Scribd Logo
Upload

Welcome to Scribd!

  • 8 views

    MMSN

    Uploaded by

    ahmed

    Copyright:

    © All Rights Reserved
    Download as PDF or read online from Scribd

    MMSN

    Uploaded by

    ahmed
    8 views3 pages

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF or read online from Scribd
    Download as pdf
    8 views3 pages

    MMSN

    Uploaded by

    ahmed

    Copyright:

    © All Rights Reserved
    Download as PDF or read online from Scribd
    Download as pdf
    You are on page 1of 3
    HOW TO THE MMSI NUMBER MF/HF RSS112A/113A PAGE 1 - 8 VHF = RSS201A.RU224A PAGE 9 INM-C RSS405A PAGE 12 -13 INM-C RSS406A PAGE 14 INM-B RSS402B.RSS402A PAGE 10 11 MF/HF RADIO RSS112A/113A HOW TO ENTER THE MMSI NUMBER 3.5 Operating Control Unit at Rack Installation Location When the Radio Rack (RC141A/RC142A) and ME/HF Control Unit NBDP. ON THIS TERR Back. tees PROM ONLY HERE POSITION. OL ) are in- stalled in different locations, when itis necessary to perform control at the Rack instal- lation location, remove the Control Unit from the Alarm Unit (RC140A) and connect it to the MF/HF Main Unit (RZ110A) inthe rack to perform control. Ref: The Check Meter for the antenna current and final stage curreat is mounted in the Rack. Use this function when performing adjustments at rediowave testing ‘and periodic inspection while observing the Check Meter. ‘This procedure is described below. 4] Sstepererioes te: fgupmeinte sem OF 2 Remove the Control Unit from the mount, and disconnect the cable between the Control Unit and the Alarm Unit (white, pin nylon connec- tor connected to 247149880). [CONTROLLER] at Alarm Unit side: 2427149926 or 3 ‘Remove the front panel of the Radio Rack. D 3.5 Operating Control Unit at Rack Installation Location 4 ‘As shown in Fig. 3.2 plug the cable disconnected in item 2 above into the connector marked (RZ110A). ME/HE coureoer Rd- ot on RFA RE24B EXTPRS [MAINT] near the lower center of the Main Unit NORMAL DISABLE | 0sele switch at the left side 5 Set the lever of the of the [MAINT] connector to the [DISABLE] XX BNTER THE MMs. side of the right Note: This switch disables external control during operation and trans mission is disabled even if the handset is pressed. Always return this lever to the [NORMAL pleting the work. side of the leftafter com- In addition, this switch setting is only read at power-on. Always recycle the power when changing this switch setting. 6 ‘Set the power to the Radio Rack and the Control Unit to ON. 7 “The menu screen is displayed atthe Control Unit and operation is enabled. Note: However communication by the Morse key and handset is not possible. Test broadcasting and DSC and NBDP communication using the Control Unit are enabled. oo Adjusting Equipment

    You might also like