Scribd
Upload
45 views1 page

Assignment 5

1) The document is an assignment for a mechanical engineering department that includes questions about journal bearings, self-aligning ball bearings, spherical roller bearings, hydrostatic lubrication, thin film bearings, and desirable lubricant properties. 2) It asks the student to explain bearing characteristic number, bearing modulus, and classifications of antifriction bearings. 3) One question involves calculating the artificial cooling required for a journal bearing design based on load, speed, dimensions, oil properties, and operating temperatures.

Uploaded by

sainath
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
45 views1 page

Assignment 5

1) The document is an assignment for a mechanical engineering department that includes questions about journal bearings, self-aligning ball bearings, spherical roller bearings, hydrostatic lubrication, thin film bearings, and desirable lubricant properties. 2) It asks the student to explain bearing characteristic number, bearing modulus, and classifications of antifriction bearings. 3) One question involves calculating the artificial cooling required for a journal bearing design based on load, speed, dimensions, oil properties, and operating temperatures.

Uploaded by

sainath
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

DEPARTMENT OF MECHANICAL ENGINEERING

Unit-5
Assignment
Part-A 5×1=5
Sl.no Question C BL
O
1 Analyze Bearing characteristic number for journal bearings. 1 Understand
(2)
2 Where do you use self- aligning ball bearings and spherical roller 1 Analyze
bearings (4)
3 What is a hydrostatic lubrication? 1 Understand
(2)
4 Write any two examples of thin film bearings. 1 Understand
(2)
5 Select any four desirable properties of good lubricant. 1 Evaluate
(6)
Part-B 3×5=15
1 Explain the following terms as applied to journal bearings :(a) 1 Apply
Bearing characteristic number ; and (b) Bearing modulus. (3)
2 A tentative design of a journal bearing results in a diameter of 75 mm 1 Analysis
and a length of 125 mm for supporting a load of 20 kN. The shaft (4)
runs at 1000 r.p.m. The bearing surface temperature is not to exceed
75°C in a room temperature of 35°C. The oil used has an absolute
viscosity of 0.01 kg/m-s at the operating temperature. Determine the
amount of artificial cooling required in watts. Assume d/c = 1000.
3 Write short note on classifications and different types of antifriction 1 Apply
bearings. (3)

You might also like