0% found this document useful (0 votes)
28 views5 pages

Ex 3

1) The student conducted an experiment to measure the resistance, inductance, and frequency of oscillation in an RLC circuit. They found that adding an iron core to the coil significantly increased its inductance due to the core's higher permeability. 2) They measured the frequency of oscillation in the RLC circuit and found it to be 555.6 Hz based on their graph, and 530.5 Hz based on theoretical calculations, with a difference of 25.1 Hz. 3) The total energy in the RLC circuit is the sum of the energy stored in the capacitor and inductor. They observed that the energy decayed over time as it was lost through resistive
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
28 views5 pages

Ex 3

1) The student conducted an experiment to measure the resistance, inductance, and frequency of oscillation in an RLC circuit. They found that adding an iron core to the coil significantly increased its inductance due to the core's higher permeability. 2) They measured the frequency of oscillation in the RLC circuit and found it to be 555.6 Hz based on their graph, and 530.5 Hz based on theoretical calculations, with a difference of 25.1 Hz. 3) The total energy in the RLC circuit is the sum of the energy stored in the capacitor and inductor. They observed that the energy decayed over time as it was lost through resistive
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 5

Experimental Report 3

INDUCTOR AND FREE OSCILLATION IN RLC CIRCUIT


Class: 723662 Verification of the instructors

Group: 4

Name: Lê Minh Hoàng

Student ID: 20213667

I. Experiment Motivations

- Understanding the current across an inductor-resistor and RLC circuit.


- Calculating the energy of the oscillation RLC circuit.

II. Experimental result


Part 1: Resistance and Inductance of the coil

a. Without core
Us = 1.00 (V)
I0 = 0.09 (A)
Slope S = 1289.95239

The resistance of the coil:


U S 1.00
R L= = =11,11( Ω)
I O 0.09

Coil inductance :
US 1.00 −3
LW /O = = =9 ×10 (H )
I O × S 0.09 ×1289.85239

b. With core

Us = 1.00 (V)
I0 = 0.09 (A)
Slope S = 277.25686
The resistance of the coil :
U S 1.00
R L= = =11.11(Ω)
I O 0.09

Coil inductance :
US 1.00
LW /O = = =4 ×10−2(H )
I O × S 0. 09 ×277.25686

Explain: After putting the core inside the coil, the coil’s inductance is significantly increase.
This phenomenon occurred because the core has higher permeability than the air, so
magnetic field can be transferred through the core easier, thus the coil inductance
increase.

Part 2: Free oscillation of the RLC circuit

a. Frequency
The current in RLC circuit:

T = 1.8 ×10−3 (s)


Lw/o = 9 ×10−3 (H)

C = 10 x 10-6 (F)

The frequency based on the graph:

1 1
f measured = = =555.6 ( Hz)
T 1.8 × 10−3

The frequency based on theoretical calculation:

1 1
f prediction= = =530.5( Hz)
2 π √ LC 2 π √ 9 ×10 ×10 ×10
−3 −6

Comparison:

Δ f =f measured −f prediction=555. 6−530.5=25.1(Hz)

b. Energy
The total energy in RLC circuit:

1 2 1 2
U =U c + U L = C V + L I
2 2

Comment:

- After stopping the electric power, the energy of the circuit does not decrease
rapidly to zero, it reduces to zero over a short period of time.

- The energy of oscillations of the coil and the capacitor are damped oscillations.

Explain:

The energy of the circuit loses by the heat of the resistor at rate i 2 R

The graph of total energy is steepest at the time that the magnetic energy reaches a
local maximum because in these times, the current through the coil is highest, and
the loss of energy is mainly due to the resistance of the coil ( ΔQ=i 2 R ).

You might also like