Inovbiz Template
Inovbiz Template
Inovbiz Template
Inovbiz
Website: www.ejournal.polbeng.ac.id/index.php/IBP
Email: [email protected]
Abstract should contain summary of the all research (aim, scope, result and
Received: (diisi oleh editor) conclusion) with maximum 250 words, justified, 9 point, and line spacing: single
Received in revised: and be written in English. For keywords separated using symbol (,) with maximum
(diisi oleh editor) are 6 words. If you need assistance, please do not hesitate to contact INOVBIZ
Accepted: (diisi oleh editor) editorial secretariat, or any further address you may have received for this purpose.
Published: (diisi oleh editor)
Keywords: Abstract, aim, scope, result
Open Access
1. Introduction
This template, created in MS Word, provides increase the line spacing. Running text should be
authors with most of the formatting specifications justified.
needed for preparing electronic versions of their
papers. All standard paper components have 2. Section Headings
been specified for three reasons: 1) ease of use The way chapter titles and other headings are
when formatting indi-vidual papers, 2) automatic displayed in these instructions, is meant to be
compliance to electronic requirements that followed in your manuscript.
facilitate the concurrent or later production of
Level 1: Arial, 10, Bold, 6 pt spacing before
electronic products, and 3) conformity of style
heading, 6 pt spacing after heading.
throughout a journal paper. Margins, column
widths, line spacing, and type styles are built-in; Successive Levels: Arial, 8, Bold, 4 pt spacing
examples of the type styles are provided before heading, 6 pt spacing after heading. NO
throughout this document and are identified in spacing below heading.
italic type, within parentheses, following the Do NOT begin a new section directly at the
example. Some components, such as multi- bottom of the page, but transfer the heading to
leveled equations, graphics, and tables are not the top of the next page.
prescribed, although the various table text styles Cite the main scientific publications on which
are provided. The formatter will need to create your work is based. Cite only items that you have
these components, incorporating the applicable read. Do not inflate the manuscript with too many
criteria that follow. The book size will be in A4.
references. Avoid excessive self‐citations. Avoid
Please make sure that you do not exceed th e
excessive citations of publications from the same
indicated type area.
region. Check each reference against the original
The structure of manuscripts should follow the
source (authors name, volume, issue, year, DOI
following order; title, authors, affiliations, abstract,
Number). Please use Reference Manager
keywords, main text consits of Introduction,
Applications like Mendeley, Zotero, etc. Use other
Method, Result and Discussion,
published articles in the same journal as models.
(acknowledgement), (appendix), (nomenclature),
references. The items with parentheses are not If you are cite using mendeley please use
mandatory. Elsevier Harvard (With Title) for cite model
The maximum pages printed in INOVBIZ are stlye.
supposed to be 8 for an original paper and 12 for 3. (Foot)notes
a review paper. Do NOT include page numbers.
Do NOT add Headers or Footers. Prescribed font It is requested not to us any of footnotes. All
is Arial, 9 points, with an single line spacing. references should be in the References.
However, if your text contains complicated Explanations should be preferably included in the
mathematical expressions, you may need to text.
4. Symbols and Units, Numbers
* Corresponding author
E-mail addresses: [email protected] (XXXX)
2614-6983/ © 20XX P3M Politeknik Negeri Bengkalis. All rights reserved.
<Author 1 Full Name>, <Author 2 Full Name> Inovbiz: Jurnal Inovasi Bisnis X (20XX) XX-XX
If symbols are defined in a nomenclature TIFF (or JPEG): Bitmapped (pure black &
section, symbols and units should be listed in white pixels) line drawings, keep to a minimum of
alphabetical order with their definition and 1000 dpi.
dimensions in SI units. TIFF (or JPEG): Combinations bitmapped
Please use the SI set of units as much as line/half-tone (color or grayscale), keep to a
possible. Wherever the application domain uses minimum of 500 dpi.
a different set of units widely, please minimize the
use of non-standard units or non-standard
symbols for those units. As examples, the use of
“a” for year (annum) is depreciated and the use of
“y” is encouraged instead. Similarly, “h” should be
used for hours instead of “hr” and “t” instead of
“ton” or “tonne”. It is important to take care of the
case in which the measurement units are typed.
E.g. “Km” does not mean “kilometers”, but
“Kelvin-meters”. When providing numerical
values followed by measurement units, please Gambar 1. Grafik Rasio Pendapatan Daerah Terhadap
leave a regular space or non-breaking space Belanja Daerah Berdasarkan Kabupaten Tahun 2016
between each value and the measurement unit. (Sumber: BPKAD Provinsi Riau)
This also includes percentages and degrees 6.2. Tables
Celsius (e.g. 42 % or 35 %, 234 °C, 504 K). This
rule also applies to the unit for litre, which is Set table number and title flush left above
recommended to be capital “L”. table. Horizontal lines should be placed above
The authors are encouraged to render the and below table headings and at the bottom of
numbers according to the International rules, the table. Vertical lines should be avoided. Title
specifying the dot as a decimal separator and the should use Arial 8, with 10 pt before and 4 pt
comma as a thousands separator. after the paragraph, left justified at the top of the
table. Tables have to be included into the text. If
5. Equations a table is too long to fit one page, the table
number and heading should be repeated on the
Make sure that placing and numbering of
next page before the table is continued.
equations is consistent throughout your
Alternatively the table may be spread over two
manuscript.
consecutive pages (first an even numbered, then
an odd-numbered page) turned by 90, without
(1)
repeating the heading. Table titleshould be
placed above the table and adjust text to table
width.
Tabel 1. Kemudahan dalam mendapatkan layanan
purna jual
No Kategori Jumlah Persentase
1. Sangat Puas 35 35%
Left align the equation and put the number of
2. Puas 40 40%
the equation flush-right, using a Right Tab on the
3. Netral 22 22%
right margin. Please reference equations in the 4. Tidak Puas 3 3%
text by writing: Persamaan (1). In principle, 5. Sangat Tidak Puas 0 0%
variables are to be presented in italics. Jumlah 100 100%
6. Figures and Tables Sumber: Data Olahan 2019
6.1. General
7. Concerning References
Positioning Figures and Tables: Place figures
and tables at the top or bottom of columns. Avoid References must be listed at the end of the
placing them in the middle of columns. Large paper. Do not begin them on a new page unless
figures and tables may span across both this is absolutely necessary. Authors should
columns. Figure captions should be below the ensure that every reference in the text appears in
figures; table heads should appear above the the list of references and vice versa. Indicate
tables. Insert figures and tables after they are references by (Lubis & Wenang, 2017), (Lubis et
cited in the text. Use “Gambar 1”and “Tabel 1” in al., 2017) or (Irawan, 2016). References must be
bold fonts, even at the beginning of a sentence. with APA Style in Scholar.
EPS (or PDF): Vector drawings, embed all used
fonts. Recommendations for references are:
TIFF (or JPEG): Color or grayscale
photographs (halftones), keep to a minimum of Book
300 dpi. Iacobucci, D. (2018). Marketing management.
Boston, MA: Cengage Learning.
2
<Author 1 Full Name>, <Author 2 Full Name> Inovbiz: Jurnal Inovasi Bisnis X (20XX) XX-X