Speaker Microphone Pin Out
3.5mm Plug
Sleeve Mic – PTT Rx Data (to the radio)
Ring Mic +
Tip +V (from the radio)
2.5mm Plug
Sleeve Speaker – PTT Data GND
Ring TX Data (from the radio)
Tip Speaker +
Connect Sleeve to Sleeve for PTT
Note: This plug is Baofeng, Kenwood and Wouxun compatible.
Dual PTT Switch
Baofeng UV-82 series
A standard single button remote spkr/micr will select Display B (the bottom display) when keyed.
There are earpiece/microphones available that incorporate two PTT buttons. The wiring
configuration for these is shown below.
Shorting X to A will select Display A (upper)
Shorting X to B will select Display B (lower)
PROGRAMMING CABLES
for Kenwood, Wouxun, Baofeng
Provided by Jim KC9HI, Paul AE5JU
The RXD line from the module goes to the sleeve of the 3.5MM plug.
The TXD line from the module goes to the ring of the 2.5MM plug.
The GND line from the module goes to the sleeve of the 2.5MM plug.
There are several variations of CP2102 boards available.
The pin location and labels may vary.
Below are two examples.
Builders Note: Some boards have the TXD and RXD pin labels reversed. If your cable does not
work, switch the TXD and RXD wires.
The CP2102 USB-UART is by Silicon Labs and can be found on eBay ($3).
A 6ft Cable and Plug can be obtained from 3_Old_Crows ($8).
Windows, MAC and Linux drivers can be downloaded at: Silabs_Drivers
Builders Note: Using an old Cloning or Programming Cable/Plug may not work. The wires are
hair thin and many can't be soldered.
Using the TOC cable: White=TXD Blue=RXD Black=Ground
Check continuity before soldering
PROGRAMMING CABLES
for Baofeng UV-3R
ANTENNA CONNECTION
Most Baofeng UV-5R, UV-82, UV-B5/6, UV-3R+, etc
require an antenna with an SMA Female fitting.
Most Wouxun KG-UVxx models require an SMA Male fitting.
Unlike horseshoes, close doesn't count.
Always confirm the connector type before ordering.
example of SMA Female
SMA RP (Reverse Polarity) and
SMA Male are NOT compatible.
Note: SMA-RP connectors are found on most Wi-Fi Routers.
Examples of Various SMA Formats
Why this is referred to as a Reversed Connector
Reversed SMA-Male Connectors are
commonly found on Wi-Fi Routers
To use an antenna with a BNC Male requires the following adapter:
SMA Female (above) to mate with the radio
BNC Female to mate with the BNC Male antenna.
Another option is a jumper (pigtail). This relieves the stress of a heavier cable when using an
external mobile or fixed antenna.
Cable Jumper (pigtails) are available from 3_Old_Crows
SMA-F Antenna Extended Threads
Some antennas with SMA-F connectors have an extended thread. Most radios such as the UV-5R
and UV-3R+ require a standard SMA-F.
The illustration shows two different Nagoya NA-771 antennas.
Some antennas with extended threads ship with a spacer to fill the gap.
If the radio requires extended threads, such as a BF-888S, an antenna with standard threads will not
make connection unless you trim the outer shell or lip of the antenna so it is flush with the base.
The wrong threads (if too short) will result in poor reception and over heating of the transmitter as
there is no antenna connection.
