930E-5SE

Electric drive truck

Safety

Reliability

Productivity

Gross horsepower Nominal GVW

2 611 kW (3,500 HP) 521 631 kg (1,150,000 lbs.)
 930E-5SE

Engine Frame
Make and model Komatsu SSDA18V170 Advanced technology, full butt-welded box sectional ladder-type frame
with integral ROPS supports, integral front bumper, rear tubular cross
Fuel Diesel
members, steel castings at all critical stress transition zones, rugged
Number of cylinders 18 continuous horsecollar.
Operating cycle 4 cycle Plate material 482.6 MPa (70,000 psi) tensile strength steel

Gross horsepower* 2 611 kW (3,500 HP) @ 1,800 rpm Casting material 620.5 MPa (90,000 psi) tensile strength steel

Net flywheel power** 2460 kW (3,346 HP) @ 1,800 rpm Rail width 305 mm (12”)

Weight (wet) 11747 kg (25,897 lbs.) Rail depth (minimum) 864 mm (34”)

Weight (dry) 11247 kg (24,798 lbs.) Top and bottom

45 mm (1.77”)
plate thickness
*Optional Tier 4 emissions compliant engine for North American market.
Non-emissionized engine for markets outside of North America. Side plate thickness 25 mm (0.98”) rear / 32mm (1.26”) front
*Gross horsepower is the output of the engine as installed in this machine, at
governed rpm and with engine manufacturer’s approved fuel setting. Accessory Drive axle mounting Pin and spherical bushing
losses included are water pump, fuel pump and oil pump. Drive axle alignment Swing link between frame and axle
**Net flywheel power is the rated power at the engine flywheel minus the average
accessory losses. Accessories include fan and charging alternator. Rating(s)
represent net engine performance in accordance with SAE J1349 conditions. Body
All-welded steel flat floor body with horizontal bolsters and full canopy.
Electric drive
Rubber mounts on frame, eyebrow and body up sling are standard. Extended
AC/DC current canopy and pivot exhaust heating are optional.
Alternator GTA-62 16 mm (0.63”) outer/19 mm (0.75”) center
Floor sheet
1 379 MPa (200,000 psi) tensile strength steel
Single impeller in-line blower 127.4 m3/min (4,500 cfm)
10 mm (0.39”) outer/12 mm (0.47”) center
Control AC torque control system Front sheet
1 379 MPa (200,000 psi) tensile strength steel
Motorized wheels* GDY106-C 8 mm (0.39”) 1379 MPa
Side sheet
Ratio 32.62:1 1 379 MPa (200,000 psi) tensile strength steel
Speed (maximum) 64.5 km/h (40 mph) 6 mm (0.24”) 690 MPa
Canopy sheet
690 MPa (100,000 psi) tensile strength steel
* Drive system performance depends upon gross vehicle weight, haul road grade, haul
road length, rolling resistance and other parameters. Komatsu must analyze each job SAE heaped 2:1 202 m3 (264 yd3)
condition to assure proper application.
Standard Komatsu
36 228 kg (79,869 lbs.)
body weight
Tires and rims
Rock service, tubeless, radial tires
Braking system
Standard tire* 53/80 R63
Oil-cooled, hydraulic actuated, multiple disc
Flange mount, five-piece rim Service brakes
brakes at each wheel
914 mm x 1600 mm x 127 mm (36” x 63” x 5”) rim assembly
Rims rated at 758 kPa (110 psi) cold inflation pressure Traction system Wheel spin-slide control
Typical tire weight 26 127 kg (57,000 lbs.) Max. service apply pressure 17 236 kPa (2,500 psi)
* Tires should meet application requirements for tkph/tmph, tread, compound, Total friction area per brake 97 025 cm2 (15,038 in2)
inflation pressure, ply rating or equivalent, etc.
* Tires sold separately. Automatically applied prior to hydraulic
Auto apply system system pressure dropping below level
Cab required secondary stopping requirements
Advanced operator environment with integral 4-post ROPS/FOPS level 2 Secondary brake system Complies with ISO-3450 standards
structure (ISO 3449), adjustable air suspension seat with lumbar support Wheel brake lock Switch-activated
and arm rests, full-size passenger seat, maximum R-value insulation, tilt and
telescoping steering column, electric windshield wipers with washer, tinted Multiple disc, spring-applied, hydraulically
safety glass, power windows, payload meter IV, 55,000 Btu/hr heater and released, dry brakes on inboard end of
defroster, 21,600 Btu/hr air conditioning (HFC–134A refrigerant). Parking brakes each wheel motor rotor shaft. Rated to
hold on ±15% grade at maximum gross
vehicle weight
Suspension Electric dynamic retarder 4 026 kW (5,400 HP)
Variable rate hydropneumatic with integral rebound control
Maximum front stroke 328 mm (12.92”)
Cooling system
Maximum rear stroke 239 mm (9.40”)
L&M radiator assembly, split-flow, with deaerator-type top tank.
Maximum rear axle oscillation ±6.5° Radiator frontal area 7.02 m2 (75.5 ft.2)

