin, such as sensors for manifold pressure, throttle position, air and coolant temperatures, oxygen sensors, fuel injectors, and other engine and emissions control components.

Uploaded by

Marrij Chowdhry
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

7AF ECU Pinout

A B C D E F G H I J
1 (VC) Yellow → [MAP] & [TPS/end of resistor] (Batt) Red-White
2 (PIM) Light Green-Red → [MAP] (ELS1) Green → [From “TAIL” fuse <10-3>]
3 (IGF) Blue-Yellow →(IGT) Yellow-Green [A20] (THA) Yellow-Black → [Air Intake Temp] (ELS2) Black → [From“DEFOG-I/UP” fuse <11-2>]
4 (NE) Black → [Crankshaft Position sensor] → [NE- White A17] (THW) White → [Engine Coolant Temp]
5 (G2) Black → White [A17 NE-] (OX2) Black → [Heated Oxygen Sensor] (W) Red-Yellow → [Malfunction Indicator Lamp]
6 (OX1) Black → [Oxygen Sensor]
7
8
9 (RSClosed) Black -White → [IdleAirControl] (E2) Brown → [Air & Water Temp, TPS, MAP] (SPD) Violet-White → [From Speedometer]
10 (RSOpen) Black-Blue → [IdleAirConrol] (AC1) Yellow-Red → [A/C Amplifier]
11 (#20) Black-Red → [I5 Injector #2] (VTA) Blue-Green → [TPS/middle of resistor] (STA) Black → [From Start SW <1-2>]
12 (#10) Yellow → [I4 Injector #1] (B+) Black → [EFI Relay, C7 Circuit Opening Relay]
13 (E01) Brown → [Intake EC Ground] (KNK) Black → [Knock Sensor]
14 (E1) Brown → [Intake EC Ground] (FC) Green-Red → [C7 Circuit Opening Relay]
15 (TE1) Blue-White → [Data Link Connector 1]
16 (E03) Brown → [Intake EC Ground] (SDL) Black → [Data Link Connector 3]
17 (NE-) White → [Crankshaft Position Sensor]
18
19 (HT2) Blue-Black → [IC2] → [Heated Oxygen sensor]
20 (IGT) Yellow-Green → [From Igniter]
21 (ACT) Red-Yellow → [A/C Amplifier]
22
23 (EGR) Black-White
24 (#40) Black → [I7 Injector #4]
25 (#30) Black-White → [I6 Injector #3]
26 (E02) Brown → [Intake EC Ground]
27 A-Connector 26 Pins 16 Wires B-Connector 16 Pins 11 Wires C-Connector 22 Pins 11 Wires 7AFE W/MT ECU Pin Out

Page 1

You might also like