Controller WING VOLCANO
Controller WING VOLCANO
Controller WING VOLCANO
TECHNICAL PARAMETERS
FUNCTIONS
It is used to control all types of air curtains WING with AC motor and water heaters VOLCANO with
AC motor. Heating switch controls valve with actuator (ON(1)/OFF) for VOLCANO water heaters and
water air curtains WING W. For WING E air curtain it switches on electric heaters (1 level, 2 level,
OFF). The built-in thermostat automatically switches off the air curtain/the water heater depending
on the set, on the knob, temperature.
Properties
Key features of the WING/VOLCANO controller:
Main (ON/OFF) switch
2-position thermostat control (on/off), gas-filled diaphragm
Heating control switch: (1,2,OFF) – level 1 and 2 refer to heating level control of WING E
Three-stage fan speed control: FAN (1,2,3)
BUILDING
The thermostat casing is made of plastic. The required room temperature can be set using the knob
located on the casing of the unit.
CONTROL PANEL
GUIDANCE
The controller should be situated where the temperature of the air is as accurate as possible and
where there is no adverse effect of solar radiation or other sources of heat or cold. The installation
should be at height of about 1,5m above the floor.
The controller can be installed directly on the wall or on commercially available installation box.
Service activities (opening of the controller) can be carried out only by authorized personnel
(Attention: 220…240 VAC!). Disconnect the power supply before opening the enclosure.