Tokyo Cosmos Electric Co LTD Ra30y 3fbd6d232f

Download as pdf or txt
Download as pdf or txt
You are on page 1of 5

TOCOS

RA30 Series PA N E L C O N T R O L S

30mm Diameter, Single-Turn, Wirewound Industrial Panel Controls

RA30YME RA30YD RA30Y

Features
䡲 30mm diameter, single-turn industrial panel controls 䡲 Wirewound element 䡲 Linear or audio tapers
䡲 Single, tandem and triple units, single shaft; dual unit, dual shaft 䡲 SPST or SPDT switch with 1A or 3A rating
䡲 Shaft lock and center tap models 䡲 Metal shaft and bushing 䡲 Temperature range of ⴑ10ⴗC or ⴑ30ⴗC, up to ⴐ100ⴗC
䡲 Panel mount only 䡲 6mm diameter shafts in slot, flat or round end styles 䡲 Standard 15mm or 20mm shaft length
Specifications
Electrical Environmental
Standard Resistance Range . . . . . . . . . . . B = 5Ω to 20kΩ Temperature Range . . . . . . . . . . . . . . Y = ⴑ10ⴗC to ⴐ100ⴗC
A,C = 100Ω to 5kΩ or X = ⴑ30ⴗC to ⴐ100ⴗC
Resistance Tolerance . . . . . . . . . . . . . . . . . ⴣ10% standard Temperature Characteristics . . . . . . . . . . .ⴐ85ⴗC, 5 hours
(ⴣ5%,ⴣ2% or ⴣ1% special order ) without load
End Resistance . . . . . . . . . . . . . . . . . . R ! 500Ω = 1Ω max. ∆T/R )ⴣ5%
R 0 500Ω = 0.2% max. Low Temperature Exposure . . . . . . . ⴑ10ⴗC ( Y ),ⴑ30ⴗC ( X )
Resistance Taper . . . . B = linear; A = CW audio (logarithm); 1 hour without load
C = CCW audio (logarithm) ∆T/R )ⴣ3%
Power Rating . . . B = 2.5 watts; A,C = 1.25 watts, at ⴐ40ⴗC Load Life . . . . . . . . . . . . ⴐ40ⴗC, 1,000 hours with rated load
Insulation Resistance . . . . . . . 100MΩ minimum at 500VDC ∆T/R )ⴣ3%
Dielectric Strength . . . . . . . . . . . . . . . . . . 500VAC, 1 minute Moisture and Load Life . . . . . . . . . . . .ⴐ40ⴗC, 90-95%RH,
500 hours with 1/10 rated load
Theoretical Resolution
∆T/R )ⴣ5%
Resistance ( Ω ) Resolution ( % ) Resistance ( Ω ) Resolution ( % )
Vibration . . . . . . . . . . . . . . . . . . .10-55Hz, 1.5mm amplitude,
5 1.62 500 0.23
10 0.81 1,000 0.19
2 directions, 2 hours each
20 0.67 2,000 0.15 ∆T/R )ⴣ1%
50 0.45 5,000 0.14
100 0.44 10,000 0.12
Soldering Heat Resistance . . . . . . . . . 350ⴗC, 3.5 seconds;
200 0.32 20,000 0.10 ∆T/R )ⴣ2%
Rotational Life . . . . 15,000 cycles (500 cycles for shaft lock
Mechanical models only) with 1/2 rated load
Mechanical Travel . . . . . . . . . . . . . . . . . . . . . . . . . . 300ⴗⴣ5ⴗ ∆T/R )ⴣ3%
Shaft Torque Standard Rotary Switches
Single Unit . . . . . 70.1 to 306 gf • cm (0.972 to 4.242 oz • in) Switch Rating . . . . . . . . . . 110VAC, 1A or 3A, SPDT or SPST
Tandem Unit . . . . . . 70 to 701 gf • cm (0.97 to 9.718 oz • in)
Other Units . . . . . . . 70 to 450 gf • cm (0.97 to 6.238 oz • in) Contact Resistance . . . . . . . . . . . . . . . . . . . . . . 0.05Ω max.
Stop Strength . . . . . . . . . . . . 10.2 kgf • cm (141.4 oz • in) max. Operating Torque . . . . . . . . 1,500 gf • cm (20.79 oz • in) max.
Mounting Nut Torque . . . . . . 15 kgf • cm (207.94 oz • in) max. Operating Life . . . . . . . . . . . . . . . 10,000 cycles without load
Solderability . . . . . . . . . . . . . . . . . . . . . . . 235ⴗC, 3 seconds R = Total Resistance Value; ∆T/R = Total Resistance Change

Marking . . . . . . . . . . Taper, resistance, resistance tolerance,


terminal identification, date code

TOCOS AMERICA, INC. 63


1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 E-mail: [email protected] www.tocos.com

Downloaded from Datasheet.su


RA30 Series Dimensions

RA30Y & RA30X Unit: mm


Panel Mount, Single Unit, Single Shaft
Right Angle Ear-Lug Terminals

Recommended
Panel Mounting Holes

RA30YL & RA30XL


Panel Mount, Single Unit, Single Shaft with Shaft Lock
Right Angle Ear-Lug Terminals

Recommended
Panel Mounting Holes

RA30YME, RA30YMF, RA30YSE, RA30YSF


RA30XME, RA30XMF, RA30XSE, RA30XSF
Panel Mount, Single Unit with Switch, Single Shaft
Right Angle Ear-Lug Terminals, Rear Exit Lug Terminals for 1A or 3A SPST or SPDT Switch

Recommended
Panel Mounting Holes

64 TOCOS AMERICA, INC.


1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 E-mail: [email protected] www.tocos.com