2
 General specifications
Overall width= 9.15

Dual
spacing=
Dumping 1.63
height=
13.98 Dimensions are in meters

Rear track= 5.37

13.41 Rear tire width= 8.3

Loading height=6.65

Tail
7.45 clearance=
4.35 1.75

4.48 6.35 4.4 Front track= 6.15

Front tire width= 7.52
9.60
Hydraulic system
Accumulator assisted with twin double Capacity Loading
acting cylinders provide constant rate Body
Steering Struck 2:1 Heap height*
steering; secondary steering automatically
supplied by accumulator Standard 151 m3 (197 yd3) 202 m3 (264 yd3) 6.65 m (21'10")
Turning circle diameter (SAE) 32 m (105’) *Exact load height may vary due to tire make, type, and inflation pressure.
Reservoir 947 L (250 US gal)
Filtration In-line replaceable elements
Electrical system
Suction Single, full flow, 100 mesh 4 x 8D 1450 CCA, 12 volt, in series/parallel, 220 ampere-hour,
Hoist and steering Dual, in-line, high pressure bumper-mounted with disconnect switch and lock-out.
Above deck, easily accessible Alternator 24 V, 275 A
Brake component cabinet with diagnostic test connections
Lighting 24 V
Two 3-stage dual-acting outboard
Hoist cylinders, internal cushion valve, Cranking motors 2 x 24 V
over-center dampening
Hoist times Service refill capacities
Power-up loaded 21 s
Power-down (high idle) 12 s Cooling system 568 L (150 gal)
Float-down empty (low idle) 18 s
Crankcase 363 L (95.8 gal)
Pumps Two pumps, single package, in-line
Hydraulic system 1 325 L (350 gal)
Tandem gear pump with output of
Hoist and brake cooling Motor gear box (each) 57 L (15 gal)
908 lpm (240 gpm) at 1,800 rpm
Variable displacement piston pump with Fuel tank (non-emissionized) 5 299 L (1,400 gal)
Steering and brake output of 242 lpm (64 gpm) at 1,800 rpm Fuel tank (tier IV) 4 542 L (1,200 gal)
System relief pressures DEF tank 288 L (84 gal)
Hoist and brake cooling 17 237 kPa (2,750 psi)
Steering and brake 27 579 kPa (4,000 psi)
Ports available for powering disabled truck and for system diagnostics

