Scribd
Upload
10 views3 pages

Sheet 1-1

The document is a study sheet for an electronics course covering Bipolar Junction Transistors. It includes 6 problems analyzing various BJT circuits: 1) Determining the Q-point for different beta values; 2) Finding currents and voltages in a circuit given beta; 3) Designing a bias network; 4) Calculating voltages given beta and input voltages; 5) Finding beta from circuit measurements; 6) Calculating voltages in a multi-transistor circuit. Diagrams of the circuit for each problem are provided.

Uploaded by

Shams Amir Mohamed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
10 views3 pages

Sheet 1-1

The document is a study sheet for an electronics course covering Bipolar Junction Transistors. It includes 6 problems analyzing various BJT circuits: 1) Determining the Q-point for different beta values; 2) Finding currents and voltages in a circuit given beta; 3) Designing a bias network; 4) Calculating voltages given beta and input voltages; 5) Finding beta from circuit measurements; 6) Calculating voltages in a multi-transistor circuit. Diagrams of the circuit for each problem are provided.

Uploaded by

Shams Amir Mohamed
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Zagazig University Electronic 2 (2st year)

Faculty of Engineering
Electronics and Communications Department Sheet -1 / 2021-2022

0 – (a) Use the node-voltage method to find and in the circuit shown in Fig.

0 – (b) Use the mesh-current method to find the branch currents and in the circuit in Fig.

Bipolar Junction Transistor (DC analysis)

1- For circuit shown in figure 1. Determine the Q-point for


following conditions:-
a. β=40 (assume VBE=.7V)
b. β=250 (assume VBE=.7V)
c. β=∞ (assume VBE=.7V)

Fig. 1
2- For circuit shown in figure 2. Determine the following
(assume VBE=.7V , β=50 )

a. Collector current (Ic)


b. Base-collector voltage (VBC)
c. Emitter voltage (VE)
d. Collector-Emitter voltage (VCE)

Fig. 2

3- Design a four-resistor bias network for an npn transistor to give IC = 1 mA, VC E = 5 V,


and VE = 3 V if VCC = 12 V and β = 100.

4- For shown circuit measurement indicates that VB=-1.5V


assuming 𝑽𝑩𝑬 =. 𝟕𝑽 Calculate VE ,α ,β and 𝑽𝑪 . if
transistor with β=∞ is used. What is values of 𝑽𝑩 , 𝑽𝑬 , 𝑽𝑪 .
?
Fig. 3

Fig. 3
5- For shown circuit measurement is shown find the value
of β?

Fig. 4

6- For shown circuit calculate 𝑽𝑪𝟏 , 𝑽𝑬𝟐 , 𝑰𝑬𝟏

Fig. 5

With best wishes

You might also like