Downloaded from Datasheet.su


RA30 Series Dimensions

RAT30Y Unit: mm
Panel Mount, Single Unit with Center Tap, Single Shaft
Right Angle Ear-Lug Terminals, Tap Lug Terminal 105ⴗ from Terminal #1

Recommended
Panel Mounting Holes

RA30YG
Panel Mount, Ganged Tandem Unit, Single Shaft
Right Angle Ear-Lug Terminals on Each Unit

Recommended
Panel Mounting Holes

RA30YGL
Panel Mount, Ganged Tandem Unit, Single Shaft with Shaft Lock
Right Angle Ear-Lug Terminals on Each Unit

Recommended
Panel Mounting Holes

TOCOS AMERICA, INC. 65


1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 E-mail: [email protected] www.tocos.com

Downloaded from Datasheet.su


RA30 Series Dimensions

RAT30YG Unit: mm
Panel Mount, Ganged Tandem Unit with Center Tap, Single Shaft
Right Angle Ear-Lug Terminals, Tap Lug Terminal 105ⴗ from Terminal #1

Recommended
Panel Mounting Holes

RA30YT
Panel Mount, Triple Unit, Single Shaft
Right Angle Ear-Lug Terminals on Each Unit

Recommended
Panel Mounting Holes

RA30YD
Panel Mount, Dual Unit, Dual Concentric Shaft
Right Angle Ear-Lug Terminals on Each Unit

Recommended
Panel Mounting Holes

66 TOCOS AMERICA, INC.


1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 E-mail: [email protected] www.tocos.com

Downloaded from Datasheet.su


RA30 Series Part Numbering System

RA T 30 Y L ME 20 S B 102 K NOTE: FMS = From Mounting Surface

Resistance Tolerance: K = ⴣ10% (standard).


J = ⴣ5%; G = ⴣ2%; or F = ⴣ1% (special order ).
Resistance Code: Expressed in ohms. A three digit code where the first
two digits are significant figures, and the third digit indicates the number
of zeros that follow these figures. R indicates decimal point for resistance
less than 10Ω (i.e., 5R0 = 5Ω; 100 = 10Ω; 101 = 100Ω; 102 = 1,000Ω;
103 = 10,000Ω ). See table for standard resistance values.
For Single Unit: Specify taper and resistance code as shown.
For Ganged Tandem Unit or Dual Unit:
Specify a taper code and resistance code for each unit starting with
the front unit followed by the rear unit. If both units have the same taper
and resistance codes, add “X2” suffix per example below.
Examples: B102A503 or if both units are the same: B102X2
For Triple Unit:
Specify a taper code and resistance code for each unit starting with
the front unit followed by the middle and rear units. If all units have the
same taper and resistance codes, add “X3” suffix per example below.
Examples: B102A503B104 or if all units are the same: B102X3
Resistance Taper: B = Linear; A = CW Audio (logarithm);
C = CCW Audio (logarithm).
Shaft End Style: S = Slotted; F = Flatted; R = Round.
For Single Shaft:
Specify the shaft length (FMS) and shaft end style as shown.
For Dual Concentric Shaft:
Specify the shaft length (FMS) and shaft end style for the inner shaft
followed by the shaft length (FMS) and shaft end style for the outer
shaft. Use a dash (-) to separate the code groups for the inner and
outer shaft specifications. Example: 30R-20R
Standard Shaft Length: 15 = 15 mm FMS; 20 = 20mm FMS.
Up to 50mm shaft length available (special order ).
Switch Type: ME = SPDT, 110VAC, 1A, Rear Exit Lug Terminals.
MF = SPDT, 110VAC, 3A, Rear Exit Lug Terminals.
SE = SPST, 110VAC, 1A, Rear Exit Lug Terminals.
SF = SPST, 110VAC, 3A, Rear Exit Lug Terminals.
Blank = No Switch.
Style: Blank = Panel Mount, Single Unit, Single Shaft, Right Angle Ear-Lug
Terminals.
L = Panel Mount, Single Unit, Single Shaft with Shaft Lock,
Right Angle Ear-Lug Terminals.
G = Panel Mount, Ganged Tandem Unit, Single Shaft, Right Angle
Ear-Lug Terminals on Each Unit.
GL = Panel Mount, Ganged Tandem Unit, Single Shaft with Shaft
Lock, Right Angle Ear-Lug Terminals on Each Unit.
T = Panel Mount, Triple Unit, Single Shaft, Right Angle Ear-Lug
Terminals on Each Unit.
D = Panel Mount, Dual Unit, Dual Concentric Shaft, Right Angle
Ear-Lug Terminals on Each Unit.
Operating Temperature Range: Y = ⴑ10ⴗC to ⴐ100ⴗC.
X = ⴑ30ⴗC to ⴐ100ⴗC.
Size: 30 = 30mm Diameter.
Center Tap: T = With Tap; Blank = Without Tap.
TOCOS Series Name: RA = Wirewound Element.

Standard Resistance Values and Part Numbering Codes

Standard Nominal Total Resistance Values and Part Numbering Codes


Resistance ( Ω ) Code Resistance ( Ω ) Code Resistance ( Ω ) Code Resistance ( Ω ) Code
05 5R0 100 101 1,000 102 10,000 103
10 100 200 201 2,000 202 20,000 203
20 200 500 501 5,000 502
50 500

Refer to Shaft End Styles Specifications and Hardware Specifications for details and availability.
For additional information, refer to Guidelines and Precautions for Using Panel Controls.

TOCOS AMERICA, INC. 67


1177 East Tower Road, Schaumburg, IL 60173 Tel: 847-884-6664 Fax: 847-884-6665 E-mail: [email protected] www.tocos.com

Downloaded from Datasheet.su

You might also like