B43876S9478M 1 - Ed5

Aluminum Electrolytic Capacitors
Screw Terminal
Series/Type: B43876
Preliminary ordering code: B43876S9478M 1
Date: February, 2015
Version: 5
© EPCOS AG 2015. Reproduction, publication and dissemination of this publication, enclosures hereto and the information
contained therein without EPCOS' prior express consent is prohibited.
Aluminum Electrolytic Capacitors B43876S9478M 1
Screw Terminal B43876
85 °C / 2000 h
• GP Grade
Customer: WEG
Dimensions (mm)
Case d x l Insulation Terminals imagem
75 x 105 PVC, black M6
Mechanical Spec (mm)
l1 112,2
l2 16
a 31,7
d1 M12
d2 17,7
Technical data
Rated capacitance CR 120 Hz, 25 °C 4700 µF
Capacitance tolerance ±20%
Rated voltage VR 400 V
Surge voltage VS 440 V
Operating voltage Vop 300 V
Operating temperature range -40 / 105 °C
IEC climatic category 40/105/56
ESR Max ESRmax 120Hz, 25 °C 32 mΩ
Max. Ripple Current Irmax 120Hz, 85 °C 30 A
Permissible Ripple Current I~R 120 Hz, 105 °C 13 A
Endurance 85 °C, VR 2000 h After test: |∆C/C| ≤ ±20% of initial value

tanδ≤ 2 x initial spec. limit
Ileak ≤ initial spec. limit
Useful life 85 °C, VR, IAC,R >2000 h After test: |∆C/C| ≤ 30% of initial value
tanδ ≤ 3 x initial spec. limit
Ileak ≤ initial spec. limit
Other specifications IEC 60384-4
Cautions and warnings: see Data Book 2013 or www.epcos.com

GTI CAP ALU PD February, 2015
Please read Important notes

at the end of this document. Page 2 of 3
Important notes
The following applies to all products named in this publication:

1. Some parts of this publication contain statements about the suitability of our products for
certain areas of application. These statements are based on our knowledge of typical
requirements that are often placed on our products in the areas of application concerned. We
nevertheless expressly point out that such statements cannot be regarded as binding
statements about the suitability of our products for a particular customer application. As a
rule, EPCOS is either unfamiliar with individual customer applications or less familiar with them
than the customers themselves. For these reasons, it is always ultimately incumbent on the
customer to check and decide whether an EPCOS product with the properties described in the
product specification is suitable for use in a particular customer application.
2. We also point out that in individual cases, a malfunction of electronic components or failure
before the end of their usual service life cannot be completely ruled out in the current state
of the art, even if they are operated as specified. In customer applications requiring a very high
level of operational safety and especially in customer applications in which the malfunction or
failure of an electronic component could endanger human life or health (e.g. in accident
prevention or life-saving systems), it must therefore be ensured by means of suitable design of the
customer application or other action taken by the customer (e.g. installation of protective circuitry
or redundancy) that no injury or damage is sustained by third parties in the event of malfunction or
failure of an electronic component.
3. The warnings, cautions and product-specific notes must be observed.
4. In order to satisfy certain technical requirements, some of the products described in this
publication may contain substances subject to restrictions in certain jurisdictions (e.g.
because they are classed as hazardous). Useful information on this will be found in our Material
Data Sheets on the Internet (www.epcos.com/material). Should you have any more detailed
questions, please contact our sales offices.
5. We constantly strive to improve our products. Consequently, the products described in this
publication may change from time to time. The same is true of the corresponding product
specifications. Please check therefore to what extent product descriptions and specifications
contained in this publication are still applicable before or when you place an order.
We also reserve the right to discontinue production and delivery of products. Consequently,
we cannot guarantee that all products named in this publication will always be available.
The aforementioned does not apply in the case of individual agreements deviating from the
foregoing for customer-specific products.
6. Unless otherwise agreed in individual contracts, all orders are subject to the current version of
the “General Terms of Delivery for Products and Services in the Electrical Industry”
published by the German Electrical and Electronics Industry Association (ZVEI).
7. The trade names EPCOS, BAOKE, Alu-X, CeraDiode, CeraLink, CeraPlas, CSMP, CSSP,
CTVS, DeltaCap, DigiSiMic, DSSP, Filter Cap, FormFit, MiniBlue, MiniCell, MDK, MKK, MLSC,
MotorCap, PCC, PhaseCap, PhaseCube, PhaseMod, PhiCap, SIFERRIT, SIFI, SIKOREL,
SilverCap, SIMDAD, SiMic, SIMID, SineFormer, SIOV, SIP5D, SIP5K, ThermoFuse, WindCap
are trademarks registered or pending in Europe and in other countries. Further
information will be found on the Internet at www.epcos.com/trademarks.
Page 3 of 3

B43876S9478M 1 - Ed5

Uploaded by

Copyright:

Available Formats

B43876S9478M 1 - Ed5

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

B43876S9478M 1 - Ed5

Uploaded by

Copyright:

Available Formats

Aluminum Electrolytic Capacitors

Capacitance tolerance ±20%

Rated voltage VR 400 V

Surge voltage VS 440 V

Operating voltage Vop 300 V

Operating temperature range -40 / 105 °C

IEC climatic category 40/105/56

ESR Max ESRmax 120Hz, 25 °C 32 mΩ

Max. Ripple Current Irmax 120Hz, 85 °C 30 A

Permissible Ripple Current I~R 120 Hz, 105 °C 13 A

Endurance 85 °C, VR 2000 h After test: |∆C/C| ≤ ±20% of initial value

Cautions and warnings: see Data Book 2013 or www.epcos.com

Please read Important notes

The following applies to all products named in this publication:

3. The warnings, cautions and product-specific notes must be observed.

You might also like