3
Standard equipment Standard high visibility deluxe cab
• Air cleaners, Donaldson SSG with auto evacuators • AC drive interface display
• Alternator (charging 24 V x 275 A) • Air conditioner HFC-134A
• Automatic lubrication system with ground-level fill, level indicator and dynamic timing • AM/FM radio with CD, USB and MP3
• Backup alarm • Dome light
• Batteries — 4 x 8D (1,450 CCAs) • Electronic dash panel
• Battery charging/jump start connector - Body up
• Body over — center device - Engine oil temperature (high)
• Body-up sling (with KAC-supplied body) - Parking brake
• Brakes: oil-cooled, multiple disc (front and rear) - Propulsion system not ready
• Electric start - No DC link voltage
• Eliminator, Cense - No propel
• Fast-fill fuel system (in tank and left side remote) - Service brake applied
• Filters, high pressure hydraulic - Wheel brake lock applied
• Ground-level radiator fill - Maintenance monitor
• Mirrors: • Engine hour meter, oil pressure gauge, coolant temperature gauge, hydraulic oil
- LH: Flat with convex aux mirror temperature gauge
- RH: Heated, multi-cambered convex • Engine shutdown with Smart timer delay
• Mud flaps • Floor mat (double barrier)
• Muffled exhaust — deck-mounted • Fuel gauge in cab
• Power supply, 24 V and 12 VDC • Fuel low level light and buzzer
• Quick disconnects (steering, hoist and diagnostics) • Gauges (with backlight)
• Retard speed control with set indicator • Headlight switch
• Radiator sight gauge • Heater and defroster (heavy-duty)
• Removable power module unit (radiator, engine, alternator) • Heater switch
• Reverse retarding • High beam selector and indicator
• Service center — LH • Horn switch (center of steering wheel)
• Electronically controlled viscous fan clutch • Indicator lights (blue)
- Engine service
- Komtrax Plus Snapshot (IM)
Operator environment and control • Komatsu Payload Meter IV (PLM IV)
• All hydraulic service brakes with auto apply • Komtrax Plus
• Battery disconnect switch • Operator seat, adjustable with air suspension, lumbar support and arm rests
• Brake lock and drive system interlock • Panel lighting (adjustable)
• Circuit breakers, 24 V • Passenger seat, mechanical suspension
• Diagonal staircase across grille • Power windows
• Dynamic retarding with continuous-rated element grids • Pressurized cab air system with fan on
• Engine shutdown at ground level • Single brake/retarder pedal
• Hoist propulsion interlock • Sunvisor (adjustable)
• Horns (electric–front) • Tilt and telescoping steering column
• Integral ROPS/FOPS cab level 2 • Voltmeter (battery output)
• Maintenance and power lockout • Windshield (tinted safety glass)
• Parking brakes with warning light and speed application protection • Windshield wiper (dual) and washer (electric)
• Power steering with auto secondary steering
• Protective deck handrails
• Pump driveline protector Optional equipment
• Radiator fan guard Note: Optional equipment may change operating weight.
• Seat belts
- Operator 3-point 51 mm (2”) retractable • Amber beacon light
- Passenger lap 51 mm (2”) retractable • Application-specific body structure
• Slip-resistant walkways • Body liners
• Body-up sling
• Bumper access — hydraulic retractable steps
Lighting • Bumper-mounted headlights
• Double wall exhaust tubes
• Backup lights — rear-mount (2) LED • Engine access platform, LH
• Backup lights — R and L — deck mount (2) halogen • Extended canopy
• Brake and retard lights on top of cab • Eyebrow
• Clearance lights (LED) • Fire extinguisher 9 kg (20 lbs.)
• Dynamic retarding, rear (2) (LED) • Heated body
• Engine compartment service lights • Hot start engine oil (220 V, 2-500 W)
• Fog lights (2) halogen • Hot start hydraulic oil
• Headlights (8) halogen • Hot start engine coolant (220 V, 2-500 W)
• Manual backup light, switch and indicator • Hubodometer
• Payload lights R and L (LED) • Komatsu Smart type rims
• Stairway lights • KomVision all-around monitoring system
• Stop and tail lights (2) (LED) • LED headlights
• Turn signals (LED) • Mufflers between frame rails (standard tier IV)
• PLM IV scoreboards
• Premium operator seat
• Reversed access ladder
• Rock ejectors
• Service center, RH
• Shutters (radiator)
• Spare rim
• Spare Smart rim
• Special language decals
• Suspensions (cold weather)

Product designs, specifications and/or data in this document are provided for
informational purposes only and are not warranties of any kind. Product designs
and/or specifications may be changed at any time without notice. The only
warranties that apply to sales of products and services are Komatsu’s standard
written warranties, which will be furnished upon request.
komatsu.com
Komatsu and other trademarks and service marks used herein are the property
of Komatsu Ltd., Komatsu America Corp., Komatsu Mining Corp., or one of their
affiliates, or the respective owners or licensees.

© 2022 Komatsu Ltd. or one of its subsidiaries. All rights reserved. EN-930E-5SESPEC01-0922-V1